Question about 2007 Nissan Quest 3.5 Minivan

1 Answer

Why does my 07' quest down shifts hard at 20 mph

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Nissan Master
  • 1,449 Answers

It can be the cable on the throttle body needing adjustment .remember it is the cable from the gearbox.

Posted on May 08, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHY DOES MY 2003 JEEP WRANGLER 4.2 ENGINE AUTOMATIC TRANSMISSION CUT OUT RIGHT BEFORE IT SHIFTS GEARS


cut?
what does it do.
flare or slip
fail to up or down shift correct
shift to wrong gear say 2 to 4, or 2 to 1.?
are you just cruising when this happens
or only accelerating.
or?
did you scan to the PCM for DTC errors yet?
check fluid levels.
is engine overheating,?

Jul 05, 2016 | 2003 Jeep Wrangler

1 Answer

Why my 99 nissan quest radiator fan don't come on at idle or at stop in traffic and this cause overheating only work at low driving speed 20-30 mph


Your water temp sensor might be out of specs that means it sense only certain temperature to start your fan it is like a termoshtat

Jul 13, 2014 | 1999 Nissan Quest

1 Answer

Shifting hard from 1st to 2nd


Your transmission is computer controlled. The best way to find out why it is not shifting correctly is to scan your Powertrain Control Module (PCM) for possible fault codes. There are several Technical service bulletins (TSBs) published for your transmission. However, it is really necessary to retrieve fault codes to correctly determine which of these may or may not apply to your particular problem.
One bulletin that stands out in my mind is Technical Service Bulletin Number 07-07-30-024, which addresses hard/delayed 1-2 shifts and involves reconditioning of the valve body. But once again, it also addresses specific fault codes.

Nov 18, 2011 | 1999 Chevrolet Tahoe

1 Answer

My 07 camry sounds like it is not shifting


is this a 4cyl or V6...how many miles??sounds like the transmission isn't shifting to lower gears....is there any warning lights lit on your dash??

Apr 22, 2010 | 2007 Toyota Camry

2 Answers

2009 kia optima lx - hard downshift @ 20 mph everytime.


THE VEHICLE IS UNDER WARRANTY.
TAKE TO THE DEALER AND ROAD TEST WITH A TECH.
I WORK AT A FORD DEALER AND THERE ARE SEVERAL TSB'S TO RESOLVE SHIFT CONCERNS THROUGH SOFTWARE CHANGES AND SHIFT STRATEGY UPDATES.
KIA MAY HAVE SIMILAR ISSUES.

Jan 12, 2010 | 2008 Kia Optima

2 Answers

Hi I have a 96 nissan quest xe my problem is my car revs high before going to the next gear around 20 mph then it fine until I come to a stop and starts all over again also the check engine light stays on...


It is possible that the fluid level is low. If so then fill it because this will cause the transmission to slip. The next step is to change the fluid and filter. Hope this helps. Good luck.

Nov 19, 2009 | 1996 Nissan Quest

1 Answer

Monitor Reset


The following conditions must occur to complete a Trip and test all OBD II monitors and components including the Catalyst Efficiency Monitor:
-- The misfire, comprehensive component, and adaptive fuel monitors are checked continuously from engine warm-up and can complete any time.
-- The exhaust gas recirculation (EGR) monitor test requires a series of idles and accelerations.
-- The heated oxygen sensor (HO2S) monitor requires a steady speed drive for approximately 1 minute at 30 to 40 mph.
-- The catalyst efficiency monitor requires a steady speed drive for 1 minute and 20 seconds beyond the HO2S monitor test at 40 to 65 mph.
If you cut engine off before test are completed then you must wait for a 6 hour cool down before monitors will run again.

Feb 06, 2009 | 1996 Nissan Quest

2 Answers

2004 nissan quest idles rough when van is stopped


Have 2004 Nissan Quest. After 40 mph Van runs rough and there is a loud rattleing noise that sounds like an old 4 bbl carb waaaah, but ther is no code

Aug 14, 2008 | 2004 Nissan Quest

Not finding what you are looking for?
2007 Nissan Quest 3.5 Minivan Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...