Question about 2005 Nissan Altima

Open Question

What do I do to remove the covering on the top of the engine of a 2005 nissan

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I locate ignition coil #3 on a 2005 Nissan Altima 4 cylinda?


on top of the engine remove the plastic cover depending on which model you will have 1. a coil pack for all 4 cylinders so you change the whole part or maybe 2. 4 seperate coils if so no.3 is 3rd from front of engine or 3rd from drive belt end as you look under hood

Apr 04, 2017 | Nissan Cars & Trucks

1 Answer

Were is the swirl valve control located at on a 2005 Sentra


it located at right side rear top of the engine next to valve cover rear

Jan 13, 2017 | 2005 Nissan Sentra

1 Answer

How do i replace the thermostate in a 1987 nissan sentra


Where the top radiator hose connects to the engine is where the thermostat housing is. Remove the top radiator hose and remove the two bolts that attach the cover of the thermostat housing. What you see now is the top of the thermostat. grab hold of it and remove it. The paper gasket may hinder the easy removal of the thermostat. Just tug a little harder and it will come free. scrape off any remaining gasket material from the housing and the cover. Put the new thermostat in and the gasket on top of it. Use a liquid sealant on the cover side of the gasket...not both sides. Position the cover back on the housing and tighten both bolts. Push the radiator hose back on and tighten the clamp. Add lost coolant and start the engine. Let it run long enough to open the new thermostat. Recheck the coolant level and top off as needed.

Oct 07, 2014 | 1987 Nissan Sentra Wagon

1 Answer

How to get wire clip off crankshaft sensor


its a big job its secured to the engine block you have to Remove engine cover and valve cover and air tube If you look straight down from the valve cover you can see a black wire have a green top on connected to a sensor . good luck .


Nov 06, 2011 | 2005 Nissan Altima

1 Answer

HOW DO I CHANGE THE PLUGS IN A 2004 ALTIMA 2.4L. iIHAVE REMOVED THE ENGINE COVER,NOW WHAT?


pull the plug wires up, they are located on the top of the head. get a plug socket on a long extension and take them out.

Dec 05, 2010 | 2005 Nissan Altima

1 Answer

Finding the starter on 2005 nissan pathfinder


STARTER LOCATION ON 4.0 V6 -REMOVE ENGINE UNDER COVER.REMOVE EXHAUST MANIFOLD COVER FROM EXHAUST MANIFOLD RIGHT BANK TO GAIN ACCESS TO STARTER COVER BOLTS.THEN REMOVE STARTER COVER BOLTS AND REMOVE STARTER COVER.**** 5.6 V8 ENGINE YOU HAVE TO REMOVE INTAKE MANIFOLD TO GET TO THE STARTER.

Sep 10, 2010 | 2005 Nissan Pathfinder

1 Answer

How do you set the timing on a 2005 nissan altima 2.5 the crank has line up marks but there are no mark to go by on the head to line up the cams.


The cam has an access cover that allows you to see that the timing points line up. You have to look at the cam from the end on the passenger side and see that the points line up. This is done by making sure the lower pulley is on Top Dead Center and then look to see that the cam and the pointer line up with the inspection cover removed.,,,,,,, I copied this from somebody else, I thought I would pass it on. I have a Nissan Sentra, but I am not familiar with the cams. Hope this helps.

Mar 31, 2010 | 2005 Nissan Altima

4 Answers

Nissan micra k12. not idling properly, low power, not staring all the time. continuous problem. replaced throttle with 2nd hand part. better for a while. now car wont start, if it does it hunting,(sound...


HI, I GOT NISSAN MICRA 1.2 SE 2005 PLATE ONLY DONE 59000 MILES. MISSING! I HAVE CHANGED COIL PACKS, CAMSHAFT SENSOR, TIMMING CHAIN, STILL THE SAME PROBLEM. I HAVE ALREADY SPENT 1000.00 POUNDS. IS THERE ANYONE WITH SAME PROBLEM?

Jan 29, 2010 | Nissan Micra Cars & Trucks

1 Answer

Starter


The starter on the 5.6 L engine is located at the top of the transmission bellhousing. You have to remove the upper intake plenum to get to the starter. You can't really see the starter until the plenum is out of the way.

Hope this is helpful!!

Nissan Scope Technician- 10+ years experience in Nissan dealership

Nov 10, 2008 | 2005 Nissan Titan

2 Answers

Pathfinder 2003 pcv


The PCV valve is located in the valve cover on the passenger side of the vehicle. The valve is closer to the firewall than it is to the front of the engine. It has a hose attached to it and threads into the valve cover.

Nissan Scope Technician- 10+ years experience is Nissan dealership

Nov 02, 2008 | 2003 Nissan Pathfinder

Not finding what you are looking for?
2005 Nissan Altima Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...