Question about 2007 Chevrolet HHR Special Edition

Open Question

How to replace blower motor resistor on 2007 hhr

How to replace blower motor resistor

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MacGyver911
  • 42 Answers

SOURCE: Where is the blower motor resistor on a 2003 Chevy Malibu

Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Posted on Mar 19, 2009

e-Guru
  • 3917 Answers

SOURCE: Blower motor or resistor?

Yes its the blower motor resistor.

More then likley theres some trash or something in it, or possibly the motor itself is on it's way out. There not that bad to pull out of that body car, just pull it out and see what you can see.

The blower motor is under the glove compartment

You can replace the resistor on your own. Please find a detailed diagram which would guide you to do it.

http://autorepair.about.com/library/images/bl629a-lib.htm

Thanks

Posted on Apr 09, 2009

  • 4 Answers

SOURCE: 2002 Chevy Impala Blower resistor location

It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike

Posted on Apr 20, 2009

  • 1 Answer

SOURCE: how do you replace a blower motor on an 06 hhr

you need to cut out the bottom of the box where the motor sits and get an blower motor attachment kit from local gm dealer

Posted on Jun 19, 2009

  • 118 Answers

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Posted on Jul 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I just replaced the blower motor on my 2006 hhr, it dosent Come on. I checked fuses,


Will it blow in the medium high position? If so it should be the blower motor resistor.

Dec 01, 2016 | 2006 Chevrolet HHR

2 Answers

2007 passat s model heater blower fan only works on setting no. 4 ?!



It's the resistor. You can replace the part for around $40 or repair the part for around $2. Prevent the part from failing again be refurbishing your blower motor. Here are two videos showing you how to accomplish this...

Feb 03, 2013 | 2007 Volkswagen Passat Sedan

1 Answer

2008 HHR fan not coming on when I turn the fan control knob. I replaced sensor still nothing


i'm not sure what sensor ur talking about but usually the problem is with the resistor or blower motor to check which one remove connector from the blower motor located on the passenger side under the dash behind the glove box check with a test light to see if ur getting power and ground to the blower on all speeds if u are replace blower motor if not replace the resistor or may be called blower module if that doesn't repair it u will need a control head

Jan 12, 2013 | Chevrolet HHR Cars & Trucks

1 Answer

Heater is on high will not change to a/c or lower speeds


The blower motor resistor is bad. First, determine if the resistor is separate from the blower motor. Most resistors are built into the blower motor. If separate, replace resistor. If not replace blower motor.

Jun 14, 2011 | 2007 Nissan Armada LE

3 Answers

2006 chevy hhr heater fan stopped blows at all speeds. Fuse panel under hood is numbered but nothing matches on fuses. I have no manuel.


CHECK FOR INSIDE FUSE BOX AS SOMETIMES THEY ARE SEPERATED FUSE BOX INTERIOR & POWER DISTRIBUTION BOX UNDER HOOD.

Jan 27, 2011 | 2006 Chevrolet HHR

1 Answer

How to replace the Resistor Pack for the Blower motor of a 2006 Chevy HHR.


This forum has great info and pics on the subject - I am in the process of getting mine fixed as well.

Oct 19, 2010 | 2006 Chevrolet HHR

1 Answer

Heater and air conditioner blower switch.


Check the resistor first. It may be bad. Should be under pass. side of the dash close to blower motor mounted in bottom of evap case. Remove it and try known good one first before going at the switch. If it works on high then the switch may be okay. Good luck.

Jun 06, 2010 | 2007 Chevrolet HHR Special Edition

2 Answers

Ac blower motor


it should be located in the heater/evap case under the dash by the glove box, usually the pigtail from the blower motor itself leads the the resistor pack.

May 29, 2009 | 2006 Chevrolet HHR

1 Answer

Ac blower motor


you need to replace the blower motor resistor assembly try this website www.autozone.com if they do you be able to checkout a price and get pictures and diagrams for the most part its on the passenager side behind the glove box i also would like to give you this information if you every have any hard to find GM-parts its Schram auto & truck parts 1-800-292-1032 and they website is www.schramauto.com and i hope i have been some help to you Michigan Man.

May 11, 2009 | 2006 Chevrolet HHR

1 Answer

Blower stopped working


Bad blower motor resistor.Remove plug & look to see if the plug is burnt/melted on any contacts.Also check the pigtail that plugs into blower motor.I only had to replace my resistor.

Jan 03, 2009 | 1999 Chevrolet C2500

Not finding what you are looking for?
2007 Chevrolet HHR Special Edition Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...