Question about 2000 Dodge Durango

Open Question

Where is the low pressure port on AC for a 2000 Dodge Durango

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

66 chrgr
  • 1011 Answers

SOURCE: i have a 2000 dodge durango 360 that once it runs loses oil press

if there is no knocking noise then replace the oil sending switch this should fix your problem let me know

Posted on Feb 22, 2009

  • 22326 Answers

SOURCE: 2005 Dodge Durango won't blow cold in front!! Rear air works fine

you are bodging it and as you dont know anything about the A/C system then leave well alone and get it done with a machine.the whole system needs to be evacuated oil drain needs to be measured then refilled with the correct grade of oil and then regassed with the correct WEIGHT of gas and possibly a leak sealer added using special equipment.If it still doesnt work properly then it needs draining again and the venturi valve removing and checking out on the front unit.This is a specialised job for highly skilled operatives with the right equipment

Posted on Feb 28, 2009

  • 1 Answer

SOURCE: where is the AC low pressure port on a 2004 Dodge 2500?

I would think you found the low pressure port by now? But just in case most Dodge trucks I have seen have the low pressure port just above the compressor on the suction line. Of coarse leave it to Dodge to move it on some applications? Good Luck !

Posted on May 26, 2009

  • 2 Answers

SOURCE: 2005 Dodge Durango Front AC won't blow cold, back air works great

Did anyone find the answer for this?

Posted on Aug 30, 2009

  • 2299 Answers

SOURCE: Location of low pressure port

I am not 100% sure, but it should be on the passenger side, There is a aluminum line that runs up to where the radiator is to the AC compressor. It will have a cap on it like a valve stem cap on it.

Posted on Sep 15, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can I use an ac fluid pressure sensor from a different year since they discontinued the part for 2000 Durango 5.9l?

Maybe, consult you're local auto parts store and ask them the difference between the years. Sometimes the differences are so minute, the don't matter, sometimes they do.

May 13, 2014 | 2000 Dodge Durango

1 Answer

My 2000 durango won't start I have spark but very low fuel pressure I hear the fuel pump kick on what should I check

Low fuel pressure will do it. Will it start with starter fluid

If you need further help, I’m available over the phone at

Feb 09, 2013 | 1999 Dodge Durango

1 Answer

Where to add freon on 1999 dodge durango

At the low pressure port, that is the side with the larger line from the AC pump. The charging kit only goes on the correct fitting, so you will not be able to hook up to the wrong port.

Jun 15, 2012 | 1999 Dodge Durango

1 Answer

Location of low side a/c service port

The low side port is located in the low pressure side of the AC system, this is the larger of the two lines comming from the compressor.

Jun 07, 2012 | 2005 Dodge Durango

1 Answer

Charge ac

The high pressure service port is located on the liquid line between the condenser and the evaporator, near the front of the engine compartment. The low pressure service port is located on the compressor manifold, directly over the suction port of the compressor. Make sure you know what your doing if you connect the wrong thing to the wrong port you can blow something up.

Mar 22, 2012 | 1998 Dodge Durango

1 Answer

Can't find the LOW PRESSURE port on a 2004 Dodge Durango to charge the AC???

cannot say for sure as i have never seen one of these vehicles but some vehicles do not have a low pressure port as such ,you need a special adaptor as it only uses a high pressure fitting on the low pressure pipe ,confusing i know but lots of new europeon vehicles only have the one fitting so ask at dealer to be sure

Aug 20, 2011 | 2004 Dodge Durango

1 Answer

Location of low pressure port on 2000 dodge durango

I am not 100% sure, but it should be on the passenger side, There is a aluminum line that runs up to where the radiator is to the AC compressor. It will have a cap on it like a valve stem cap on it.

Sep 15, 2010 | 2000 Dodge Durango

2 Answers

My recharging kit for air conditioner doesn't seem to fit recharge valve on 2004 dodge durango. How can I be sure i am looking at the low prerssure valve?

Newer vehicle come with R134 vs R12. Since the two are not compatible, R134 has larger fittings. AC system has two ports, High and Low. Low is return to AC Compressor and high is output. High port is first following line from compressor to condenser (condenser is at front of vehicle like a second radiator). Keep following line till you find high port (paint cap red). Second port is low (paint cap blue).

Jul 11, 2009 | 2004 Dodge Durango

Not finding what you are looking for?
2000 Dodge Durango Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides