Question about 2000 Chrysler Cirrus

1 Answer

Turn signals and wiper do not work. How can I fix?

I have replaced wiper/signal fuse.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,511 Answers

Did you chack the fuse/

Posted on May 09, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mattozan
  • 555 Answers

SOURCE: 1991 Le Baron Turn Signal Problem

A Clymer Guide or similar manual will show you the wiring schematic. Should be available online, or in your library.

Posted on Jul 11, 2008

SOURCE: Windshield wiper and turn signals don't work.

I have seen this problem several times and it was the assembly under the steering wheel at the top of the steering column. There are many electrical connections in there for turn signals, wipers, horn, headlight dimmer, etc. The electrical contacts could be dirty and not conducting current or they could be misalligned or broken or just plain worn out.

If you're up to it, take steering wheel off and take a look. If there is an airbag, and you've never removed one of those, I wouldn't even start -- take it back to the shop and tell them what you suspect the problem to be.

Posted on Apr 28, 2009

motor1258
  • 6674 Answers

SOURCE: 2000 Town/country left turn signal

Good chance it's just a bulb problem, start there & clean socket good & replace bulb. If that doesn't cure it, get back to us.

Posted on Jun 24, 2009

  • 101 Answers

SOURCE: my headlights,windshield wipers, and turn signals wont work

check all your fuses. replace any and all bad ones. if fuse blows again u have a short somewher

Posted on Jul 03, 2009

  • 1779 Answers

SOURCE: MY TURN SIGNAL QUIT WORKING IS THERE A FLASHER

My service manual states that the '02 T+C has a combination turn signal/hazard flasher/daytime running lights module which is located on the junction block, adjacent to and left of the steering column. To access it, you must remove the steering column lower cover and knee pad panel. There is also a fuse for turn signal/hazard flasher. If none of them work, check the fuse 1st.

Posted on Jul 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windshield wipers won't turn off


This SHOULD be two different problems. I hope.
The wiper problem is very likely the wiper motor.
There is a "transmission" built into the motor, that used to be rebuildable 40 years age, but not any more.
The are made as cheaply as possible, and can fail in a few years, and often do.
Replacing the motor should fix that problem.
Since these are made cheaply, I have even gotten new ones off the shelf and had them "no good" either.
The turn signal, start with the fuse under the dashboard.
Then go to the turn signal relay, either under the dashboard or under the hood in a black plastic box.
If your 4-way flashers work, it would usually be the turn signal relay, since the 4-ways use a separate relay.
God bless your efforts.

Jun 30, 2016 | 2012 Dodge Grand Caravan

2 Answers

Why don't the headlights, turn signals, and wipers work?


Check fuses. Replace the turn signal switch for the head lights. If the wiper fuse is good, Replace the turn signal switch first, then go after the wiper motor. Both run threw the turn signal switch.

Apr 03, 2015 | 1998 Volkswagen Beetle

1 Answer

2000 buick lesabre Dash and turn signals not working.


I would think because your wipers don't work as well it could be your multi-function switch. (turn signal arm) The only other thing I would have recomended before hearing that your windshild wipers didn't work would have been your turn signal flasher. You may still want to try replacing that before anything elese. It will only cost you a few bucks and is located under your dash on the driver side. Near your OBDII plug. If your cruise control dosen't work as well, I would believe strongly that it is your multi-function switch.

Jan 25, 2013 | Buick LeSabre Cars & Trucks

1 Answer

1997 jimmy turn signals and windshield wipers quit working


Okay, we will need to pin point the short,first remove connector from wiper motor and install a fuse and see if it blows. if it does then we know its not the wiper motor.next, will fuse blow when key is turned on or do you have to turn on signals? if its when signals are working then check all bulbs, remove signal bulbs one at a time and make sure the correct bulb is in the socket and the bulb and socket are good, if all checks out then i would say you may have a bad switch,let me know what the outcome of these tests are i will help you fix problem or give you price. good day

Feb 22, 2012 | 1997 GMC Jimmy

1 Answer

Heater, turn signals and rear wiper do not work


https://s9.postimg.org/4k77afpa7/turn_signal.jpg

Click on the link. I looked at turn signal wiring. Check fuse 15--20 amp under hood fuse box. Not only check the fuse, use a testlight and check fuse circuit for voltage, hot all the time. At the combo flasher, there is also, ignition/run voltage, goes hot with the key on, you can see wire color.
There could be other issues. As you can see, turn signal switch is part of ground circuit.
I could post whole diagram on one link, but, too small to read. Usually with multiple issues, I just pick one and check it out. Fixing one issue may or may not fix the others?

Jun 29, 2017 | 1996 Plymouth Voyager

3 Answers

My 1996 mercury grand marquis wipers stopped working but the turn signal and washer sprayer button works what should i fix or replace?


check fuses if not that look for a short in the wiring near the wiper motor if you dont find one you probably need a new wiper motor,

Dec 04, 2010 | 1996 Mercury Grand Marquis

1 Answer

The turn signals on my 04 eclipse spyder Stopped!


There is a relay for your turn signals at the fuse block in the engine compartment,the wipers are on another circuit, if all the other wiper positions work,you got a bad switch

Dec 15, 2009 | 1998 Mitsubishi Eclipse

1 Answer

My headlights,windshield wipers, and turn signals wont work


check all your fuses. replace any and all bad ones. if fuse blows again u have a short somewher

Jul 02, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...