Question about 2007 Hyundai Santa Fe Limited

Open Question

Wiring diagrams autozone

I have a 2009 Hyundai Santa Fe Ltd w/ 3.3L engine. A rodent has chewed up parts of the wiring harness for the ignition system and I need to replace parts of the wiring between the coil & the harness. These are not regular plug wires - these a 2 pin snap on connector that connects to each coil connected to each plug - any idea where I can find replacement with the connectors attached

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: 2001 hyundai santa fe 6

HI......
OK. just follow the number on the ignition coils.
And the number on the cylinders are.
The FIREWALL side are 1,3,5, Starting from the belts location.
The RADIATOR side are 2,4,6, Starting from the belts location.
The coil with number 1 go to cylinder 1. as the same way the rest of the coils and cylinders.

OK... I hope this solve your question .

THank you for use fixya.

Posted on Jul 25, 2008

Ad
  • 740 Answers

SOURCE: 2002 hyundai santa fe 2.7 multi misfire number 2and 5 cylinders

OK IS THERE IS ACTUALLY A mis-FIRE THIS VEHICLE SHOULD BE SHAKING DURING IDLE AND ACCELERATION IF IT IS, here is what you do get a noid light this used to check injector pulse. This vehicle will set a misfire code if injector is not functioning efficiently or bad. A noid light is like a test light bulb can be bought at almost any auto store.SART UP VEHICLE AND DISCONNECT THE INJECTOR WIRE TO THE CYLINDER THAT'S mis-FIRING AND CONNECT noid LIKE TO ELECTRICAL PLUG. DO THIS ONE CYLINDER AT A TIME. The nod light should have a steady flickering light/consistent pattern of flickering. If there is Gap/irratic flickering or no flickering BINGO you have found your problem. NO FLICKERING= bad/broken injector wire if not broken BAD COMPUTER/ECU. IF THE FLICKERING IS CONSISTENT /GOOD = BAD INJECTOR..replace injector and solve the misfire problem. However is all the components tested are ALL GOOD. Then the only other SOURCE for a mis-fire is the camshaft sensor that provides reference for injector pulse and the crankshaft sensor provide reference for Spark pulse. JUST ON A LAST NOTE: make sure all oils are getting electrical power to them. Good Luck I know this is alot of info at once. Contact me if you need more help. Thanks fr using FIX YA

Posted on Jan 08, 2009

232K7
  • 26 Answers

SOURCE: changing the tail light assembly on a 2004 hyundai santa fe

lift the tailgate, and you should see 2 screws on the side of the lamp assembly. remove the screws, and remove the lamp assembly by sliding it sideways away from the vehicle. you will be able to access the bulbs & sockets once the taillamp has been released.

Posted on Apr 14, 2009

  • 1 Answer

SOURCE: 2001 Hyundai Santa Fe Ignition coils & EGR Valve

Well I went ahead and took a go at changing the coils, plugs and wires yesterday. It literally took maybe 15 minutes and my hands didn't even get dirty. This is something that the auto place wanted to charge me 650 to do. I spent 200 on parts. I didn't realize the coils were the things sitting on top of the spark plugs. I think my 4 year old could've done it. All I had to do was unbolt the coils detach the wires and then replace. It was too simple.

Posted on Apr 18, 2009

ghost4548
  • 776 Answers

SOURCE: Access to tail light wiring harness plug

You have to remove the access panel on the interior side of the passenger compartment to access that connector.. it's a simple procedure after you see the wire harness and bulkhead boot.

Posted on May 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the pinout for this radio that was in a Hyundai Santa Fe 2005?


Do you need Wiring Diagram for hyundai santa fe.Or you need where the radio fits in hyundai santa.The connector of radio.
Please Check the link mentioned below it has all wiring diagram for hyundai santa fe radio.Also it has details for how to connect radio connector.
http://www.allcarhelp.com/2016/05/hyundai-santa-fe-radio-wiring-diagram.html

If you need anything else,please reply.
Thanks.

May 11, 2016 | Hyundai Cars & Trucks

1 Answer

4 cyl 2002 hyundai santa fe knock sensor


How do you know it's the sensor? my 20 yr old car different make complained via an engine light, the code said knock sensor several times. had issues with ignition wires fixed. Almost all sensors had corrosion at their connections. I cleaned to bright metal both sides and round toothpick then slide back and forth so that contact areas are mating properly. Not easy to change, Location, since DIYer and you will want one next time Repair manual from an auto parts store. Easy to refer to in the middle of repair.

May 09, 2015 | 2002 Hyundai Santa Fe

1 Answer

My 2004 Hyundai Santa Fe 3.5L Has a P0320 Code and the Tachometer has stopped working. What would I change out first?


P0320-is Ignition/Distributor engine speed input circuit. Inspect the wire harness and electrical plug ins in the area of the distributor. Replace the Ignition/Distributor engine speed sensor. This should clear up your Tachometer problem. Good Luck and happy new Year. From Ernie @ RedDeer, Alberta, Canada.

Dec 27, 2010 | 2004 Hyundai Santa Fe

1 Answer

Am getting a hyundai fault code of po501 from check engine light anylysis


Hi. P0501 means there is a problem with the Vehicle Speed Sensor. VSS is not sending data to the ECU. The ECM receives vehicle speed information from the right front wheel speed sensor, presuming your Santa Fe isn't equipped with ABS. Check the tone wheel on the axle and check the wiring going to the sensor, especially for being chewed by rodentia. These are far more common
problems than problems with the sensor itself.

All the best!

Nov 10, 2010 | 2004 Hyundai Santa Fe

1 Answer

2003 Hyundai Santa Fe. Driving about 10 minutes-stop at redlight and all dashboard lights come on and brakes feel locked. Have to restart ignition and then it's fine. Happened about a month ago as well....


Wiring harness runs along the left side of this vehicle between the engine compartment & the instrument panel junction box (left side under dash). damage may have occurred to this harness and no one found/noticed it.

Oct 08, 2009 | 2003 Hyundai Santa Fe

1 Answer

Hyundai santa fe 2004 how can i install two front seat,


2 bolts in each of the seats' floor rails... total of 8. Wire harness connectors may not be the same power seat control harness, seat heaters, etc. Research of connectors shows floor harness connectors are identical between 04 & 05. However, optional features like seat warmers in the wire harness of the 05 model may not exist in the other and vise versa.

Sep 03, 2009 | 2004 Hyundai Santa Fe

1 Answer

How to change blower motor in a 2003 hyundai santa fe


try these two websites www.alldatadiy.com and www.autozone.com and you should be able to get pictures and diagrams showing you how to repair your truck

Aug 02, 2009 | 2003 Hyundai Santa Fe

1 Answer

Are 08 hyundai santa fe and tucson desame stereo wiring harness?


NOPE! . Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Jun 29, 2009 | 2004 Hyundai Santa Fe

1 Answer

Hyundai santa fe 03 running problems


If your Santa Fe has a V6 engine 2.7L , it sounds like you have an ignition break down happening. You will need to renew all the ignition wires and check the two coils also for arcing .

Mar 28, 2009 | 2003 Hyundai Santa Fe

Not finding what you are looking for?
2007 Hyundai Santa Fe Limited Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...