Question about 1996 Nissan 200SX

Open Question

1996 nissan 200sx: where is the turn signal relay (under the dash, but where and what color is it)?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: NO TURN SIGNALS-BUT FLASHERS WORK

PROBLEM WAS FLASHER SWITCH WHICH HOUSES RELAY FOR TURN SIGNALS AND FLASHER UNIT--IT IS SOLID STATE AND WORKS WHEN YOU TAP ON IT--ORDERED ONE--IT SOUNDED LIKE A DIFFERENT RELAY BECAUSE SWITCH IS ABOUT 6 INCHES LONG AND EXTENDS BEHIND RADIO/CD/TAPE PLAYER--WHICH IS EASILY REMOVED (PUSH ON 2 SIDE TABS AND THEY POP OUT-GRAB THEM AND PULL ASSEMBLY OUT--PUSH RELAY OUT FROM BEHIND TOWARDS YOU--UNHOOK AND REPLACE--A 5 MIN REPAIR
GOOD LUCK
MC

Posted on Feb 13, 2009

Ad
  • 132 Answers

SOURCE: brake and turn signal lights stopped working on my 1996 Ford E150

You might have cut a wire or it could have broken or disconnected. Try tracing the wiring where you hooked up the trailer you may find one broken or disconnected.

Posted on Mar 26, 2009

  • 6 Answers

SOURCE: hazard flashers work turn signals dont where is

i am assuming you checked all your fuses and the fuses in the engine compartment. if so there is a switch in the steering column.

i am no expert on this quest you have here just offering my 2 cents.

i had a similar problem with my 96 monte carlo pretty much the same as a lumina...... but added to the no turn signals the brake lights would not work alot of the times as well. replaced switch in steering column and all was well.

good luck

Posted on Jun 25, 2009

  • 436 Answers

SOURCE: 99 caravan relay clicking under dash

couls be an old alarm in the van from previous owners and it keeps setting off and then flashing noise woud come from that unit

Posted on Oct 04, 2009

  • 534 Answers

SOURCE: My battery light indicator on dash board stays on

This is usually caused by a faulty alternator.
It stays on because the alternator is not generating sufficient voltage on the control winding to extinguish it.

Check battery terminal voltage while motor running with headlights on or blower fan running.
Terminal voltage should be approx 14.5V.
Ensure alternator and engine are properly connected to ground and the battery negative terminal.

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the high beam headlight fuse in a 1996 Nissan 200sx


Those fuses should be in a plastic box under the hood near the battery also check the relays. It should have a legend printed on the lid for fuse and relay function.

May 15, 2017 | Nissan Cars & Trucks

2 Answers

My signal are working well outside but dose not indicate on the datch board car nissan altima 2003


There is a Relay usually in the interior Fuse Panel under the Dash for the Turn signal that's where the clicking noise comes from also when your turn signals are on, I suspect you have a bad Relay or even a Fuse. Its unlikely the bulbs simultaneously went out in the Dash. So check your fuses and the Turn Signal Relay.

Jun 17, 2015 | 2003 Nissan Altima

1 Answer

Turn Signal problem


Hi:
I suggest to check the Flasher, that is located front seating area, center, under dash, mounted on driver side of center dash brace.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 27, 2012 | 1995 Nissan 200SX

1 Answer

Cannot remove the passenger side axle on a 1996 200sx Nissan


if you mean the transmission end ! put a pan under transmission to catch the fluid. use a bar, or big screwdriver to pry axle out of transmission. when putting back in, make sure the axle snap ring is tightly locked in transmission.

Nov 05, 2011 | 1996 Nissan 200SX

1 Answer

Hello, My 96 nissan 200sx ac only works on num 4, is it a bad switch are what?


It's the diode block. The switch is fine, but the diode block controls the speeds. It's about a $20 part and located under the dash next to the fan on the passenger side. It's held in with two screws and shouldn't take you more than 20 minutes to replace.

Aug 25, 2010 | 1996 Nissan 200SX

1 Answer

Ac only works in number 4 on my 1996 nissan 200sx se. is this a known problem and is there a fix? also my radio cuts out alot when i turn my ac ondoe sit sometime when i turn it on and sometime it does it...


Can't help with the radio but the fan is a simple fix. You need a diode block, it's about $20. Once you have the replacement it will be easy to find the defective one. It's located on the firewall under the passenger side dash next to the fan. Two screws and a wiring plug. It should take you longer to find than to replace.

Jul 08, 2010 | 1996 Nissan 200SX

1 Answer

Where is the flashers located to replace turning signals in a 1996 nissan maxima


The combination flasher relay is located under the dash panel, next to the center console near the Automatic Speed Control Device (ACSD) control box. If the turn signals operate in only one direction, a bulb is probably burned out. If they do not operate in either direction, a bulb on each side may be burned out, or the flasher may be defective.

0c054d5.jpg

The flasher is located next to the ACSD control unit under the dash panel on the driver side of the vehicle

Hope this help (remember rated this). Good luck.

Feb 08, 2010 | 1996 Nissan Maxima

1 Answer

Dash bord Air bag blinks, car won pass inspection safety inspect


most times the problem is the rotating contact under the steering wheel has a break in the wiring of the flat ribbon connector, the part is called a clock-spring airbag contact.

Mar 17, 2009 | 1996 Nissan 200SX

1 Answer

Turn signal not blinking


Hi sounds like just the flashing unit, located under dash to the right of the steering column.

Hope this help, if this does not fix the fault please get back to me and see were to go then.

Cheers

Aug 21, 2008 | 1996 Nissan 200SX

Not finding what you are looking for?
1996 Nissan 200SX Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...