Question about 2001 Chevrolet Astro

1 Answer

Doors do not lock or unlock with the buttons

2001 astro awd, LS...doors do not lock or unlock with the lock buttons, but do lock and unlock with the remote, and unlock when removing the key. The rear door does not unlock at all and does not open.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

Check to see if someone might have unplugged the switches or rain may have ruined switch if window was down... the keyless module goes to the relays that throw the actuators. sometimes door switches are wired so one is the master and the other goes through it as a slave. GM should be driver side. also could be broken wires in the door boots from opening and closing. The rear door may have problems with the linkage from the key cylinder to the latch or be rusted. Usually one can find the relays by using the keyless while listening for a light clicking sound under the dash driver side kick panel if you need to check for unplugged harness.

Posted on Aug 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevrolet blazer 2001 programming transmitter FOB


lol...turn the key on..there a reset button on the dash that show mile how far u drive..well push and hold while the ignition on and engine off until it blink..than start tap it until you came across door lock/alarm...ok ...here the trick..leave the setting on the alarm. than u can press an hold unlock n lock until u hear the door lock than u release turn key off n on than off again...and than try your transmitter

Apr 21, 2010 | 2001 Chevrolet Blazer

1 Answer

Driver and Passenger auto door locks are inop.


Sounds like bad wiring, or bad door lock actuators. Check for power while locking/unlocking the doors.

Jun 29, 2009 | 2003 Chevrolet Astro

1 Answer

Step by step reset the door remote control lexus 400LS


1. sitting in driver seat, with driver's door OPEN, press lock/unlock button ON THE DRIVERS DOOR to lock all doors, then manually unlock driver door only.
2. Insert YOUR key in ignition, DO NOT TURN, then remove key.
3. Using the same lock/unlock button ON THE DRIVERS DOOR, slowly press lock-unlock in 5 cycles
4. Shut door.
5. Open door.
6. Using the same lock/unlock button ON THE DRIVERS DOOR, again slowly press lock-unlock in 5 cycles
7. With the door open insert your key into the ignition, turn to 'on' position (DON'T START), wait 5 seconds. Turn off and remove key.
8. Locks should cycle once (Car will lock and then unlock once by herself). If they don't cycle or they cycle more than once, do steps 1-7 over.
9. Now using the remote, push lock button, hold for one second, then release the button. The locks should cycle once. If not, start over and go slower.
10. Close the door.
11. Open the door.
12. Press the lock button on the remote. The locks should do a lock-unlock cycle.
13. Close the door
14. Press the lock button on the remote, the doors should lock.
15. Press unlock button and the doors should unlock.

Jun 16, 2009 | 1996 Lexus LS 400

1 Answer

Un work of the doors auto control lexus


1. sitting in driver seat, with driver's door OPEN, press lock/unlock button ON THE DRIVERS DOOR to lock all doors, then manually unlock driver door only.
2. Insert YOUR key in ignition, DO NOT TURN, then remove key.
3. Using the same lock/unlock button ON THE DRIVERS DOOR, slowly press lock-unlock in 5 cycles
4. Shut door.
5. Open door.
6. Using the same lock/unlock button ON THE DRIVERS DOOR, again slowly press lock-unlock in 5 cycles
7. With the door open insert your key into the ignition, turn to 'on' position (DON'T START), wait 5 seconds. Turn off and remove key.
8. Locks should cycle once (Car will lock and then unlock once by herself). If they don't cycle or they cycle more than once, do steps 1-7 over.
9. Now using the remote, push lock button, hold for one second, then release the button. The locks should cycle once. If not, start over and go slower.
10. Close the door.
11. Open the door.
12. Press the lock button on the remote. The locks should do a lock-unlock cycle.
13. Close the door
14. Press the lock button on the remote, the doors should lock.
15. Press unlock button and the doors should unlock.

Long beep to follow if successful.

Jun 16, 2009 | 1996 Lexus LS 400

1 Answer

Driver side unlock button will not unlock any doors.


Try taking the switch out and spraying it with some electrical cleaner. It's probably just dirty. If not, replace the switch.

May 05, 2009 | 1997 Ford Explorer AWD

1 Answer

How can i program the key less?


  1. Close all the vehicle doors.
  2. Insert the ignition key into the ignition lock cylinder.
  3. Press and hold the DOOR unlock switch.
  4. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
  5. Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
  6. Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
  7. Repeat the previous step to program up to four transmitters.
  8. Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
  9. Operate the transmitter functions in order to verify correct system operation.

Dec 03, 2008 | 1999 Chevrolet Astro

2 Answers

Child locks won't release


1997 ford explorer awd child safety won't open from the inside can you help

Nov 12, 2008 | 1997 Ford Explorer AWD

3 Answers

2005 Astro Van, when I put the vehicle into Park all the doors unlock. I only want the driver door to unlock as a safety precaution. I will manually unlock the other doors if I have passengers. I do not...


hello milford,

i don't think you can eliminate your problem, the door lock feature is being run by a single module and all doors are connected to it in parallel

so i you want that only the driver's side door would unlock as you put it in park, then you would isolate the rest of the doors to the module but will in turn not controll the rest for locking puposes.

you can not have both features. either control one door or controll all doors.

its your choice.

tnx for using fixya.

drcool

Aug 26, 2008 | 2003 Chevrolet Astro

Not finding what you are looking for?
2001 Chevrolet Astro Logo

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...