Question about 2001 Daewoo Tacuma 1.8

Open Question

I can not get the new cile pack to spark all wires are on the right way

The cile pack isbran new and it will not spark

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Isuzu 2ltr bakkie nmbr 2 and 3 no spark?


post 3, adds, no spark , 2/3 (and still no year, no country stated)
bad coil pack?
wired wrong, this pack.
no photo of the engine, nor real name of it, Petrol.
btw, we dont have "BAKKIE" here. not a single one.
nor KB trucks, either.
what spark system this car has, im clueless.
4 coils or 1 pack.? if one pack , replace all spark wires
if one pack system , if either 2/3 wire opens, both cylinders go dead. try new spark wires. high voltage,

or you measured spark wrong, on 1 pack car.
it takes 2 spark plugs do do that. 2 good plugs and 2 good wires,
#2 and #3, due to the fact they are wired, in SERIES.
see its called wasted spark system, with 1 coil pack and no distributor..
the testing is unique. on this, setup.
try new spark plugs, gapped correctly
and 4 new HV wires,
I bet its go. if not the coil pack is toasted.

Dec 05, 2016 | Isuzu Cars & Trucks

2 Answers

I have a 1997 Isuzu Rodeo 2.6L cylinders 2 & 3 won't fire after vehicle starts but will fire if I unhook cylinder 1 or 4 what will cause this


USA car? must I GUESS?
so you have 2 coil packs. ????
called wasted park
seems you typed the displacement wrong, !!! 2.2L is 4 banger...
1 and 4 fire as a pair
2 and 3 , fire as a pair , in series

so if the spark wires open , you loose a pair,
say #1 opens, you loose #4 with it.
they are wired in series.
if one spark wire grounds out , you lose only THAT spark plug.
but why would you get the odd pack to pack cross talk.
(assumes you have the HV wired right. correct?)
the packs cant be wired up willly-nillly.
this is the 2.2L coil pack.
and IS wasted SPARK system. for sure.
and can not be mixed up
the PCM is hard coded for 1,3,4,2 firing order.
and must be wired right. did you meddle here?
if you unplug the 2 one right , this must not make the 2 on left work.
pulling 1 wire, only kills the adjacent wire. normal.
see the pairs there, at the bottom see those hiddencoil packs mail coils molded to case?
if you are wired right and you have cross talk from 1/4 to 2/3 bank
the pack is bad.

25857019-xm4r4cd100gbehm3txueal2s-4-0.jpg by cross talk i mean, 1;3 effect 1/4 or the reverse.

Sep 09, 2015 | 1997 Isuzu Rodeo

1 Answer

What is the Wire Order with distributor?


theres no distributor and the firing order for your 3.8 is 1-6-5-4-3-2-the following link shows the coil pack
Buick General Motor 3800 V6 Engine Firing Order DIS IDI ignition timing 3.8 Buick Engine Coil Pack Firing Order Spark Plug Wire Location Which way do the spark plug wires go on & what cylinder is what?
.
For the Buick V6 231 3.8 liter turbocharged engine:
.
Answers!
.
Firing order:
1 - 6 - 5 - 4 - 3 - 2.
.
Spark plug wire location on coil pack:
.
Closest to the back of the car, left to right: 1 - 5 - 3.
Closest to the front of the car, left to right: 4 - 2 - 6.
.
Spark plug wire location on engine:
.
drivers side, front to back of car: 1 - 3 - 5.
passenger side, front to back of car: 2 - 4 - 6.
.----and this link shows the coil pack to cylinders
.
3 8 Buick Turbo Engine Coil Pack Firing Order Spark Plug Wire Location

Aug 15, 2015 | 1987 Buick Regal

1 Answer

What could I do to stop my lt1 from missfiring


Lets see coil pack, spark plug wire, spark plug, and if it is MFI maybe injector, or check injector pulse. If all those are ok, then check the compression in that cylinder, if it is low it will not fire right. Go through normal check out procedures to check each of these pull out the spark plugs, put them back on the end of the wire and check for spark. If these are ok the go on go the injector. If they are not try temporarly swapping spark plug wires with a different coil pack, if the problem follows the wire, then put on new wires. If it does not follow the wire, then the coil pack could be bad, or the signal going to it. If the spark is ok check to see if you have injector pulse signal going to injector. If it is ok replace injector. Hope this helps you.

Apr 24, 2012 | 1996 Chevrolet Caprice Classic

2 Answers

How do you change spark plugs in a 2004 hyundia sonata


It depends on which engine is in the vehicle. The 2004 Sonata came with two possible powertrains -- the 2.4 Lit L4, and the 2.7 Lit V6.

On the 4 cylinder engine, there are two coil packs and two ignition wires, Below each coil pack is a spark plug (#2 and #4 cylinders). The wire from # 2 coil pack goes to #3 spark plug, and the wire from #4 coil pack goes to #1 spark plug.

Photo:

ghost45_15.jpg
Now the 2.7 Lit V6 requires you remove the surge tank (intake manifold) in order to access the spark plugs & wires on Bank 1 (Right Hand side of the engine).

Photo:
ghost45_16.jpg

Jun 10, 2011 | Hyundai Sonata Cars & Trucks

1 Answer

My engine is stalling and it shakes too much i put new spark plugs and wires and it stills run rought. what can it be?


what about the coil pack? If you changed wires and plugs you should also change the coil pack which controls spark to all the plugs. Make sure you put the right wires on the right plugs.

Jun 09, 2010 | 1997 Ford Explorer AWD

3 Answers

Ignition module where do I find it.


The ignition coils are mounted on it. Just follow the spark plug wires.

Nov 18, 2009 | 2005 Chevrolet Impala

1 Answer

Missing in every gear..


you have to see if the coil pack fire up do you have spark coming out of the coil pack cylinder 2 never mind the other code the missing cylinder make the other sensor malfonction check if you have spark coming out of the coil pack if not change the coil pack if you have you spark check the compression let me know pierre please dont rate right away we work together to fix our problem because i whant you to get our car running good and i whant a fixya anything else is bad for me thanks pierre

Feb 25, 2009 | 2002 Mitsubishi Lancer

1 Answer

Unsure if spark plug wires are connected to the coils correctly


i presume what you replaced was the coil pack. if it's a six cyclinder which my windstar was... the numbering on the pack is one to three on one side. and 4-6-5 on the other. either ford had a better idea or they wanted to see if mechanic paid attention. you haven't mentioned the motor is running rough, but the spark sound suggests something is off. start from the coil pack and make sure each wire is where it should be. it's numbered right on the pack. the wires hopefully will have numbers stamped right on them.
follow each wire to see which cyclinder it goes to to make sure the order is correct.

Robert

Dec 16, 2008 | 1997 Ford Econoline

1 Answer

Spark plug change in a 1998 dodge intrepid


if you don t see any spark plug wires then your motor has coil packs(black colored boxwith 2 small electrical wires) located on top of motor 3 on one side,3 on the other.disconnect negative terminal on battery,then disconnect wire connector at each coil pack and remove 2 screws that hold down coil pack, pull gently straight up and plug is right there below coil pack

Jul 03, 2008 | 1998 Dodge Intrepid

Not finding what you are looking for?
2001 Daewoo Tacuma 1.8 Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...