Question about 2002 Mercury Grand Marquis

1 Answer

Where is the fuel level sensor located on a 2002 mercury marquis grand marquis

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 27 Answers

It is inside the tank attached to the fuel pump assembly that part is available seperatly but if you have 100k or more i would replace the whole assembly

Posted on May 10, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75817 Answers

SOURCE: 1992 Mercury Grand Marquis FUEL LEVEL SENDING

the sensor is located inside the gas tank, you can access the sender from the front of the tank, just make sure the tank is less than 1/2 full or gas will gush out when u remove the sender retainner ring on the tank to remove the sender, u will need the car on a lift to do this...

Posted on Jul 22, 2009

  • 5501 Answers

SOURCE: Cruise control on 2002 Mercury Grand Marquis has

Check for the recall on cruise controls to see if this model has problems.

Posted on May 03, 2009

  • 398 Answers

SOURCE: Where is the fuel filter located on a 2003 mercury

on the drivers side under the car bout the front seat area

Posted on Mar 05, 2010

  • 58 Answers

SOURCE: where are the spark plugs located on a 2000 Mercury Grand Marquis

There are eight COPs (coil-on-plugs) to remove. Using a 7mm or 9/32" socket, remove each bolt securing each COP to the intake manifold on top of the engine. Remove all eight COPs, and the spark plugs are underneath. When replacing the spark plugs, use only the proper Ford/Motorcraft plugs, even if they cost twice as much as the aftermarket ones. You will avoid further headaches this way. Hope this helps.

Posted on Mar 30, 2010

  • 564 Answers

SOURCE: how to replace starter +1993 Mercury Grand Marquis

disconnect battery,,jack car up,,put jack stand on frame,,take starter bolts out,(may not be easy),,take wires off starter,,hoped it helped,,

Posted on May 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel level sensor is malfuctioning what should i do?


if its over 100k its best to replace the whole fuel pump assembly with oem or airtex and try not to run the tank below 1/4 as the pump uses the fuel to keep itself cool

May 10, 2014 | 2002 Mercury Grand Marquis

1 Answer

2002 mercury grand marquis missing and hesitating


Since it could be several different things in the ignition system, as well as fuel and other things, you may have to get professional help.
Some things you did not mention are the coil, cam and crank sensors, and the computer.
I assume the check engine light is on and the only code you have is a random miss. There are a lot of things to rule out.

Jan 16, 2013 | 2002 Mercury Grand Marquis

1 Answer

Where is the coolant temperture sensor located on a 2002 mercury grand marquis, as Im getting OBD codes PO1299 and PO340


po340 is a camshaft position sensor code depending on what engine is in your vehicle sensors are located in different places you'll probably need a service manuel

Jul 30, 2012 | 2002 Mercury Grand Marquis

1 Answer

Where is the camshaft position sensor located on a 2002 mercury grand marquis


depends on the engine could be up front by the damper pulley or in the rear of the engine around the flywheel

Jul 30, 2012 | 2002 Mercury Grand Marquis

1 Answer

2002 mercury grand marquis 4.6l turns over but wont crank up


How about the injector? In the engine junction fuse box the fuse for the injector power is in there make sure its not open

Mar 06, 2012 | 2002 Mercury Grand Marquis

1 Answer

Fuel filter location 96 grand marquis


For 1996 Mercury Grand Marquis 4.6L SFI 8cyl the Fuel Filter is located: Under vehicle, passenger side, below seating area, near fuel tank, mounted on frame rail in fuel line

Hope helps (remember to rate this answer).

Mar 19, 2011 | 1996 Mercury Grand Marquis

1 Answer

Where is the fuel filter located on my 1993 mercury grand marquis


1993 Mercury Grand Marquis 4.6L SFI 8cyl
The Fuel Filter is located: Under vehicle, driver side, below seating area, front of rear wheelwell, mounted on chassis in fuel line .

Hope helps (remember rated this).

Jun 15, 2010 | 1993 Mercury Grand Marquis

1 Answer

1992 Mercury Grand Marquis FUEL LEVEL SENDING UNIT; The gas guage does not function. Where is this sensor located and how do I access it to replace it? I took this car for an inspection sticker, the guy...


the sensor is located inside the gas tank, you can access the sender from the front of the tank, just make sure the tank is less than 1/2 full or gas will gush out when u remove the sender retainner ring on the tank to remove the sender, u will need the car on a lift to do this...

Jul 22, 2009 | 1992 Mercury Grand Marquis

1 Answer

1996 MERCURY GRAND MARQUIS WITH OCCASIONAL SLUGGISHNESS ON ACCELERATION AND SEEMS LIKE IT MAY BE USING MORE GAS THAN USUAL. HAS BEEN WELL TAKEN CARE OF, REG. OIL CHANGES, NEW FUEL FILTER 2 YRS AGO-DR


I would use 10W40 in the 96 and 5W20 or 30 in the 2002.

For the 96 with sluggishness, you need to gently clean the MAF sensor wires with carb cleaner and a toothbrush. It is in the air intake tube. After cleaning, disconnect the battery for 1/2 hour, then reconnect so the computer can relearn the clean sensor. Drive for 10 miles, it will run rough until it relearns.


Section 03-14: Engine Controls, Electronic 1996 Town Car, Crown Victoria, Grand Marquis Workshop Manual
DESCRIPTION AND OPERATION Mass Air Flow (MAF) Sensor The mass air flow sensor (MAF sensor) (12B579):
  • is mounted on the corner of the engine air cleaner (ACL) (9600).
  • uses a hot wire sensing element to measure the amount of air entering the engine; air passing over the hot wire causes it to cool.
  • sends out an analog voltage signal to the PCM (12A650) to determine the intake air mass. The PCM will then calculate the required fuel injector pulse width to provide the desired air/fuel ratio.
The mass air flow sensor hot wire sensing element and housing are calibrated as a unit and must be serviced as a complete assembly.

Mass Air Flow (MAF) Sensor

f314297.gif

May 27, 2009 | 1996 Mercury Grand Marquis

Not finding what you are looking for?
2002 Mercury Grand Marquis Logo

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...