Question about 2006 Hyundai Tucson

1 Answer


2.0L GAS

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Hyundai Expert
  • 403 Answers

If you want to start empty the rad you have a little plug under the rad or on the side to open and drain or take bottome hose off with the rad cap off must be cold dont do it when engine hot now follow top rad hose down to motor should come to a casing with 2 or 3 bolts holding it to engine it should be round remove the cover and thermostat is there after finding and replacing it do all in reverse now fill rad up run vehicle till fans start with rad cap off to let all air out now fill to level put cap on and that it

Posted on Jun 18, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What's your question?my ford Freda 2,0l petrol has temperature going high and water heating so fast what could be the problem

When water heats fast the temperature must be checked independently to eliminate possible electrical problems with the gauge or sender.

If the coolant really is getting too hot too fast a restricted coolant circulation should be suspected. Thermostat is the most likely cause of low or zero coolant circulation but other sorts of blockage are possible and it has been known for the water pump impeller to fall off the shaft or to break up., though these things are rare. I don't advocate suspecting this unless there really is no flow and this is best checked by disconnecting a heater hose.

A restricted air flow through the radiator or the cooling fan not working would probably cause overheating but that tends to take longer and be unremarkable in the speed of overheating.

It is possible for a leaking cylinder head gasket to pressurise the cooling system and displace coolant and disrupt the thermostat operation.

Jun 06, 2016 | Ford Cars & Trucks

2 Answers

How long and how much to replace timing belt 2000 hyundai tuscon 2.4

we need more info on this vehicle yr make model engine 2wheel 4 wheel auto manual

Feb 03, 2015 | Hyundai Cars & Trucks

1 Answer

Wher is the coolant sensor fpr a 2010 focus

Clear the code and drive the vehicle. If the code comes back, then you know it's real condition and not a one time event.
Changing the temperature sensor isn't going to remedy the situation. Most likely the thermostat will need to be replaced.

Apr 26, 2014 | 2010 Ford Focus 1.6

1 Answer

Tuscon 07 starts when gas cap removed

Sounds like fuel tank vent is blocked,also check breather hole in fuel cap...

Jan 06, 2013 | 2006 Hyundai Tucson

1 Answer

How do you remove and replace engine on a 2005 hyundai tuscon

you drop the engine and trans out the bottom as a assembly then seperate them

Aug 12, 2012 | Cars & Trucks

2 Answers

My 2002 vw cabreo does not idle very erratic it has the 2,0L gas

1) Ignition time is incorrect. Reset the ignition timing to the specification of manufacturer.
2) Test the ignition system. see the diagram attached. God bless you.


May 15, 2012 | Volkswagen Cars & Trucks

1 Answer

How to aline crankshaft position and camshaft position

Timing marks for a 2002 Volvo S40 2,0L engine:


Oct 13, 2011 | 2002 Volvo S40

2 Answers

Where is thermostat on 97 VW Jetta 2,0L /engine runs cool/160 degrees

The lower hose of the engine block just behind the alternator is where you will find the thermostat.

Mar 05, 2011 | 1997 Volkswagen Jetta

1 Answer

2005 huyndia tuscon takes several times to started-doesn't happen each time, but every day-noted to begin after 1/2 tank gas added-put additives in-down to 1/2 tank of gas again-appears to happen more when...

Sounds like you may have either dirt, sediment, water in the base of your fuel tank, I would have the gas analysed and if it is contaminated have the tank drained, the fuel filter replaced the lines flushed and the injectors serviced, hope this helps.

Aug 01, 2010 | 2005 Hyundai Tucson

2 Answers

I have a 2006 Hyundai Tuscon 6 Cyl Automatic and when you apply brakes, it jerks and when you come to a stop, will stall out. It will restart and have no issues for a few miles but then starts again. I...

There are so many sensors and crud on cars these days, it's difficult to troubleshoot when problems occur. If your engine light is coming on, have Autozone hook up an OBD 2 tool and try to pinpoint which sensor is giving you a problem.
On another thought, get some gas additive and pour in your tank. Sometimes you can pump crud into your tank at the gas pump, when a big truck just delivers fuel to the stations underground tanks. This stirs up condensation and crud from the storage tanks and gets pumped right into yours. It's a cheap thing to try anyways...
Hope this helps... Good luck.

Oct 15, 2009 | 2006 Hyundai Tucson

Not finding what you are looking for?
2006 Hyundai Tucson Logo

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides