Question about 2007 Ford F-650

Open Question

What does TCB fault on on a F 550. 2005 means?

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2010 Proton S16 emission light (solid) is on, not sure what this means?


it means that you have a problem with the emission control sensors and need to have it checked out
have the fault codes read to determine if it is EVAP system fault, HO2S sensor fault or O2 sensor fault
fix what is reported

Apr 03, 2016 | Proton Cars & Trucks

4 Answers

Parasitic draw from tcb fuse, leaves battery dead. I have found the source of the draw, how do I solve the problem? Battery is drained after 7 hours whether running or sittimg.


You say you've found the source of the draw, but you really haven't. "tcb fuse" isn't a specific source, only the identity of a group of things. You will need to identify what is on that fuse, and which one of those is causing the drain.
If your alternator is indeed putting out, no rational drain will cause your battery to go dead while you're driving. Think perhaps your alternator isn't "fine", but may have one or more bad diodes. I had three replacement alternators go bad within a week each time. Rebuilt alternators can go out quickly...

Apr 29, 2015 | Cars & Trucks

1 Answer

What does error codes 40 and 41 mean on my 1999 mitsubishi eclispe mean


11 Oxygen sensor fault.
12 Airflow sensor fault.
13 Intake air temp sensor fault.
14 Throttle position sensor (TPS) fault.
15 Idle speed control (ISC) motor position sensor fault.
21 Coolant temp sensor fault.
22 Crankshaft position (CKP) sesnor fault.
23 Camshaft position (CMP) sensor fault.
24 Vehicle speed sensor (VSS) fault.
25 Barometric (BARO) pressure sensor fault.
31 Knock sensor fault.
32 MAP sensor faulty.
36 Ignition timing adjustment signal fault.
39 Oxygen (O2) sensor fault.
41 Injector(s) fault
42 Fuel pump fault.
43 EGR fault.
44 Ignition coil (cylinders #1 & #4) fault.
52 Ignition coil (cylinders #2 & #5) fault.
53 Ignition coil (cylinders #3 & #6) fault.
55 Idle air control (IAC) valve position sensor fault.
59 Rear Oxygen (O2) sesnor fault.
61 Transaxle control module torque reduction signal fault.
62 Variable Induction control (VIC) valve position sensor fault.
71 Traction control (TC) vacuum valve solenoid fault.
72 Traction Control (TC) vent valve solenoid fault.

Sep 26, 2014 | 1999 Mitsubishi Eclipse

2 Answers

What is tcb on fuse box diagram Yukon 2003 Yukon


I think you mean TBC,,..
Trailer Brake Control ...

Jul 19, 2014 | Cars & Trucks

1 Answer

What does Tcb stand for on fuse box diagram2003 Yukon


TBC - Truck Body Control or commonly known as Body Control Module.

Jul 19, 2014 | Cars & Trucks

1 Answer

F250 Diesel Super Duty started jerking while driving. Changed both fuel filters and air filter. Had air filter off while truck was running and truck stopped running. Would not restart. Also getting...


It may have run out of fuel when the filter was replaced, you may need to use some starting fluid for diesel to getting going and when it starts just rev engine for a few minutes to bleed any air out, also the fault may be related you would have to scan it to see what the fault is , i would start with these things first. hope this helps, good luck.

Nov 08, 2010 | 2006 Ford F-250 Super Duty

1 Answer

2007 Volvo XC90 fault codes-ECM P030000, P030100, P030300, P0304000, what do they mean?


first code means random/multiple misfire cylinder (s) detected
second code means misfire detected number 1 cylinder, third code, miss=fire number 3 cylinder fourth code misfire number 4 cylinder
causes can be spark plugs, HT leads, ignition coils, injector, wiring fault, low compression/ engine mechanical fault

Jun 04, 2010 | 2007 Volvo XC90 V8 AWD Sport

2 Answers

Reverse and interior lights out, chevy express van


Fuse block under the hood. Driver's side, under the brake master cylinder. Number 18. TCB#2. Replace the fuse.

There is an under-engineered ground in the reverse circuit. If you back up with the dome lights on, it could blow that fuse. There should be some extra fuses under the cover of the fuse block.

Apr 25, 2010 | 2007 Chevrolet Express Passenger

1 Answer

I am having a constant draw killing my battery the draw stops when i pull both the tcb 10 amp fuse and the atc 20 amp fuse and the altranator charge wire i know the alt is bad what do the fuses run


ATC, auto traction control. this is to maintain stability during slippage. you may have a closed sensor circuit that is continuing to drain power when the ignition switch is in the off position. Tcb is a module fuse. I would preform the test below to isolate any other draws that may exist.


Here is the procedure I use to isolate a battery drain. Remove negative battery cable from the battery. Using a 12-volt test light, hook one end to the negative battery post the other end to the negative battery cable you just disconnected. The test light will glow or "light" if there is a drain. If the "light or glow" is faint, that is probably normal draw for the clock or computer. If the "light or glow" is bright, then there is a large drain. That should be corrected. Now start removing and replacing the fuses one by one until the light goes out; that one will be the circuit with the drain. Remember to hold in the button in the door jam for the interior lights.

Sep 23, 2009 | 1998 Oldsmobile Bravada

Not finding what you are looking for?
2007 Ford F-650 Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...