Question about Cars & Trucks

1 Answer

What can i do after i replace the ignition in my 2000 camaro to reset the anti theft

I changed the ignition switch. and my car still wont crank. please help what else can it be

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 124 Answers

Have to take it to the dealership. If it's just a blinking light, I'd leave it. Costs a lot for them to turn off the light.

Posted on May 10, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jwyatt816
  • 3 Answers

SOURCE: 2000 Cadillac Deville DTS is in anti- theft mode

you can reset the system by turning key to on position for 5-10 mins and then try starting it but its probably a short or grounding prob try the engine to chassis ground

Posted on Oct 03, 2008

  • 1 Answer

SOURCE: anti theft device for 97 ford expedition

I have 2007 expedition XLT and the interior light blinking all the time what the solution ?

Posted on Oct 18, 2008

  • 275 Answers

SOURCE: anti theft device for 97 ford expedition

try locking and unlocking the drivers side door with the key

Posted on Nov 12, 2008

Keith100881
  • 74 Answers

SOURCE: 2000 windstar anti theft system

un hook battery and wait about an hour or so and use factory key if wont fix dealer has to reset.

Posted on Jun 23, 2009

  • 19 Answers

SOURCE: 1999 Pontiac Sunfire ignition lock cylinder

try turning the ignition on try to start then without shutting key off wait 10 mins then shut key off then back on but do not try starting leave on for ten mins then back off turn key back on to run but do not try starting it wait ten mins then if it reset it should crank over and start if not repeat all steps again

Posted on Sep 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I fix the security system? the security light comes on and it wont crank. Does it reset itself?


sounds like gem module I had a 2001 did the same took batt cable off for 10 min and put back on and it worked for awhile it's the anti theft module a dealer can remove in for $ 150 hope that helps hope that helps

Nov 21, 2015 | 1995 Chevrolet Camaro

2 Answers

How to reset anti-theft on a 2000 alero


The security, antitheft or lock picture/icon is a visual indication that something in the car's antitheft system is failing. In most GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each other. The security light illuminates when that signal gets broken, even just for a second. When the signal breaks, the car misinterprets this as an attempt at theft and goes into antitheft mode. The car thinks its being stolen or hotwired because it is not getting that signal from YOUR specific key. This is why the security light turns on and shuts down your vehicle. This link explains it pretty well.
http://www.diy-gm-security.com/

25627937-vycpj41x2iphfdmbx4v0vfed-3-0.jpg

Apr 04, 2015 | 2000 Oldsmobile Alero

1 Answer

Anti theft wont reset car not start


Dead Battery
Bad Starter Solenoid
Bad Starter

The starter solenoid clicks, your past the
security system & starter relay

May 02, 2014 | Ford Crown Victoria Cars & Trucks

1 Answer

CAR WON'T START, NOTHING AT ALL.HAVE LIGHTS,HORN WORKS CHECKED THE ANTI THEFT SYSTEM TO SEE IF IT NEED TO GET RESET


Most cars have an ignition chip on their ignition key. This is an anti-theft feature. If it gets damaged or your ignition switch doesn't read it properly your car won't start. Everything else will work your engine just wont crank over. You can replace the ignition switch and key or you could bypass this theft feature. Talk to a mechanic to locate your ignition wire under the dash near the steering column. You can get a resistor (at Radio Shack) that matches the resistance of your key. Cut the ignition wire and put the resistor in its place to reconnect the cut wire. If you cut the right wire and the resistor matches your key you can trick your onboard computer to allow the car to start. This is what I did rather than replacing the switch. Cost of this fix less than $3.00 this way.

Mar 24, 2011 | 2002 Chevrolet Malibu

3 Answers

How do you reset anti theft on a 2007 equinox


TURN ON IGNITION SWITCH TO ON POSITION.ENGINE OFF.REPEATEDLY PRESS VECHICLE INFORMATION BUTTON UNTIL PRESS TO RELEARN REMOTE KEY IS DISPLAYED.PRESS SET RESET BUTTON UNTIL REMOTE KEY LEARNING ACTIVE IS DISPLAYED. IF THAT PROCEDURE DONT WORK.INSERT MASTER KEY INTO IGNITION SWITCH.NOW SWITCH IGNITION ON SWITCH IGNITION OFF.REMOVE MASTER KEY.WITHIN 10 SECONDS INSERT NEW KEY.SWITCH IGNITION ON.ENSURE SYSTEM WARNING LAMP SWITCHES OFF.NEW KEY NOW PROGRAMMED.IF YOU STILL HAVING PROBLEM RESETING THEFT SECURITY SYSTEM THE DEALERSHIP HAS TO FIX.REPROGRAM IT.

Mar 14, 2011 | 2007 Chevrolet Equinox LS New Cars

2 Answers

The car wont start, the brake pedal is locked like the anti-theft is active, the anti theft light is flashing when the keys are in the ignition. when i try to turn it on it doesnt turn over, just makes...


TRY REPROGRAM KEY .PUT KEY IN IGNITION SWITCH TURN IGNITION SWITCH ON POSITION 20 SECONDS DONT START ENGINE WAIT 20 SECONDS TURN OFF SWITCH THEN TURN SWITCH BACK ON 20 SECONDS WATCH THE THEFT SECURITY LIGHT BLINKING.WHEN THEFT STOP BLINKING VECHICLE WILL CRANK.IF LIGHT STILL BLINKING.TRY FEW MORE TIMES KEY IN SWITCH ON POSITION FOR 20 SECONDS.MAKE SURE YOU HAVE THE CORRECT CAR KEYS IN SWITCH IF NOT WRONG SET OF CAR KEYS WILL SET OFF THEFT SECURITY SYSTEM.IF KEY RESETTING TRICK DONT WORK.CHECK BATTERY POWER MAKE SURE YOUR BATTERY HAS 12.5 VOLTS AND CHECK SECURITY THEFT FUSE.IF ALL LOOKS GOOD YOUR SECURITY HAS TO BE CHECKED OUT AT THE DEALERSHIP.

Oct 08, 2010 | 2006 Ford Fusion

2 Answers

My mechanics say the brain box locked on security. it has refused to start, they've tried all they can but it just wont start, they say the brain box has to be reprogrammed. it a nissan maxima 2000 model....


IF YOU GOT 2 SETS OF KEYS TRY ANOTHER IGNITION KEY.THAT NOT WORN.TURN ON IGNITION FOR 5 SECONDS.SWITCH THE IGNITION OFF.WAIT APPROXIMATELY 5 SECONDS.SWITCH IGNITION ON FOR APPROXIMATELY 5 SECONDS.SWITCH IGNITION OFF.WAIT APPROXIMATELY 5 SECONDS.START ENGINE.IF STARTS OTHER KEY WAS WORN.IF CAR STILL DONT CRANK.THE DEALERSHIP HAS REPLACE KEYS AND ANTI THEFT SYSTEM AND REPROGRAM TO CRANK.ALSO CHECK TO MAKE SURE THE NEUTRAL START BACK UP LIGHT SWITCH IS WORKING.IF FAULTY IT WILL ALSO CAUSE NO START PROBLEMS.

Feb 28, 2010 | 2000 Nissan Maxima

1 Answer

Is there a anti theft reset 2002 vw jetta


DEALERSHIP HAS TO FIX IT.ANY TIME YOU HAVE PROBLEMS WITH ANTI THEFT SECURITY SYSTEM THE DEALERSHIP HAS TO REPLACE AND REPROGRAM CAR.IT COULD BE KEYS WORN BAD OR IGNITION SWITCH AND PCM CANT RECOGNIZE KEY.THE CAR WONT CRANK.

Oct 22, 2009 | 2002 Volkswagen Jetta TDI

2 Answers

Anti theft light comes on when driving


no cutoff switch!! try this turn key to on, do not start car. let sit for about 30 minutes, after 30 minutes, turn key off. wait 15 seconds and try to start car. this should reset anti theft system.

Feb 20, 2009 | 2000 Chevrolet Malibu

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...