Question about Pontiac Bonneville

Open Question

How do i add the 134a refrigerant to my 2000 bonneville ssei

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
co7196
  • 3433 Answers

SOURCE: I am trying to add 134a refrigerant to my 2000 VW

Are you on the suction line? Large fitting. Shake the can and warm it up. Do not overcharge. Make sure the A/C compressor is running.

Posted on Jul 10, 2009

Ad
  • 29 Answers

SOURCE: is a 95 bonneville ssei 3.8 supercharger the same

is it a series 2 or series 1 3800

Posted on Feb 05, 2010

samtoler
  • 666 Answers

SOURCE: where do i add 134a refrigerant in a 2003 kia

on the low side fitting, Follow a/c hoses, both will have fittings, some are marked with a blue cap. Remove cap and recharge at that point

Posted on Jun 12, 2010

Testimonial: "I have two yellow caps one marked h and l and i assume it is the l cap where i charge the unit."

  • 1 Answer

SOURCE: Serpentine belt diagram for a 2001 Pontiac Bonneville SSEI

these motors have two carrier pulleys and oone tensioner. lookinjg at the motor from the rightside of car the belt goes as follaws: crank pully to super charger from the left. the right side goes up to the lower carrier which will have the flat of the belt riding on it. from there the belt routes to the upper carrier
[ loop it over so the grooves ride
] and then under the tensioner any questions contact goldenvegasart@gmail.com

Posted on Aug 03, 2010

  • 1 Answer

SOURCE: fuse box diagram for 1998 pontaic bonneville SSEi

I have taken a picture of the fuse panel diagram and can send it to anyone if given an email address. Photo is to large to upload here and I don't know how to shrink it!

Posted on Jan 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My gas gage in my 2000 Bonneville ssei is all over the place. It reads full when it is empty and the faster I go the more it moves up..


The wire between the gauge and the tank is the problem. It may just be loose on the connector stud of the sender. or shorting to the body somewhere.

Mar 16, 2012 | 2000 Pontiac Bonneville

2 Answers

Looking for the PCM for a 2000 pontiac bonneville. please help. irritated and hot here.


The pcm or power control module is located on the drivers side of the engine.
The pcm relay is # 4 on the power distribution box in the engine compartment.
Also in the power distribution box in location # 6 is a 10amp mini-fuse for the
power train control. good luck!

Aug 04, 2011 | 2000 Pontiac Bonneville

1 Answer

2000 Chevy Malibu...Working on my AC replacing the compressor...What is the fluid capacity of the compressor/AC system on this vehicle...If I've added more than enough, how do I drain excess fluid to...


NEW AC COMPRESSOR POUR OUT SHIPPING OIL COME WITH IT ADD THEM SAME AMOUNT.IF YOU NOT SURE AND OIL BEEN POURED OUT.ADD 2 OUNCE R 134A REFRIGERANT OIL TO NEW COMPRESSOR. YOUR AC SYSTEM HOLD 1.75 LBS R 134A REFRIGERANT.

Jun 22, 2011 | 2000 Chevrolet Malibu

1 Answer

2000pontiac bonneville ssei wont blow cold air compressor on refrigerant ok


most likely the expansion valve on the evap coil under the dash on the passenger side is stuck. system will have to be evacuated to replace it.

Apr 16, 2011 | 2000 Pontiac Bonneville

2 Answers

Where is the oil pressure switch on a 2000 pontiac bonneville ssei located?


It is on the oil filter housing, let me verify that in the service manual. I will get back to you if it is not in that location

Jan 19, 2011 | 2000 Pontiac Bonneville

1 Answer

Bonneville air system


My GUESS is that a previous owner probably installed air shocks and the valve you refer to is for inflating them.

Oct 05, 2009 | 2000 Pontiac Bonneville

2 Answers

Pontiac Bonneville(2000) oil pressure sending unit


The oil pressure sending unit is located behind the oil filter, Threaded into an aluminunm housing. It has wiring that plugs into the sending unit. The oil filter has to be removed and you will need a deep well socket and a 6 inch extension. Change the oil and the sending unit together.

Jan 24, 2009 | 2000 Pontiac Bonneville

1 Answer

Brake pads and rotors on 2000 bonneville ssei


Try tapping the rotors on the edges with a heavy rubber mallet, they are probably just rusted on.

Jul 04, 2008 | 2000 Pontiac Bonneville

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...