Question about Cars & Trucks

1 Answer

I want to make my 2wheel drive vitara xl-7 a 4wheel drive but the transfer case is emptie. What do i need to make it a 4wheel drive ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 450 Answers

Too much trouble.. look for one that is already factory 4 x 4.

Posted on May 11, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 135 Answers

SOURCE: wont go in to gear

get the levers into neutral b4 reinstalling shifter.
real pain.

Posted on Oct 02, 2008

Brian032472
  • 150 Answers

SOURCE: 96 suzuki vitara - radiator empties but no visible leak

Check the passanger side floor board for moisture this could indicate a bad heater core. Then I would check the engine oil and make sure its not milky looking (head gasket). make sure when you fill it let it run with the cap open with you looking into the cap to be sure is circulating and not vapor locked (air pocket)
hope this helps

Posted on Feb 01, 2009

  • 12 Answers

SOURCE: shifting transfer case part time light stays

put it in 4 take out

Posted on Jul 21, 2009

  • 107 Answers

SOURCE: i needed to replace the rear main seal on a 2000

did you seat the torque converter IN THE TRANS before installing the tranny? If not you broke the pump in the tranny. Also DO NOT tip a used tranny upsidedown it sends all the clutch and band debres into valve body. I hope this helps CJ

Posted on May 27, 2010

ftw1952
  • 10319 Answers

SOURCE: 1997 chevy k1500 4x4 Makes

most likely a thrush washer is at fault since the 4x4 kicks in for you
Have a trans shop give you an idea how much to repair before you grind this thrust washer to bits

Posted on Feb 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How Do You install the transfer Switch In the Transfer of a 2004 Suzuki XL-7


How To Change Service Front 4WD Differential Suzuki XL-7 ...

? 2:22
https://www.youtube.com/watch?v=PQEnGgW6rfE
Feb 28, 2014 - Uploaded by 1A Auto Parts
http://www.1aauto.com In the video, 1A Auto shows how to toinstall, repair, ... How To Change Service Front ...

How To Install Replace Front Grille Suzuki XL-7 - YouTube

? 1:59
https://www.youtube.com/watch?v=ZjihqqSARl8
Feb 13, 2014 - Uploaded by 1A Auto Parts
How To Install Replace Front Grille Suzuki XL-7 ... 7:07. 2008Suzuki Grand Vitara Transfer Case Fluid ...

Dec 07, 2015 | 2004 Suzuki XL-7

1 Answer

What is the encoder motor?


read the manual yet, this is fully covered. !

https://suzukipitstopplus.com/Products/10047-2006-grand-vitara-xl-7-service-manual-ja627.aspx

RTM, then ask quesitons that you have.
save us 100 pages of posts.

Aug 17, 2014 | 2006 Suzuki XL-7

1 Answer

96 explorer disengages 4wh low but does not engage 2wheel


Does it shift to 4wd high range ? If so then shift to 2wd . What is going on here is the transfer case motor is stopping due to the motor position sensor has gone bad which means that you replace the transfer case motor assembly. But if you wish to make it a 2wd for awhile then remove motor and manually turn shaft . This can be done by raising and supporting rear axle truck in park remove motor turn shaft slowly with pliers and rotating the play in drive shaft. There are stamped markings on back of case showing gear positions..

Mar 31, 2014 | 1996 Ford Explorer

1 Answer

I have a 2000 Cadillac escalade it is in 4lo and the push button and lighting up and when you push 2wheel drive nothing happens I need help


solenoid is bad on transfer case... sometimes you can keep messing with it and it will finally switch, or you can take it off the transfer case for lil bit and it will reset itself...

Dec 28, 2013 | Cars & Trucks

1 Answer

My 2004 Ford F150 4WD feels like its in 4 low


Ok the motor was working on the transfer case but was it turning inside the transfer case all the way? Pull it back off and manually turn the inside of the transfer case to 2wheel drive.

Apr 09, 2017 | Ford F-150 Cars & Trucks

1 Answer

04 tahoe z71 the allwheel drive,2wheel drive,and 4hi,4lo buttons don't alwas work sometimes it's in 2wheel drive then go to 4lo and when i push the 2wheel button it just blinks and the 4lo button stays on...


Pulling code's from the 4X4 control module would point to a diagnostic procedure . Do you own a professional type scan tool that can read DTC'S - diagnostic trouble code's in the 4X4 control module ? Autozone , advance etc.... can not read these code's .
Which transfercase does it have ?
Transfer Case - BW 4482-NR4
Transfer Case - NVG 246-NP8

How many buttons for 4X4 three or four ?
The BW 4482 transfer case features a 3-button shift control switch located on the instrument panel
The NVG 246 EAU transfer case features a 4 button shift control switch located on the instrument panel
When the ignition key is in the RUN position, the transfer case shift control module monitors the transfer case shift control switch to determine if the driver desires a new mode/range position. At a single press of the transfer case shift control switch, the lamp of the new desired position will begin flashing to inform the driver that the transfer case shift control module has received the request for a new mode/range position. The lamp will continue to flash until all shifting criteria has been met and the new mode/range position has been reached, or has been engaged. Once the new mode/range position is fully active, the switch indicator lamp for the new position will remain ON constantly.The 4X4 system with four button shift control can set a number of DTC'S
DTC B0790
DTC B2725
DTC C0300
DTC C0305
DTC C0306
DTC C0321
DTC C0327
DTC C0359
DTC C0374
DTC C0379
DTC C0550
The three button switch can also set an store a few codes
DTC B0790
DTC B2725
DTC C0306
DTC C0327
DTC C0329
DTC C0359
DTC C0550
Without knowing if any of these DTC'S are stored can't suggest any type of repair .

Dec 29, 2017 | 2004 Chevrolet Tahoe

1 Answer

Truck is stuck in 4wd low how do i get it out? it is a 2004f-150


This will require the help of a assistance. With the engine turned off, set parking brake . Have your assistance turn the key to the on position (motor off) and turn the 4 wheel drive switch to 2 wheel,next apply brakes and shift vehicle into neutral. While your assistance continues to hold brake petal on crawl under your truck and locate the transfer case. on the back side of the transfer case there is a electric motor, using a hammer moderately rap on shift motor (ON the area of the motor its self) If you now hear it shifting and it shifts back to 2wheel drive your transfer case motor needs replaced. thanks for using fix ya

Jan 08, 2011 | 2004 Ford F150

1 Answer

Trying to find way to fill transmission fluid


To change the fluid in the transfer case you must go under neath the vehicle ,on the side of the transfer case you will see a nut on the side ...that's is where you fill it ...on the bottom or some times on the side you will see another nut to empty it ...I recommend putting transfer case oil synthetic ....if you ever go through a lot of water while 4 wheeling,i recommend changing the fluid in your transfer case as soon as you can ...also check your rear end to see if there is water in it....to resovle problem ...add a longer hose ,so it will not take on any water ,hope this was help full

May 12, 2009 | 1999 Suzuki Grand Vitara

1 Answer

How can i convert grand cherokee laredo from 2wheel to 4wheel.i wana ask you the process


First you need a transfer case, then you need a shorter rear drive shaft. You need a front diff. same ratio as the rear diff. you need a front drive shaft. You need different trailing arms. Should I go on ?

Dec 08, 2008 | Jeep Cherokee Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...