An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: remove seat rear
Have you tried pulling the seat UP from the rear ,wear it meets the back part of seat , if the seat is secured at the front into the carpet and so the car bodywork it is usually with a bolt , or a tag that will just pull forwards,towards the front of the car hope this helps
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It is held down by spring wire clips. Just push in on them really hard and the seat will release. Run a screwdriver under seat to locate the spring clips. The seat back just unbolts and lifts up and out.
IN ANOTHER post I read
Remove the RH seat, rear seat bottom, and plastic trim holding the right side carpet down, unbolt the seatbelt from the floor, and the carpet will pull up easily. Transmission computer is in a plastic box under the carpet there.
DO NOT CUT YOUR SEATBELT!!! Simply unbolt the seat from the body, unbolt the seatbelt from the body under the seat, tilt the seat forward, pull the seatbelt and part that attaches to the body between the seat cushion and backrest and release the tension. Not the easiest fix, but it only takes 30 minutes to do, and will save you a LOT of money. If you cut that seatbelt, you will be buying a new rear seat.
Remove the RH rear seat bottom, and plastic trim holding the right side
carpet down, unbolt the seatbelt from the floor, and the carpet will pull up
easily. Transmission computer is in a plastic box under the carpet there
Push the lower seat cushion toward the rear of the car and lift, there's 2 hooks approx. 12" or so either side of the center of the seat.
The seat back is held in with 2 bolt located on the lower outside corners.
You'll have to unbolt the seatbelts from the floor to completely remove the seat back.
hello tracieandmia, I am assuming that the seatbelt buckles are just underneath the seat. The rear seat bottem can be removed for access. If you reach under the front part of the seat bottem near each corner and lift up, the seat will release. You will need to give it a little yank and use a little force for it to release. Once each corner is released you can remove the seat bottem. To install the seat, slide it back under the seat back and push hard down on each front corner that you had previuosly pulled up at. You should hear a definite click/lock sound when the catches are locked.
If it is the factory installed speakers.They are come out thru the inside.You need to remove the rear deck carpet...Easiest way is to remove both back seats first .
Remove the bottom seat first by pushing the seat towards the back of the car / then lift it up.
Then you will release the other seat by (using a socket set) to remove 2 nuts inside the trunk.then the seat will be release to simply lift out of the car. remove the top deck carpet .
The speakers are held in by 4 angled clips.
From inside the trunk, release the 4 angled clips,disconnect the speaker wires.Then push the speaker inside the car and your done. Hope this helps.
you can remove the bolt that holds the seatbelt to the floor by pulling off the seatpad where the belt goes to the floor and then raise the seat and the belt should reset. this happens on my passenger side rear seat.
Hi, sit in middle seat facing forward. If seatbelt is mounted in roof over your right shoulder, the clip on the end of the seatbelt clips in down by your right hip. Then the 'free' clip clips in by your left hip in to one of the two seatbelt clips. If you have done it right you should have a lap/sash configuration with the belt form the roof running over your right shoulder. The roof belt is also 'inertia reel' and behaves the same as all the other belts. To get out of the seat belt undo the 'free' or middle point clip only. When you have finished altogether, press key in to end clip lock and store back in the roof. If you have problems getting clips in to holders press the release tab on the holder. Hope that helps.