Question about 1998 Volvo V70

3 Answers

Remove rear wiper arm 1998 v70

Replacing motor...need to know how to remove wiper arm

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

As far as im aware the best way is to remove the rear tailgate at the hinges first

Posted on May 30, 2014

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Ok these can be a pain on any car. There is only about 3 differn't ways they are held on.

#1 There is a cover that can be pried off exposing a nut holding it onto the wiper motor shaft. Once you remove that grip the arm assy right at the shaft and lift while using a small twisting motion. If it seems really had or won't budge us a small hammer and something to place around the arm and tap the outside of the arm around the motor shaft. If it still won't come off you'll need to get a puller the remove it.

#2 There is a small leaver that has to be pressed to "Unlock" the arm from the shaft. It is usually located on the bottom of the arm assy and while pressed you can remove the arm with a upward motion.

#3 There is a locking pin that is driven into the arm and has to be removed using a pin punch (You can make one by cutting off the pointy end of a nail the same size as the locking pin), using this and a hammer gently drive the locking pin out and lift the arm off.

Now these are the most common types of locking retainers to hold the arm of. There may be many others.

Good luck and hope this helps.
Mike K

Posted on May 10, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

Http://www.volvo-forums.com/t36992-rear-wiper-arm-v70.htm

Posted on May 10, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear wiper arm


Good idea....just do it.

May 10, 2014 | 1998 Volvo V70

2 Answers

The rear windshield wiper motor needs to be replaced. where is it and how can i get to it?


MARK THE POSITIONS OF THE WIPER ARM ON THE LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE OUT SIDE LIFT GATE, THEN THE BEZEL.BECAREFUL DONT DAMAGE PAINT.ON THE LIFT GATE.AND REMOVE THE UPPER AND LOWER LIFT GATE TRIM PANELS.DISCONNECT THE ELECTRICAL CONNECTOR AT THE REAR WIPER MOTOR, THEN REMOVE THE TWO MOUNTING BOLTS SUPPORT WIPER MOTOR WHILE REMOVING BOLTS.THEN INSTALL NEW WIPER MOTOR AND PUT EVERY THING BACK IN PLACE VISA VERSA.

May 26, 2011 | 1998 GMC Jimmy

3 Answers

How easy is it to replace the front wiper motor on a 2004 ford escape ? Where is it located ?



Front Wiper Motor
Removal & Installation

NOTE A new wiper motor assembly comes with the linkage arm installed.
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the windshield wiper mounting arm and pivot shaft
    WARNING Do not remove the wiper motor linkage arm from the wiper motor assembly. If the arm is removed, the wiper arms may not park in the correct location.
    NOTE Use a suitable tool to separate the wiper linkage arm from the wiper mounting arm and pivot shaft assembly.
  3. Remove the 3 bolts and the wiper motor.

    7f7866e.gif

    Fig. Wiper motor and linkage

To install:
  1. Install wiper motor and bolts.
  2. Tighten wiper motor bolts to 10 ft. lbs. (13 Nm).
  3. Install windshield wiper mounting arm and pivot shaft.
  4. Check wiper operation.

Rear Wiper Motor
- Removal & Installation
  1. Remove the rear pivot arm.
  2. Remove the rear wiper motor shaft nut cover
  3. Remove the rear wiper motor shaft nut.
  4. Open the lift gate window.
  5. Remove the rear wiper motor cover trim panel.
  6. Disconnect the electrical connector.
  7. Remove the 2 rear window wiper motor nuts
  8. Remove the rear window wiper motor.

    79be491.jpg
    Fig. Rear wiper motor view-2008 model shown, other years similar

To install:
  1. Install rear wiper motor and tighten mounting nuts to 62 inch lbs. (7 Nm).
  2. Reconnect the electrical connector.
  3. Install wiper motor cover trim panel.
  4. Install rear wiper pivot arm tighten nut to 53 inch lbs. (6 Nm).
  5. Install shaft nut cover.
  6. Check wiper operation.

Good luck (remember rated this post).

Feb 25, 2010 | 2004 Ford Escape

1 Answer

I want to know in detail how you remove the rear wiper blade to replace it


first remove the wiper arm and the nut under it, next remove the panel inside the door , un-clip the wire connector, remove the 3 bolts holding the motor to the door. wiggle the motor loose .

Jan 27, 2010 | 1998 Dodge Caravan

1 Answer

Rear windscreen wiper V70 1998


Pull, and the plastic clips will disengage.  Some will break, there is nothing you can do about that.  Best to make a run to the dealer and pick up a handful of extra clips for the ones that do break.  There are tools that help prevent the clips breaking but they'll still break and it's not worth it.

Aug 08, 2009 | 1998 Volvo V70

2 Answers

Rear Wiper does not move


My 2005 Malibu Maxx the motor works but the wiper arm barely moves

Jun 19, 2009 | 2006 Chevrolet Malibu Maxx

1 Answer

2005 V70 Estate Wiper motor access


It's actually not that hard, just be carefull not to crack the windshield.


Remove the wiper arms 13mm nuts and the four to five plastic rivets in the black cowl. using a small punch push the center of the rivets all the way through and pull of the larger outside ring. Last but not least there are two push pins on the far left and right sides of the black cowl cover. Pull up on the pin and it will come loose. Well if you can understand what I've written.....

Now lift up on the front (side towards the engine) and pull it to the front of the car.


I hope this helps...

Feb 17, 2009 | 1998 Volvo V70

1 Answer

HOW DO I REPLACE A REAR WINDOW WIPER ON 2005 FORD ESCAPE?


Remove the rear pivot arm.
Lift the pivot arm to the upright position.
Slide the locking tab out.
Pull up and remove the pivot arm.
Remove the rear wiper motor shaft nut cover.
Remove the rear wiper motor shaft nut.
Remove the rear wiper motor cover.
Remove the rear wiper motor bracket nut.
Remove the bolt and the rear wiper motor.

Jan 29, 2009 | 2005 Ford Escape

1 Answer

I have a 1998 Ford Explorer.


  1. Remove the rear pivot arm; refer to Pivot Arm—Rear . 7981ec7.gif
  2. Remove rear pivot arm.
    1. Lift the pivot arm nut cover.
    1. Remove the nut.
    1. Remove the pivot arm.
  1. Remove the liftgate door trim panel; refer to Section 501-05 . Remove the (A) liftgate handle to liftgate screws and the (B) liftgate handle. Remove the liftgate trim panel screw access plug. Remove the screw.
  2. Remove the liftgate door trim panel.
    1. Use Windshield and Molding/Trim Removal Kit to remove the liftgate door trim panel from the liftgate window opening.
    1. Push the liftgate door trim panel toward the top of the liftgate and remove the liftgate trim panel. 9e75e00.gif
  1. Position the watershield aside to gain access to the rear wiper motor.
  1. Remove rear wiper motor.
    • Disconnect electrical connector.
    • Remove three retaining bolts.
    • Remove rear wiper motor.
good luck.

Jan 10, 2009 | 1998 Ford Explorer

Not finding what you are looking for?
1998 Volvo V70 Logo

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...