Question about Rover 200
Diesel leaking from rear of car around fuel tank somewhere
Posted by Anonymous on
Get car to garage put on ramp and steam clean tank.
Tanknmay have split
Posted on Jan 18, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: leaking brake line
I end to fix it on my way i bough universal brake steel tube and one connector and i disconnect from the rubber flex pipe and cut flash the old pipe one foot from front before fuel tank where old pipe still in good shape i put connector between old pipe and new pipe on back end i put regular universal tube fitting.
works good .
Posted on Aug 29, 2008
SOURCE: F-250 FUEL PROBLEM
Hi, My brothers 250 had the same problem and is now fixed.The fuel pump in each tank has a check valve that allows the fuel to run in one direction only. When this valve fails to close fuel runs into that tank when the other pump is running. We replaced the pump and all is well. Dan
Posted on Jan 25, 2009
there should be two straps holding the tank in place,,,,if you remove them the tank should drop down to where you can disconnect the feeder hose and go from there
Posted on Feb 20, 2009
SOURCE: Rover 200 overheating
Check the usual things: like a stuck thermostat, a slipping water pump belt and a clogged radiator. Then check that the cooling fans are turning on...they consist of a temp sensor, a relay and the fan motors. If all these are correct brace yourself for a blown head gasket. This is indicated by exhaust smell in the coolant and a lot of pressure in the cooling system.
Posted on Mar 22, 2009
The leaking from one tank to another was covered by a recall from Ford. Not sure if they still foot the bill for installation of the required check valves. These are still available from the dealership. The rear one is the hardest to install. The check valve can be installed without pulling the rear tank. As for your front sender I would clean all of the connections to the sender and make sure it has a decent ground. If it still only reads at the 1/4 tank level you will have to replace the sender to rectify the problem.
Posted on Jun 06, 2009
Tips for a great answer:
Jun 28, 2015 | Cars & Trucks
Mar 13, 2015 | Cars & Trucks
Dec 27, 2014 | Land Rover Cars & Trucks
Jan 09, 2011 | 2001 Land Rover Discovery Series II
May 31, 2010 | 2002 Land Rover Freelander
Oct 07, 2009 | 2003 Land Rover Freelander
Jun 09, 2009 | 1996 Land Rover Range Rover
Mar 10, 2009 | 2000 Land Rover Range Rover
Oct 11, 2008 | 1985 Toyota Land Cruiser
22 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: