Question about 2008 Jeep Wrangler

Open Question

Where is IOD fuse jeep wrangler - 2008 Jeep Wrangler

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: Jeep wrangler Fuse box

i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck

Posted on Jun 30, 2008

  • 60 Answers

SOURCE: 95 jeep wrangler 4x4 6cyl. no spak from coil and

you have a short in the ign. circut

Posted on May 11, 2009

  • 6982 Answers

SOURCE: What does the auto shut off fuse do? 92 Jeep Wrangler.

The auto shutdown relay in your vehicle is controlled by the computer. If the computer does not see a signal from the crank or cam sensor, it will turn off power to the relay which in turn shuts off power to the fuel and ignition system. Unlike those in many passenger vehicles, it's not connected to an impact sensor. (as jeeps are off road vehicles as well as being transportation, if they had an impact sensor, they would be prone to shutdown when traveling over rough off road terrain)
The fuses to the relay are affected by shorting or overload of any components they serve, or by a problem with the relay itself.

Posted on Nov 01, 2009

  • 4088 Answers

SOURCE: 2000 jeep wrangler fuse keeps blowing?? What do I

That or the wiring to it is shorted at some point. Remove the connection at the center back of the socket and replace the fuse--if ok, replace or repair the socket. If still blows fuse, check the wire you removed for damage near any metal object.

Posted on Nov 11, 2009

  • 372 Answers

SOURCE: I have a 1997 Wrangler Sahara 4.0L I have a IOD

is it .54 or 54. It should be less than .1 total draw with key off

Posted on Apr 24, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

1999. Why does the 15 amp IOD fuse keep blowing?

have an auto electrician check it over for a short or overload,could be any of a number of things . the systems that become active with the turning of the key may be the source of the problem. could be a short in the wiringgbehind the instrument binacle

Jul 09, 2015 | Jeep Cars & Trucks

1 Answer

Where is the i o d fuse located

why do you ask this> must we guess the context?
you found the IOD word, congrats !
this is Ignition off Draw. (100% hot full time power feeds)
these are the fuses that the Jeep factory pulls just before shipping
car so the battery dont drain, New jeeps.

they operate all computers on board, PCM/BCM, radio, NAV, etc, to the max on newer cars,
these are mostly memory fuses so the brain on the end DONT FORGET its programming, Errors and configurations and learn modes.
2000 Compass,. what engine, what IOD do you want?

so if confused, why not read the FSM
the FSM covers all that. the factory service manual.
or at a real jeep page. here RTM

i will now give one example from the book on IOD.
just 1.

the operators guide in the glove box has this ,as does the TIPM its self marked.
6 of em in read , below;.


context: what is the job.?
battery drains parked
need to reset learn modes?
resetting DTC with no scan too>?

Oct 04, 2014 | 2008 Jeep Compass

1 Answer

What is an IOD fuse

IOD stands for, ignition off draw. If your going to store your vehicle or not use it for long periods of time then pull this fuse. It helps you keep from having a dead battery. It removes power from unnecessary accessories .

Jun 14, 2014 | 2005 Jeep Liberty

1 Answer

The lights under the dash (by your feet) stay on (2001 Jeep Wrangler). What fuse is that or what to do?

join a wrangler forum find it by googleing wrangler forums or try 2001 jeep wrangler fuse layout

Feb 06, 2013 | 2001 Jeep Wrangler

1 Answer

I have a 1997 Wrangler Sahara 4.0L I have a IOD fuse draw of 54ma. Is that accetable?

is it .54 or 54. It should be less than .1 total draw with key off

Apr 24, 2011 | 1997 Jeep Wrangler

1 Answer

Battery drain I put test light between neg

Hope this info helps

Jan 13, 2010 | Jeep TJ Cars & Trucks

1 Answer

2007 Rubicon radio will not come on

Check the IOD fuse in the engine back it is a double 10 amp fuse with a pull up tab. If that is good you need a radio should still be under warenty.

Jul 13, 2009 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

2008 jeep, electrical problem - won't start

try removing the IOD fuse in the fuse block for a minute then reinstall it. will reset the computer

Jan 16, 2009 | 2008 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides