Question about 1988 Chevrolet Corvette
I have a 1988 corvette... the climate control has gone bonkers.. i have cleaned the contacts on the unit.. changed nothing.. i can hear the compressor engage.. but the fan does not come on.. tried it on the "auto".. econ.. and bi level settings.. with "auto" and manual fan speeds..
could it be the climate control head.. fan motor.. or the entire control unit ??? any way to narrow it down..?
any help would be appreciated..
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You should make sure you have proper charge for sure.has your battery gone dead lately? I know on some of them digital climate controls will act exactly like this and have to be reset or go through a setup sequence.
Posted on Aug 28, 2009
SOURCE: ac not working
if you by passed the relay and clutch engaged then this shows that pump works ??but was it getting cold on and around the restrictor valve where the pipes enter the cab is normally a valve block but american monsters use a valve in the pipe for cooling and if its not getting cold their or blowing cold inside cab then system needs re-gassing with R 134 gas if its an older system with R 12 gas then it will need to have adaptors fitted to valve connections and refilled with R134 gas.The main cause of A/C system loosing gas is porosity in the rubber flexible pipes also the back seal on the pump.Or just regass and put a leak stopper in the system
Posted on Nov 04, 2008
SOURCE: a/c heater climat control switch
Check the relais module located inside under the rh side of the heather box you can see the connector most of them need to be replaced as they burn out you may need to replace the blower motor as well,high amp draw caused by faulty bearings will overload the blower motor controller
Posted on Feb 15, 2009
There is a way to retrive the diagnostic codes in the A/C system by holding 2 buttons at the same time on the panel. I did this many years ago to solve a problem on my '92 Roadster. I got the info from corvetteforum.com Post your problem at corvetteforum.com. There are many experts there that will help.
Posted on Feb 21, 2009
Your A/C system has lost its refrigerant, and will automatically go into "ECON" at that time. System will have to be leak tested , repaired, and recharged. Hope this helps.
Posted on Apr 09, 2009
Tips for a great answer:
Dec 05, 2016 | Cars & Trucks
Oct 23, 2014 | BMW 325 Cars & Trucks
Jul 19, 2011 | 2004 Chevrolet Silverado
Aug 13, 2010 | 2000 Chevrolet Corvette
Sep 15, 2009 | 1988 Chevrolet Corvette
Jul 01, 2009 | 1987 Chevrolet Corvette
May 01, 2009 | 1988 Chevrolet Corvette
Mar 18, 2009 | 1986 Chevrolet Corvette
Feb 03, 2009 | 1988 Buick LeSabre
Jan 28, 2009 | 1989 Chevrolet Corvette
504 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: