Question about Cars & Trucks

1 Answer

Audi a4 19tdi replaced fuel pump n cylinder head,now won't start any advice

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

If it is the fuel injector pump you replaced you might have air in it. Modern pumps are self bleeding but you have to turn the engine over for a long time to get the air out.

Have you checked the timing when you put everything back?

Posted on May 08, 2014

  • nasheef May 08, 2014

    Thanx a mil

×

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2005 Audi A4 1.8 Fuel Pump problem?

I had an Audi A4, 10 years older than yours mind you, but it would start then stop, sometimes 10 times but would eventually go. I ran a little WD40 in the key barrel and put the key in and out a couple of dozen times. Wiping it with a cloth each time, lots of dirt came off. My theory and it's only mine, is that the wear on the key left dirty metal deposits inside which stopped the chip in the key being recognised. I believe they had a security chip inside the key.
Anyway after 6 months of this nuisance it never happened again after that. Fixed my problem and a lot of frustration. Maybe help you too.

Posted on Mar 03, 2010

tayjoejoe
  • 2185 Answers

SOURCE: silverado 02 won't start.

Is there a light on the dash that says SECURITY? These anti theft systems have been known to disable fuel.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Posted on May 15, 2011

  • 1 Answer

SOURCE: REPLACING AUDI 80 FUEL PUMP

how to remove fuel pump from the tank / cradle audi80 v6

Posted on Jul 07, 2011

eagletwo811
  • 2 Answers

SOURCE: engine cranks but won't start; how do I tell if fuel pump needs replacing?

take the gas cap off and have some one listen when the key is turned on and listen for a humming if it hums its working you might want to replace the crank sensor that's the most common reason for no start

Posted on Dec 20, 2011

Testimonial: "checked for the hum and nothing. Bought a new fuel pump, removed the old pump and installed new one along with a new strainer & fuel line filter. Works great now. Thanks! Btw...the pump is inside the fuel tank & you must remove the tank in order to remove the pump. This isn't too complicated but it takes some time, patience, & a little help."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Problems with audi a3


No idea without a play but i do know these engine do suffer from head gasket problems on no4 cylinder other than that i would need my head under the bonnet sorry for the indecisive answer

Jan 29, 2014 | 2004 Audi A3 2.0

1 Answer

Hi, I have just replaced the cylinder head on my pajero 2.8 diesel. It started first time and ran for about 4/5 mins then cut out. It is attempting to fire but won't.....any ideas would be grate


Keep pumping the hand bleed pump on top of the fuel filter to remove all the air. when started and still a bit lumpy keep pumping and it should clear itself

Dec 03, 2012 | Cars & Trucks

1 Answer

Audi A6 1996 V6 2.6 Petrol - Won't start and fuel pump is not coming on either.


try connecting pump direct to battery to see if pump works if it dose then a fuse or relay check all wire connections

Sep 02, 2012 | 1996 Audi A6

2 Answers

My 1997 ford tauras was running fine until the water pump went bad I changed the water pump and now car won't start it turns but won't start what could b the problem


Check for spark. If there is none take a peak at your work. The crank sensor is in that area and it is possible you damaged it when you replaced the water pump. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 19, 2012 | 1997 Ford Taurus

1 Answer

My Audi 500 SEL 1993 model is difficult to start - as if there is not enough fuel injected when the engine is cranked. Agents tell me that the injectors are leaking and needs replacement. I don't agree...


bad fuel, bad fuel pump, clogged fuel fiter, injectors or fuel fiter. If injectors are leaking at o-rings on rail or cylinder head your sucking in air and changing mixture ratio, computer can't compensate. Try all these things before proceding further... also when cold thew seals may be holding but when warmed up this is can be a very dangerous fire condition!

Sep 16, 2010 | 1993 Audi 100

2 Answers

White smoke from tailpipe, running poorly.


Blown head gasket for sure if its a petrol engine.

If its diesel then its overfuelling.

Jan 13, 2010 | 1994 Plymouth Voyager

1 Answer

Working on a 2000 Audi A8. Need info on changing


If it's anything like the six cylinder engines from Audi, which I'm very familiar with, and from what I remember of the V8, you have a timing belt that drives the water pump, crank, and exhaust cams, and also includes a tensioner and an idler roller. The timing chains come into play in the cylinder heads. What Audi did was to only drive the exhaust cams off of the crank, using the timing belt, and inside each cylinder head there is a timing chain assembly that is used to drive the intake cams off the exhaust cams. On a periodic service (like the timing service) you only need to do the timing belt. The timing chains are only replaced if the tensioners fail - you'll know this by a diesel-like clatter from the cylinder heads. Failure of the chain drive assemblies is very rare, which is good because they're incredibly expensive (on the V6 engines they're upwards of $700 each). If you're doing this job because it's due based on mileage, don't touch the timing chains in the cylinder heads - only change the timing belt, tensioner roller, relay arm, hydraulic tensioner, idler pulley, water pump, and serpentine belt. You can leave the chains alone.

Dec 01, 2009 | 2000 Audi A8

1 Answer

Audi 5000 Quattro S - just bought it, driven to property, was sitting for 3 years in Ariaona, won't start. Sparkplugs spark, but gas seems to not have much pressure at the fuel filter; other than the fuel...


if the fuel is getting past/through the filter and to the distributor head ,make sure all lines are on fuel pump inside tank ( access under floor inside trunk ) also see if the is fuel to the injector lines, undo a line and see ,check for fuel at the cold start injector.poor fuel pressure can be a pressure regulator issue ( small gey box attached to fuel dist head attached by 2 screws )

Nov 05, 2009 | 1985 Audi 5000 S

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...