Question about Cars & Trucks

1 Answer

Key won't come out if the ignition! - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

Need to replace ignition

Posted on May 10, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ignition of ford edge will not turn completely off..it is stuck in position 2 in auxillary power


1-
My ignition key will not turn to off. I can remove the key, but it stays in the accessory mode. What's the fix?
My ignition key will not turn to off can remove the key but it stays in...

2.
Ignition key is stuck and does not turn Inspection Service & Cost
Ignition key is stuck and does not turn Inspection Service Cost...

3.
Ignition key won turn

Aug 24, 2016 | 2012 Ford Edge

1 Answer

Key won't turn in the ignition


probably need a new ignition lock or your key is wore. ignition locks arn't too bad to change depending on the vehicle.

Jul 14, 2013 | Cars & Trucks

1 Answer

Toyota rav 4


ignition keylock cylinder broken or could have the wrong ignition key.

May 06, 2013 | 1998 Toyota RAV4

1 Answer

Steering wheel won't lock, key won't come out


If the ignition normally only locks with the vehicle in park position, then check the switch on the gear lever mechanism is working.
If not, then you'll have to jiggle and wiggle that key out or replace the ignition lock.

Nov 10, 2012 | Volkswagen Cars & Trucks

1 Answer

Stuck eldorado key in DTS ignition now car won't start


Make sure your steering wheel isn't locked. Sometimes a key won't turn until you jiggle the wheel while trying to turn the key.

Aug 21, 2012 | 2004 Cadillac DeVille DTS

1 Answer

Cranks and then goes dead


First check your fuel pressure it should be 41-47 psi with key on and engine off if its below 32 psi replace the fuel pump and filter.If fuel pump checks out to be good then take ignition switch out and check for burned ignition switch wires and worn ignition key tumblers and ignition lock cylinder.These cars are known for faulty ignition switches and ignition lock cylinders.Ignition switch gets to hot then it won't start until it cools off.

Dec 30, 2011 | 1996 Pontiac Grand Am

1 Answer

1998 Plymouth grand voyager ignition won't turn


I have had this happen on my 98 Voyager. Just have a new key cut. This new key will sometimes cure the problem. The older keys get worn out and won't unlock the ignition. Try this before a much more expensive and time consuming change of the ignition.

Nov 01, 2011 | 1998 Plymouth Voyager

1 Answer

My key wont turn to off in order to remove my key from ignition while in parking


Ignition - Key Stuck In Ignition Switch/Won't Turn Bulletin No.: 06-02-35-005 Date: February 28, 2006 TECHNICAL Subject: Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger) Models: 2002-2005 Chevrolet Monte Carlo Condition Customers may comment on any of the following conditions: - The key is stuck in the ignition cylinder. - They cannot return the key to the off position to remove the key. - The shifter button won't release in the park position. Cause This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD

Aug 05, 2011 | 2005 Chevrolet Monte Carlo

1 Answer

Ignition key won t turn. steering wheel locked


the key may be worn badly or the ignition needs to be replaced.

Jul 31, 2009 | 2004 Saturn VUE

2 Answers

Ignition key won`t turn on my chrysler cirrus


tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.

Jan 08, 2009 | 1999 Chrysler Cirrus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...