Question about 2003 Toyota Corolla

1 Answer

2009 matrix a/c bottom not ligth and compressor don't desengage

Posted by on

  • Andres Gonzalez
    Andres Gonzalez May 12, 2014

    The compressor was worn, I changed with the new one the new a/c compressor comes with clutch engaged. I did the process with vacuum pump, fill with gas.... The system shows correct pressures but the a/c push bottom not light and the compressor keep engage at all times. What is wrong?



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Toyota Expert
  • 294 Answers

Well the compressor is a variable type and the pulley is a brake away design so it is fix to the shaft, that's normal on the other side you did not mention if properly cooling.... if it is your a/c indicator bulb may be out,(some units use an led bulb/not replaceable) hope it helps.

Posted on May 13, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Car has no power after changing fuses with car on

If your vehicle was running while you
changed a fuse, you may have fried the computer.
Try disconnecting the positive(red side) cable on your
battery. Desconnect it for about 5 or 10 seconds
then reconnect it. This will reset everything.
That is, if you didn't fry the system. You might
want to check that fuse you replaced. For future
reference, only change fuses with vehicle off.

Jun 28, 2014 | 2009 Toyota Matrix

1 Answer

What is wrong?

If you disconnect the electrical wire going to the compressor does the compressor disengage?
If it does not,it is defective.

Mar 02, 2018 | 2009 Toyota Matrix XRS

1 Answer

2009 matrix 115v power outlet not working

usually in side panels in the rear. well covered. have seen some under the back seat but its depends on what model the inverter is. hope this helps

Mar 23, 2014 | 2009 Toyota Matrix

1 Answer

I can not find the Back door sensor light

The sensor is in the door latch.

Jan 20, 2014 | 2005 Toyota Matrix

1 Answer

Change bulb in tail light on 2009 matrix

How to change a break light on 2012 Toyota Matrix

Feb 24, 2013 | 2009 Toyota Matrix

1 Answer

A/c blows warm air when car is on motion, but works well on idle

directional flaps working or not ?
0 ring or joint leaking
stuck tx or inline valve
not enough gas pressure in system

Apr 12, 2017 | 2009 Toyota Matrix

1 Answer

Fuse diagram for 2009 matrix

Where exactly is the starter relay switch on a 09 toyota matrix?

Sep 27, 2011 | 2009 Toyota Matrix

1 Answer

I don´t see the ligth of the car in the nigth

Have hadlights aimed. Sounds like they are aimed too low. This happens as the sprnigs sag in the front more that in the back due to the increased load on the front. 

Aug 09, 2008 | 1988 Toyota Tercel 2 Door

Not finding what you are looking for?
2003 Toyota Corolla Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides