Question about 2007 Mazda CX-7 Grand Touring

Open Question

How to remove rear seat in 2007 mazda cx7 - 2007 Mazda CX-7 Grand Touring

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: I am trying to replace the low beam bulb on the

Open the 2007 CX-7 Owners Manual (here is you don't have one http://www.mazdausa.com/MusaWeb/pdf/manuals/2007CX7OM.pdf)
Go to page 8-35 (P. 331 in the pdf). Close the hood, you're in the wrong place. Remove the cover in the front of the wheel arch to expose the headlight assembly.

Posted on Jun 18, 2009

Hrnsly
  • 154 Answers

SOURCE: Timing chain broke on a 2007 cx7 w 65K miles

you need to take it to your local dealer and raise a big fuss because this is a known problem and if you yell loud enough you should be able to get this fixed under warranty.

Posted on Aug 12, 2009

  • 1986 Answers

SOURCE: 2007 mazda cx7

They're charging you for it? Since your car's only 2 years old, they should be covering it under warranty. Timing Chains don't break normally, and when they do, usually it's on a much older car. Mazda should be covering the costs for this under the power train warranty (which is good for 48 months or 50,000 miles, whichever comes first)



Posted on Sep 22, 2009

  • 12 Answers

SOURCE: How do I change the bulb in the low beam headlight

Removing the bulb in a CX7 is a real PITA. If replacing the right bulb, turn the steering wheel all the way to the right, or do the opposite for the left side. (or you can opt to remove the entire wheel on the corresponding side) You'll need to remove 3-4 of the fender well clips with a phillips screwdriver being careful not to break them. Once the screws are removed, pry back the wheel well cover to access the back of the headlamp to change the bulb.

Posted on Feb 01, 2010

  • 197 Answers

SOURCE: timing belt same clicking

vvt actuator and you are driven by timing chain not belt common problem in cx-7

Posted on Feb 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission problem with a 2007 Mazda cx7


This indicates a problem in the transmission control module as it is not activating the solenoids/servos and consequently the sensors that read turbine speed and output shaft speed are not reading the correct difference of the two units . Have this checked out at an accredited auto transmission shop.

Jun 16, 2014 | Mazda CX7 Cars & Trucks

1 Answer

Replacing struts on Mazda CX7


There are 3 Nuts inside the Engine Compartment, There is one Bolt on the Lower Arm and you have to remove the ABS and Torsion Rod. You need a Spring Compressor to do this job.

Apr 15, 2013 | 2007 Mazda CX-7

1 Answer

How do i replace a headlamp on a 2007 mazda cx7


un plug the cable socket at the back side of the headlight then remove the rubber cover at the same place and then there is a steel wire clip carefully remove it (as you have to put it back again) the lamp can be removed easily you have to put the new one in the same direction again so remember what you remove

Jan 20, 2011 | 2007 Mazda CX-7 Grand Touring

1 Answer

I cannot remove the push pins in the wheel weel on my Mazda CX7. Any suggestions? They have a philips screw head but unscrewing does nothing.


TRY TO PRY WITH A FLAT SCREWDRIVER BETWEEN THE SCEW AND WASHER DURING YOU UNSCREW THE PHILLIPS ...IT SHOULD BE OK....

Dec 04, 2010 | 2007 Mazda CX-7 Grand Touring

2 Answers

PROGRAMMING THE GARAGE OPENER ON MY REAR VIEW MIRROR ON A 2007 MAZDA CX7


GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

May 12, 2010 | 2007 Mazda CX-7 Grand Touring

2 Answers

How do I change the bulb in the low beam headlight in my 2007 Mazda CX7?


Removing the bulb in a CX7 is a real PITA. If replacing the right bulb, turn the steering wheel all the way to the right, or do the opposite for the left side. (or you can opt to remove the entire wheel on the corresponding side) You'll need to remove 3-4 of the fender well clips with a phillips screwdriver being careful not to break them. Once the screws are removed, pry back the wheel well cover to access the back of the headlamp to change the bulb.

Nov 04, 2009 | 2007 Mazda CX-7 Grand Touring

3 Answers

Timing chain broke on a 2007 cx7 w 65K miles


you need to take it to your local dealer and raise a big fuss because this is a known problem and if you yell loud enough you should be able to get this fixed under warranty.

Aug 03, 2009 | 2007 Mazda CX-7 Grand Touring

1 Answer

I am trying to replace the low beam bulb on the passenger side of a 2007 Mazda CX7 . Can't seem to figure out how to get to it. Any help?


Open the 2007 CX-7 Owners Manual (here is you don't have one http://www.mazdausa.com/MusaWeb/pdf/manuals/2007CX7OM.pdf)
Go to page 8-35 (P. 331 in the pdf). Close the hood, you're in the wrong place. Remove the cover in the front of the wheel arch to expose the headlight assembly.

Jun 08, 2009 | 2007 Mazda CX-7 Grand Touring

Not finding what you are looking for?
2007 Mazda CX-7 Grand Touring Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...