Question about BMW X3 Series

Open Question

Why wont my doors lock bmw 335i 2008

Doors do not lock when run

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 109 Answers

SOURCE: Want to loacate the Brake Fluid reservoir on the BMW 335i Sedan

it should be under the hood on the drivers side up close to the fire wall

Posted on May 04, 2009

  • 1 Answer

SOURCE: battery dead to remote and cant open fuel door to

Their should be an emergency pull cord in the trunk top release the fuel door

Posted on Nov 09, 2009

rickyrt441
  • 4399 Answers

SOURCE: bmw 335i will not start

You need fuel, air, and fire to start a car. You need to make sure the engine is getting gas. Make sure the fuel pump works. Check the pump fuses/relays, and reset if equipped. If the engine is getting gas, check the timing belt.chain. Check your spark plugs/coils, coil pack, distributor, dist.cap, cam sensor, roter, cranks sensor. It could be anyone of these. That is why it is important to check for fire and fuel. Cancel out what works and narrow the choices. If you have any questions, just let me know.

Posted on Mar 06, 2011

  • 495 Answers

SOURCE: 335i bmw will not start

Could be quite a few things. If you have had to replace your car's battery or your key fob battery, you may have lost the sync between the key and the ignition
You can relearn or reprogram your key following the steps:
1. Get in your vehicle and shut the doors. Insert the key into the ignition and turn it to the "ON" position (without cranking). Hold it for two seconds, then turn the ignition off and remove the key.
2. Hold down the unlock button and quickly press the lock button three times.
3. Release the unlock button. The door locks will flash, signaling that the programming is complete.
4. Place the key in the ignition and toggle between "ON" and "OFF" to finalize.
NOTE: Please make sure this is completed quickly in order to for it to take effect!
If the above does not seem to work, please let me know if your key Rounded or Diamond shaped?

Posted on Mar 06, 2011

  • 29 Answers

SOURCE: bmw door lockremote wont lock/unlock doors and key wont fit doors to turn only

Key wont fit the door? Then the key you have is not the key for that car. Hence the remote will not unlock the car.

Posted on Jan 04, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 bmw 335i convertible top wont lock


more then likely due to faulty module, best bet is to bring to dealer to verify issues

Jan 12, 2017 | BMW Cars & Trucks

1 Answer

How to reset the low coolant light on a 2008 bmw 335i


use a diagnostic scanner or take to local dealer

Feb 21, 2015 | 2008 BMW 335i

1 Answer

Why would my 2007 bmw 335i showengine fault warning running on reduced power


Is your oil level or radiator coolant level low? It sounds like the engine is going into "Limp Home" mode to save the engine.

Aug 05, 2014 | 2007 BMW 335i Sedan

1 Answer

Bmw drivers door only wont lock/unlock with key fob


Could be your driver door lock mechanism that is going bad , since the other door are working, it cannot be the fob. I would try to change the driver side door latch mechanism.

Apr 02, 2014 | 2008 BMW 320i Automatic

1 Answer

What oil do i use in my bmw 335i


The best way to know for certain what kind of oil to use in your BMW is to check the driver's manual that came with the car.

Oct 18, 2012 | 2008 BMW 3 Series 335xi

1 Answer

How do i check the oil in my 2008 335xi?


On the upper left stalk next to the steering wheel, push the flipper up (or down) until "OIL" shows up in the display. Then press the BC button on the end of the same stalk. The oil level should be displayed.
I believe this model has no dipstick (my 2008 335i does not) so this is the only way to do it short of draining the oil and measuring it.

Aug 12, 2012 | 2007 BMW 335i Coupe

1 Answer

My 335i....actually a 2008 warning indicator gone haywire


There is an issue with the rear tail lamp bulb holders. BMW knows about this problem and released an updated part. Basically the bulb is not held tight enough, and occasinally loses contact with the holder. Your car should still be under warranty and any local BMW dealer should have the parts in stock.

Mar 22, 2009 | 2007 BMW 335i Coupe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

10 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...