Question about 1994 Chrysler LeBaron

3 Answers

Where is the sending unit for the fuel gauge located on a 1994 chrysler labaron located finj. 6cyl.

Where is the sending unit for the fuel gauge located on a 1994 chrysler labaron located finj

Posted by on

Ad

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 97 Answers

Hi there! I would not say that the removal of the fuel tank in these cars is difficult or hard to do. I don't have a ramp or pit, but I was able to remove the almost empty tank by myself and then did a complete tank cleaning and washing, and the only thing I needed to do, was to raise the rear of the car and support it safely it on a pair of stands. I recommend you to place a flat piece of Wood on a floor Jack saddle to support the weight of the tank when it is unbolted from the car, and then remove all the hose connections, including the fill pipe, as it is advantageous to have it removed from the tank as its large diameter allows you to perform an easy drying of the tank after washing it with soapy water, for a full cleaning procedure that in my case left a pristine looking and shiny appearance of a like new tank insides. I removed the tank in my car because the electrical connector for the fuel pump dried up and developed small cracks, the plastic (apparently a type of Nylon) became yellow and dry, and cracked. That caused a small leak that dripped a few drops of gas on the floor every 5 minutes. As a new connector for the pump harness costed almost the same as a complete new pump, I decided to replace the pump and clean the inside of the tank. To completely clean the tank, I filled it with hot soapy water and dropped a couple of dog chains inside, and sloshed the tank, rinsing it with plenty of clean water and a small K?rcher pressure washer. After letting it drain, I used a hand held hair drier on hot, placing the air outlet inside the large opening of the fill-up pipe, using a cloth around the drier nozzle to better seal the hot air blowing into the tank. After 5 minutes of hot air being blown into the tank, the steel Wall of the tank became very warm and that dried all the w?ter completely. With my somewhat small size hands, I was able to touch the inside of the tank both through the pump and the fill pipe openings. Believe me, the inside of the tank was as pristine, clean, shiny smooth; a complete cleaning that left the tank inside as clean as a new one!. Best Luck, Amclaussen.

Posted on Jan 19, 2015

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 752 Answers

Hi Ralph, I'm glad to help. The sending unit is inside the gas tank mounted on the fuel pump. Hope this helps and have an awesome day Ralph.

Posted on Jun 11, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 229 Answers

The send in unit should be found inside the gas tank

Posted on May 30, 2014

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

  • 4102 Answers

SOURCE: Fuel gauges bounces - 1996 Chrysler T&C 3.8

hi the sending unit is located at the very top of the tank to replace this part the tank will need removing to get to the top of the tank. Once the tank is removed its easy to remove the sender unit make sure your tank is empty first as it will be really heavy and hard to manage with fuel in the tank.

I you havnt got the use of a garage ramp or pit then it can be a big job removing the tank as it would involve removing all the fuel hoses and the filler hose from the tank to allow you enough freedom to get the tank off.

Let me know how you get on or if you need further assistance ok

Posted on Aug 25, 2009

Testimonial: "Thanks. Your response is exactly what I needed."

jacobs_danie
  • 808 Answers

SOURCE: i have a 1994 chrysler labaron what i would like to know is if there is a fuel pump sending unit i know theres a relay

Basically there are several components in the system there is a fuel pump relay a gas gauge sending unit and fuel pump.

Posted on May 07, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is a fuel gauge for when your tank is empty located on a 2006 Chrysler Pacifica


It could be the gauge on the dash or the sending unit in the fuel tank is bad. If it is the sending unit ,the gas tank will most likely have to be taken out. And if the dash gauge the dash will have to be taken apart. Diagnosis of Stuck Fuel Gauge Is it Gauge or Sending Unit Here is a video how to test it.

Dec 30, 2014 | Chrysler Cars & Trucks

1 Answer

How to repair sudden fuel gauge failure after fill up?


check fuel pump relay or fuses at the worst sending unit or gauge is bad

Sep 28, 2014 | 1994 Chrysler LeBaron

1 Answer

I have a 1994 chrysler labaron what i would like to know is if there is a fuel pump sending unit i know theres a relay but is there also a sending unit


Basically there are several components in the system there is a fuel pump relay a gas gauge sending unit and fuel pump.

May 07, 2014 | 1994 Chrysler LeBaron

1 Answer

I have a 1994 Chrysler labaron i have replaced the fuel pump & filter & the relay but it still blows the fuse


Sounds like a short somewhere in the circuit. If you are able check all wiring coming from the fuel pump for any chafed wires or loose connections check connectors and harnesses for corrosion or loose connection which can cause resistance. also check for any signs of melted or burnt wires or connectors. hope this helps some.

May 06, 2014 | 1994 Chrysler LeBaron

2 Answers

Can you tell me if the fuel pump is located inside the fuel tank or on the outside of a 1994 GMC Safari


For 1994 GMC Truck Safari Van AWD 4.3L CPI 6cyl is inside the tank...

zjlimited_751.jpg


Fig. 2: The fuel pump and fuel gauge sender assembly

Hope helps.

Feb 27, 2011 | GMC Safari Cars & Trucks

1 Answer

Fuel gauge stays on empty


check fuel gauge sending unit condition/ its located inside the fuel tank if its ok check your fuel receiver unit its in your instrument panel/ gear must have been worn out

Apr 07, 2010 | 1994 Mazda 2WD B Series Pickup

2 Answers

1994 crystler labaron alarm system deactivation


Lock your doors. Then Unlock with the key. Unless you mean complete deactivation

Nov 23, 2009 | 1994 Chrysler LeBaron

2 Answers

99 Chrysler 300M gas gauge droping down to empty


you are going to have to replace the sending unit for the gas gauge, it is located in the fuel tank.

Jul 20, 2009 | 1999 Chrysler 300M

2 Answers

Problem with fuel guage on my 1994 Mercedez Benz C180


There is no gauge in the fuel tank, the fuel sending unit is, that sends the signal to the fuel gauge in the dash to show how much is in the tank. Apparently, the sending unit is shot.

Jan 28, 2009 | 1994 Mercedes-Benz C-Class

Not finding what you are looking for?
1994 Chrysler LeBaron Logo

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...