Question about Cars & Trucks

1 Answer

94 ford dually, dual fender lights went out only come on when manual trans is in reverse

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,679 Answers

Could be an earth problem ,from the light fitting trace the wires back through vehicle until you find the earth location ,bolted to body/chassis make sure all wires are intact and making a good contact with the body/chassis by undoing and cleaning contact parts keep me posted if you wish

Posted on May 11, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mick-40
  • 94 Answers

SOURCE: 94' jeep grand cherokee trans. delays in reverse

Hi ray_c_brown, This pause is determined by a time lag test, and you can check this yourself with a stop watch.Engagement time in "D" range should be a maximum of 1.2 seconds and the engagement time for reverse should be a maximum of 1.5 seconds. So with your vehicle warmed up and assuming curb idle speed is correct set the park brake,make sure ac is off (air cond) shift transfer case to 2H or if it is a NP249 transfer case leave in 4H,put your vehicle into neutral and set your stop watch shift to Drive and record time repeat this a couple of times and do the same with reverse,as you said the delay is with reverse so if it takes longer than 1.5 seconds here are a few things it could be:shift cable adjustment,low line pressure,worn direct clutch, first/reverse brake worn or a worn or damaged overdrive clutch.Hope this helps you good luck :)

Posted on Nov 12, 2008

nightwolf364
  • 48 Answers

SOURCE: 1991 ford ranger 2wd 2.9, 4 cyl, manual

check the shift lever and make sure it goes all the way into reverse. remember it is all the way on the right and all the way back.

Posted on Apr 17, 2009

  • 1 Answer

SOURCE: need to find the backup beeper or reverse light

You can purchase a reverse bulb that that has an audible signal only when the reverse lights come on. Check some parts stores. I have one in my 1995 F350, It works Great.

Posted on Apr 20, 2009

ftw1952
  • 10319 Answers

SOURCE: To replace the rear fender on my 2005 Dually, how

they bolt on through the bed which is a hard one to change for most

Posted on Feb 05, 2010

emissionwiz
  • 76846 Answers

SOURCE: will the ignition control module for a ford ranger

No it is designed just for 2.3, no other engines

Posted on Nov 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 03 GMC 3500 dually that the driver's side fender running lights won't light up. The passenger side work fine. Also my reverse light doesn't light up either. Could that be the problem?


check battery voltage both sides of stop light switch if if none check fuse , if one side only replace switch, if ok check voltage at light bulb holder if ok check bulb or earth system

May 02, 2017 | GMC Sierra 3500 Cars & Trucks

1 Answer

Reverse stopped working in 1998 ford explorer


reverse band in trans broke, will have to pull the trans and have it gone through,

Oct 15, 2014 | 1998 Ford Explorer

1 Answer

My f350 w/v10 has a serious loss of power from a standstill. The engine will bog down when in forward gear. In reverse, I can spin the duallys. In park or neutral the engine seems to have plenty of hp. ...


You can spin the duallys in reverse because reverse is a MUCH lower gear. NO, there is no kickdown cable for your transmission. Your transmission is controlled electronically.
If the engine is bogging down or if the transmission is trying to start up in the wrong gear, either the check engine light should be on or the O/D OFF light should be flashing. The best course of action in diagnosing a problem with a computer controlled engine and transmission is to scan the computers that control them to check for fault codes.

Sep 06, 2011 | 2004 Ford F350

1 Answer

How can you tell if your 2000 F350 dually has dual alternator,secondly i just replace the primary battery and secondary hold a charge,today the truck will not start the dome lights went out as i begin to...


Did you put a battery of equal or larger cranking amps, if you have dual alts it would be very noticable as you would see 2 alternators. You may also need to replace the other battery also, as this is not a primary and secondary batteries but equal batteries.

Jan 27, 2011 | 2000 Ford F350 Super Duty Super Cab

1 Answer

Lost only my parking lights, have trailer park lights, headlights, brake lights, top cab lights, dash lights, headlamp on chime. What the heck happened. Lights flickere blew a fuse put in a 25 amp fuse in...


Hello you have blown those bulbs out you will need to replace them some times this happens these are usually sold in packages of two.This is my solution to you.

Jan 02, 2011 | 2004 Ford F350

1 Answer

My 94 pontiac grand prix will only drive in first gear an will not shift up also will not shift to reverse


your reverse band went out in the trans you will have to get it replace or rebuilt. either way youll need a trans.

Jun 26, 2010 | Cars & Trucks

1 Answer

99 PSD AUTO-MANUAL CONVERSION KIT ?


It would be cheaper to fix the automatic

Feb 23, 2009 | 1999 Ford F350 Regular Cab

1 Answer

Car transmission problem


trans band busted for reverse this is a common problem for the 94's easy fix but requires a tranny shop

Dec 06, 2008 | 1994 Ford Explorer Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...