Question about 2003 Volkswagen Golf

Open Question

Will the car start without the map sensor? - 2003 Volkswagen Golf

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have code PO107 after clearing it keeps coming back


The P0107 code is a bad MAP sensor circuit. Unless you replace the sensor, you can clear the code a million times, and it will come right back. And without that sensor, the engine will run rough, since the PCM has no idea how dense the air is to make adjustments to the fuel/air mix.

Oct 23, 2015 | Cars & Trucks

2 Answers

Hard starting, misfire & cut out when revved with MAP sensor connected


Hi Bernie, Im AL the owner of Big As Auto Repair

Bernie, this is hard to say without diagnosis, but I can tell you that 99% of the time when you unplug the MAP Sensor and it runs better, then its usually the MAP Sensor. If it should turn out that a new MAP doesn't fix it, then check for broken or frayed wires and check the connector for damage. Hope this helps and please visit my auto-repair website and check out my satisfied customer testimonials.

Jul 03, 2015 | Cars & Trucks

1 Answer

Citreon c2 vts rac codereader is po106 p 01/01 map/barc0 ckt range/performance fiited new map sensor still wont start


what does the scan tool show.??
? still P0106, and did you reset it?
did you try to start car with MAP disconnected, some do start in limphome mode. rich a a pig but starts.
did you have key off when you fiddled the MAP connector,
or better pull the battery neg, lug first?


lost power to the mAP, check the power pin.
lost ground to sensor.
lost vacuum to the sensor (clogged paths)
Bad MAP sensor Water/dirt intrusion affecting MAP sensor connector Intermittent open in the reference, ground, or signal wire for the MAP sensor Intermittent short in the reference, ground, or signal wire for the MAP sensor Ground problem due to corrosion causing intermittent signal problem A break in the flexible air intake duct between the MAF and the intake manifold Bad PCM
(do not assume the PCM is bad until you've exhausted all other possibilities)

May 23, 2014 | 2005 Citroen C2

1 Answer

Will the 2.9l ford motor start without the map sensor?


yes the engine will start without the map sensor

Aug 26, 2011 | Ford Bronco II Cars & Trucks

1 Answer

Stalling


I am dealing with the same issue. I have had the computer checks and there is nothing to indicate an issue.There were no computer error codes yet I stall at red lights.

The O2 sensor, the speed sensor or the MAP sensor may be one of the problems. The MAP sensor measure the air pressure in the manifold. It is commonly mounted on the fender and is low in cost and easy to replace. To test it if your if your car won't start, unplug the electrical connection from the MAP sensor. If it starts, then you know to replace the MAP sensor. The Hall Effect sensor can fail and not set an error code. This is an inespensive part that sits underneath the rotor in the distributor cap on cars without distributorless ignition. This only applies to cars made after 1996. Also check the fuel injectors and fuel filter.

If you have a burglar alarm, make sure that it is not causing the problem. It often times can cause the stalling issue.

Jul 18, 2009 | 1996 Dodge Stratus

1 Answer

1996 dodge stratus..keeps stalling out randomly..then starts up


I posted this response to a similar situation. I am dealing with it now and have narrowed it down to these issues...

The O2 sensor, the speed sensor or the MAP sensor may be one of the problems. The MAP sensor measure the air pressure in the manifold. It is commonly mounted on the fender and is low in cost and easy to replace. To test it if your if your car won't start, unplug the electrical connection from the MAP sensor. If it starts, then you know to replace the MAP sensor. The Hall Effect sensor can fail and not set an error code. This is an inespensive part that sits underneath the rotor in the distributor cap on cars without distributorless ignition. This only applies to cars made after 1996. Also check the fuel injectors and fuel filter.

If you have a burglar alarm, make sure that it is not causing the problem. It often times can cause the stalling issue.

I hope this helps!

Jun 30, 2009 | 1996 Dodge Stratus

1 Answer

Stalling and lagging


sounds elecrical try some eletronic parts cleaner and spray all the connections maybe the is a [wet] sensor which is hard to trace

Jun 10, 2009 | 1999 Saab 9-5

Not finding what you are looking for?
2003 Volkswagen Golf Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...