Question about 2000 Jaguar Vanden Plas

Open Question

How do i remove spare tire from 1998 jaguar vanden plas ?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 100 Answers

SOURCE: 1988 Jaguar Vanden replace headlight

What you need to do is remove the 2 screws on the top bezel from inside the engine bay, then underneath the outer corner of the plastic headlamp surround there is a philips screw, (put your head under neath car near from wheel) loosen the screw, do not remove it, now the headlamp plastic bezel/surround will come free enough so you can get a philips screwdriver in through the middle of the headlamp surround, there is a chrome retaining ring holding the headlamp in place, loosen the 3 philips screws (do not remove) The retaining ring will rotate and you can slide the ring out from the outer edge of the headlamp surround. The headlamp will then come out throught the middle of the surround, disconnect the 3 pin multiplug and reverse process for install.

Posted on Sep 19, 2008

soultrip
  • 103 Answers

SOURCE: Need a wiring Diagram for 1998 Jaguar XJ8 Vanden

See here.

Posted on Sep 29, 2009

SOURCE: How do i disable valet mode om a 98 jaguar vanden

Try inserting the key into the drivers door lock and try centrally locking and unlocking all the doors a few times. If this does not reset the valet function try using the key in the drivers door lock and pressing the fob at the same time as locking and unlocking the doors. Even with valet mode engaged you should be able to access the trunk by physically inserting the key into the trunk lock.

Posted on Oct 06, 2010

Testimonial: "it was really helpful and the trunk yea i was able to open with the key but it still doesn't remove the valet all is doing is not keep sunroof open "

  • 4102 Answers

SOURCE: Where is the battery on

HI, to locate the battery you need to open the boot/ trunk then look on one of the sides you should see a panel will pull open giving you access to the battery, from what i can remember its on the right hand side in the trunk/boot, have a look you should be able to find it now you know where you are looking.

let me know if you have any further problems ok

plz rate this solution as i have a whole page of unrated posts, thanks

Posted on Nov 13, 2010

  • 87 Answers

SOURCE: how to remove a starter on a 86 jaguar xj6 vanden

The starter motor is located on the passenger side ( left ) side of the motor. it is held onto the motor with two bolts. Before starting the removal process you must disconnect the battery by removing the ground lead. Under the car disconnect the battery feed wires on the solonoid mounted on the starter. Also disconnect the white with red tracer wire on the solonoid. This is the wire that comes from the starter relay on the firewall. Remove the upper bolt first. You can get at it from the top of the engine bay and then remove the bottom bolt. This starter is heavy. The starters on the later cars were a lot lighter. The starter will clear the engine. Be sure to test the new starter before you install it. Installation is reverse of the removal.

Posted on Dec 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 Jaguar, Vaden Plaus,car just quit running going down the road. Had to have it towed home Won't start,turns over, just won't start,says Restricted Performance.


Sounds like it is some type of 'limp home' mode.
It could be anything. It might be as simple as a bad Fuel Pump Relay. When you turn the Key to the ON position (not Start) can you hear a little buzz for about 1 second? That would be your fuel pump running. You need to see if the engine is getting gas and spark.

Jan 05, 2016 | Cars & Trucks

1 Answer

1996 Jaguar Vanden Plas. Problem: having trouble with vibration and noise on speeds between 30 and 35 mph. no vibration on lower or higher speeds. Any suggestions would be helpful.


Balancing the tires is the typical solution but your case sounds like it might be a bent wheel. Take your car to a tire shop to have them check for balance. While on the balancing machine, they can inspect the rim for a warped rim. Make sure you let them know prior to the wheel getting mounted on the balancing machine. Jags are known for that to happen. I hope it is just a tire balancing but if it is a bent wheel, the cost is more. Good luck.

Dec 29, 2010 | 1996 Jaguar Vanden Plas

2 Answers

I have a 91 vanden plas. what body style is this car .is it a xj6


the only vandeb plas i can find listed is indeed an xj6.

Dec 22, 2010 | 1991 Jaguar XJ6

1 Answer

Where is the battery


Right hand side of the luggage compartment, right near the spare tire.
You will need to remove the floorpanel and a small cover over the battery.

Oct 17, 2009 | 2002 Jaguar Vanden Plas

1 Answer

Leaking valve covers, 2000 jaguar vanden plas supercharged


no there is'nt enough pressure underneath to make it leak try tighting up the valve cover bolts or just getting a new gasket about a $6.00 to $10.00 dollar fix depending on where you go

Dec 01, 2008 | 2000 Jaguar Vanden Plas

2 Answers

1988 Jaguar Vanden replace headlight


What you need to do is remove the 2 screws on the top bezel from inside the engine bay, then underneath the outer corner of the plastic headlamp surround there is a philips screw, (put your head under neath car near from wheel) loosen the screw, do not remove it, now the headlamp plastic bezel/surround will come free enough so you can get a philips screwdriver in through the middle of the headlamp surround, there is a chrome retaining ring holding the headlamp in place, loosen the 3 philips screws (do not remove) The retaining ring will rotate and you can slide the ring out from the outer edge of the headlamp surround. The headlamp will then come out throught the middle of the surround, disconnect the 3 pin multiplug and reverse process for install.

May 18, 2008 | 2000 Jaguar Den Plas Supercharged

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...