Question about 2002 Acura MDX

Open Question

How to jump start the compressor - 2002 Acura MDX

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you jump the ac compressor over on a 02 Toyota Avalon, to be able to charge the system?


If you have to jump it, then there is another problem. You would be wasting money. If you put the can on the A/C port and it doesn't take the fluid and kick start the compressor. you have problems. Could be high pressure sensor or the compressor.

Mar 20, 2015 | Toyota Cars & Trucks

1 Answer

Help 2008 ford fusion heater and ac stopped working


1) TEST the fuse+ relar of a/c
see the next steps and fix it. God bless you
If so, the compressor is working and the A/C system probably contains enough refrigerant to make cold air, so the problem is inside the HVAC unit. Replace the motor that controls the blend air door (this is a difficult job and best left to a professional since it involves tearing apart the HVAC unit -- about an 8 to 10 hour job!).
If the compressor does not engage when you turn on the A/C, see if it will run by jumping the compressor clutch wire directly to the battery (use a fused jumper wire). If the compressor works when you jump it, and the A/C blows cold air, the system contains refrigerant and the fault is likely a bad A/C compressor clutch relay or a bad clutch cycling switch or pressure switch.
If the compressor does not engage when you jump it, the problem is a bad compressor clutch.
If the clutch engages but the compressor does not turn (the belt will start to slip and squeal), the compressor is locked up and you need a new compressor.
If the compressor clutch engages and turns the compressor, but the A/C still does not blow cold air, the system is probably low on refrigerant and needs to be recharged

10_5_2012_12_00_24_pm.jpg

Oct 05, 2012 | 2008 Ford Fusion

1 Answer

Ac vent blower


proceed according and fix it. God bless you
If so, the compressor is working and the A/C system probably contains enough refrigerant to make cold air, so the problem is inside the HVAC unit. Replace the motor that controls the blend air door (this is a difficult job and best left to a professional since it involves tearing apart the HVAC unit -- about an 8 to 10 hour job!).
If the compressor does not engage when you turn on the A/C, see if it will run by jumping the compressor clutch wire directly to the battery (use a fused jumper wire). If the compressor works when you jump it, and the A/C blows cold air, the system contains refrigerant and the fault is likely a bad A/C compressor clutch relay or a bad clutch cycling switch or pressure switch.
If the compressor does not engage when you jump it, the problem is a bad compressor clutch.
If the clutch engages but the compressor does not turn (the belt will start to slip and squeal), the compressor is locked up and you need a new compressor.
If the compressor clutch engages and turns the compressor, but the A/C still does not blow cold air, the system is probably low on refrigerant and needs to be recharged

10_5_2012_12_14_20_pm.jpg

Oct 05, 2012 | 2001 Oldsmobile Aurora

1 Answer

My air conditioner is blowing warm air on the driver side and cold on the passenger side


see this steps and think with clearly and logically NOT feared. God bless you
checkmark.gif Start with the compressor. Does it engage when you turn on the A/C?
If so, the compressor is working and the A/C system probably contains enough refrigerant to make cold air, so the problem is inside the HVAC unit. Replace the motor that controls the blend air door (this is a difficult job and best left to a professional since it involves tearing apart the HVAC unit -- about an 8 to 10 hour job!).
If the compressor does not engage when you turn on the A/C, see if it will run by jumping the compressor clutch wire directly to the battery (use a fused jumper wire). If the compressor works when you jump it, and the A/C blows cold air, the system contains refrigerant and the fault is likely a bad A/C compressor clutch relay or a bad clutch cycling switch or pressure switch.
If the compressor does not engage when you jump it, the problem is a bad compressor clutch.
If the clutch engages but the compressor does not turn (the belt will start to slip and squeal), the compressor is locked up and you need a new compressor.
If the compressor clutch engages and turns the compressor, but the A/C still does not blow cold air, the system is probably low on refrigerant and needs to be recharged.

7_25_2012_8_45_21_am.jpg

Jul 24, 2012 | 2007 GMC Sierra Classic

1 Answer

A/C compressor on 95 astro van does not engage at all.


There are a few reasons for the compressor not engaging. Lets start with the most common. low ac gas.A bad clutch on the compressor.Blown fuse.
Let is start with testing for low gas. (134a freon).Locate the dryer. this is on the passenger side of engine compartment. it looks like a tall cylinder, on the top side you will see a switch. unplug switch connector and jump the two terminals in connector with a piece of wire, this is the low pressure or cycling switch. you will be completing the circuit by jumping a wire across the terminals.If the compressor turns on when connectors are jumped then you are low on gas and the system needs recharging.
If the compressor does not urn on then check all fuses, if fuses are good then the next step is to go to compressor and test for power and ground. If you have power and a good ground on the connector to compressor then compressor clutch is bad.A bad clutch will some times blown fuses, so if you replace the fuse because it was blown and it blows again then clutch is bad.
Another test that will help is when you remove the connector from the cycling low pressure switch , test the connector. one wire on the connector should have power when ac is turned on,
Hope this helps let me know what the outcome is. Good day.
I have enclosed a picture of the switch and dryer to help you locate it.If you jump the terminals

Mar 23, 2012 | 1995 Chevrolet Astro

2 Answers

1996 lincoln towncar. No a/c compressor engagement unless jumped


the control unit is no good.i had a similar situation with a 98 tracker,and installed a switch to give it a ground for the compressor relay that comes from the a/c computer module.
it works good and goes on and off with the a/c switch.

Jul 18, 2009 | Lincoln Town Car Cars & Trucks

1 Answer

No voltage to AC compressor after jump start 93 G20 van


the main fuse box under the hood is where those relays can be found.

Jul 06, 2009 | 1993 Chevrolet G20

1 Answer

1986 cadillac fleetwood is making me loca(crazy)


It all depends on the AC compressor , is it the freely bearing that has jammed or is the compressor itself totally jammed!
You will have to remove the fanbelt onthe compressor and lossen the pulley better if you can remove it, it should come out togther with the bearing .
This will show if its the bearing tht has siezed or the compressor itself.
Hope this helps!

May 10, 2009 | 1986 Cadillac Fleetwood

2 Answers

A/c trouble


Hello, it sounds as if you have a problem with your tensioner jumping violently. When the defrost is on it uses the ac compressor that is why the belt jumps then to, but it sounds like you are going to be needing a compressor soon. It has a piston that is hanging up at a certain point and thats why it is jumping. It will break a brand new belt when it locks up,when that happens. Please rate my answer, thank you.

Feb 22, 2009 | 2002 Chevrolet Tahoe

Not finding what you are looking for?
2002 Acura MDX Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...