Question about Cars & Trucks

Open Question

Part No , p05064385AF Issue , 1 Date Code , 1273 S,N TCAAA1273J6838 Supplier ID 17719D That's all for Jeep cherokee 2003 I Chang the battery then I couldn't find the code , can anyone help me ?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 41 Answers

SOURCE: engine code 95 jeep grand cherokee lerado

12 is a battery disconnect within the last 50 start cycles and 55 means the end of the diagnostic cycle.  Basically the computer found nothing wrong. The 12 code may seem incorrect if you haven't disconnected the battery recently, but from my experience the 12 code shows up almost all the time regardless.

Posted on Dec 16, 2008

mcgyver468
  • 710 Answers

SOURCE: 2003 Jeep Vacuum Diagram

THERE SHOULD BE A EVAP/VACUUM DIAGRAM UNDER THE HOOD ON A WHITE STICKER. SOMETIMES THEY ARE ON THE BOTTOM SIDE OF THE HOOD ITSELF. I HOPE THIS HELPS. PLEASE KEEP ME POSTED THANKS FOR USING FIX-YA AND FOR AN HONEST RATING/COMMENT. GOOD LUCK

Posted on Aug 29, 2009

calilourw1
  • 12 Answers

SOURCE: 2003 Jeep Grand Cherokee Laredo - Code P0456 EVAP leak

open hood and ck for broken vacuum hoses going to the purge valve(2 vacuum ports and a wiring connector)
on the drivers side between airbox and firewall
if good remove driver side rear tire and inspect hoses next to the gas tank and 3rd, the canister is in that wheel well also insp for cracked hoses there also, been working for jeep 12 years i charged people about 1 hour to correct this probem.

Posted on Dec 18, 2009

Testimonial: "Thanks!"

ZJLimited
  • 17970 Answers

SOURCE: i have code p0137 coming up on my 2003 jeep grand

P0137 - Oxygen O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2)

Essentially the same as P0136, P0137 refers to the second oxygen sensor on Bank 1. P0137 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This, is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 1 Sensor 2 is located to the rear of the catalytic converter and should produce an output signal relative to oxygen storage capacity of the catalytic converter. This rear (sensor 2) sensor is less active than the signal produced by the front sensor. However, if the ECM senses the sensor is inactive, this code will set.

Symptoms: There may be no visible symptoms to the driver, other than the MIL (Check Engine / Service Engine Soon) illumination.

Causes: A code P0137 may mean that one or more of the following has happened:
* Faulty o2 sensor Exhaust leak near the rear sensor
* Plugged catalyst
* Short to voltage on O2 signal circuit
* High resistance or open on O2 signal circuit

Possible Solutions:
* Replace faulty sensor
* Repair exhaust leak near the rear sensor
* Check for restriction in catalyst and replace as necessary
* Repair short, open, or high resistance on o2 signal circuit

Hpe hti shelps (remember comment and rated this).

Posted on Jul 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Code Radio for grand Cherokee


We don't have these secure codes. Please go to this link and buy access, much cheaper than the dealer. www.radio-codes.com

Sep 21, 2016 | 2003 Jeep Grand Cherokee Limited

1 Answer

I have a 2003 Jeep Grand Cherokee Laredo. I went into a store and it was running fine when I parked it. I went to start it again and it acted like it didn't want to upshift into 2nd gear. Then it...


Check you transmission fluid. It sounds like a Torque Converter Lockup Solenoid problem though.

Also there was a Tech Support Bulletin related to the Torque Converter listed. Make sure you have taken your vehicle in to get it taken care of.

CUSTOMER SATISFACTION NOTIFICATION NO. C01 3/8" TORQUE CONVERTER DRAIN BACK VALVE
Issue Date: 01/2003

NHTSA Campaign ID number:
Potential number of units affected: 30,000
Model year(s): 2003
Manufactured: 10/15/2002 - 11/18/2002
Owner notification start date: January, 2003 Defect: 2003 models equipped with a 4.0L engine only.
Consequence: The torque converter drain back valve on affected vehicles may contain a check ball that swells. A swollen check ball will restrict fluid flow to the cooler and cause the transmission to overheat. This could cause transmission damage.
Solution: The torque converter drain back valve assembly must be replaced.

May 23, 2011 | 2002 Jeep Grand Cherokee

3 Answers

Need radio code for jeep RADIO s/n TQ1AA155927145


Unfortunately, these Chrysler codes are not available anywhere on the Net for free. However, you can get these codes from the serial number here. I have always found them cheap and reliable.

As yours is one of the older Chrysler radios you need to provide them with the part no. as well as the serial no. They will email the code right back to you on the same day and I can vouch for them as I use this site for units I repair that occassionally need a code.

Hope it helps. Thanks for using FixYa.

May 16, 2011 | 1999 Jeep Grand Cherokee

1 Answer

How do fix radio/cd code for Jeep 2003 model, battery went flat and code cleared


Try asking here for free advice as these Jeep codes can be hard to calculate

CLICK HERE

Feb 05, 2011 | 2003 Jeep Grand Cherokee

3 Answers

Radio code


Please take this to the dealer as the radio codes cannot be given without an ID and to check the vin against the radio for theft. sorry They will do it but you have to take it to them, it's for your own protection.

Apr 17, 2010 | 2001 Jeep Grand Cherokee

3 Answers

Radio code for 2001 jeep grand cherokee


hello who can help me please with my radio code for a Jeep??

info:

Part no P04858543AC-A

Date code 2609

Supplier 17719A

S/N TQ1AA2609A5016

please can you send me the code to > dr.joss@rambler.ru

thank you

Oct 04, 2009 | 1997 Jeep Grand Cherokee

4 Answers

Need Radio Security code. serial number TQAAA010712826


If your lucky the code may have been written on the back of the manuel. If not and may not have been set try 0000, and if that does not work and your good with the dealer they may help you reprogram the radio free of charge since they are always disconnecting batteries.
You could always log on to www.radio-code.com and they can help you unlock your radio.
Good luck and hope this helps.

May 29, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Need to know the physical size of a battery for a 1996 Cherokee.


Your Jeep Grand Cherokee uses a group 34 type battery. The sizes vary from manufacturer to manufacturer but, the standard size is 10 1/4 " x 6 13/16" x 7 7/8" or 260mm x 173mm x 200mm. Anything close should fit fine. Good luck. Please ask for help any time. Please rate me so I know how I'm doing. Thanks

Dec 30, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...