Question about Cars & Trucks

1 Answer

What would make my car use more gas and spider after I put a short ram coldAAir intake on a 2014 Corolla s

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 50,583 Answers

By altering the vehicles original specifications you have upset the sensor parameters for the MAF/VAF sensors and the o2 sensors. I would say that with the altered air flow the sensors are reading a need for more fuel and that has lowered the economy. Should wish to continue using the item then I suggest that you have it reset using a chassis dyno at a speed shop to recalibrate the CPU program

Posted on May 10, 2014


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 343 Answers

SOURCE: its not putting gas in the motor we changed the

Try replacing the fuel pump relay located in the fuse box that sits in the engine bay. There should be a diagram on the under side of the cover to help you find which relay it is.

Posted on Aug 08, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I put a short ram intake on my corolla S 2014 now I take off bogs out real bad and my idol is really messed up why

by "ram intake" do you mean a cold air intake? Possibly a Vacuum leak. a large vac leak.. Check everything you did for misfits, loose clamps, broken hoses, hoses not installed properly, wires disconnected, if you find no problems replace your "ram air" with the stock components. If the problem goes away its your "ram intake" if the problem is still there you have one of the above listed problems. Best possibilty you did not reconnect the Mass Air sensor, or large vac leak

May 10, 2014 | Cars & Trucks

1 Answer

How to install a cold air intake in a 2002 Mitsubishi eclipse

first you must remove all of the old intake eqipment but dont remove the metal part with the wires coming out of it that is your map sensere it will have a mesh that is improtant to keep as well. remove the old airfilter box. the instale should be easy just make shure to reinstall the metal peace with the wires uesing the provided adapter. tighten all your hose clamps and install your filter and that should be it.

if you are just shoping around I own the 3.0 L spider and had much better resalts with a short ram intak.

Mar 26, 2011 | 2002 Mitsubishi Eclipse

1 Answer

What is needed to fix fault codes 14 and 24 for a 1994 toyota corolla

The following is from a Haynes manual for 1993-1996 toyota corolla and geo prism:

Code 14: ignition signal. No ignition signal to the ECM. Check igniter or circuit, ignition coil, ig. switch or circuit, ECM (engine control module or "computer")

Code 24: intake air temperature sensor. Open or short in the intake air temperature sensor circuit. Check intake air temp. sensor or wiring to ECM.

Jan 27, 2011 | 1994 Toyota Corolla

1 Answer

Its not putting gas in the motor we changed the fuel pump changed the spider gear but wont run you can put gas in the intake and it will run im wondering if it could be the computer

Try replacing the fuel pump relay located in the fuse box that sits in the engine bay. There should be a diagram on the under side of the cover to help you find which relay it is.

Aug 08, 2010 | 1993 Chevrolet S-10 Blazer

1 Answer

1994 S-12 V-6 Vortec Dumping Gas into the Oil Pan

If it's a "W" VIN (8th Digit) check the spider injector on the intake manifold. Throttle body will come off with the intake cover, ten 10mm bolts, and two 8mm holding the fuel lines in place. Once you move a few things and lift it off. (and unplug the big plug in the top that actually goes into the spider injector, about 12 prongs on it). Gently pry the spider out of the cradle on each side and squeeze the tabs and pull out each of the 6 injectors. If you take your time a novice can do it in about an hour.

Mar 08, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

97 Astro with new fuel filter and pump. Plugs,wires and cap! Still won't start. DEaler says that it will need a spider assembly. They say its leaking. However when you take the cover off from the inside...

i would not use a junk yard spider injection unit, the worst thing is when they sit,anyway you will need a upper intake gasket set,also when you remove the upper plinum check the lines coming into the intake that feed the spider, those leak causing flooding and no start,see if gas is puddled in that area, you will see the lines once upper intake plinum is removed. hope this helps.

Jan 06, 2010 | Chevrolet Astro Cars & Trucks

1 Answer

How to install a short ram intake on a 1994 honda accord

buy the correct short ram intake then you should get 3 clamps one for your filter and two for the rubber sleeve which connects from the short ram pipe to your intake manifold remove old intake vent and filter box hope this helps

Nov 04, 2009 | 1994 Honda Accord

1 Answer

Replaced fuel pump spider still no gas at poppits

4.3 L engine crank position sensor is located on passenger side bottom of timing cover. plug should be around the front of the intake manifold.

Oct 09, 2009 | 1995 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14479 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides