Question about 2000 Chevrolet Monte Carlo

1 Answer

2000 Monte Carlo

What is the length of the right rear brake line?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 61 Answers

Is the metal line or the rubber line leaking? if its the rubber hose just get a new one at the local parts store they are specific to your vehicle.
if its the metal line buy a roll of tubing if you want to replace the whole line dont forget the correct fittings. if you just want to repair a section get a piece of line apx 2 ft longer then the section you want to repair with the correct fittings and that will cover it. Best repair replace the whole line do not patch or will end up repairing it again down the road.

Posted on May 16, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I recently replaced a rear brake line on my 85 ss monte carlo. I went to bleed the line and nothing came out. I attempted to bleed the other side and no fluid came out. When I replaced the line fluid did...


It should not be a mystery. Loosen one of the fittings on your new line to see if brake fluid is present. If so, the problem lies downstream from that point! Good luck!

Oct 23, 2014 | 1985 Chevrolet Monte Carlo

1 Answer

Brake Line


Only a dealer may have the length, you should remove the affected part and take it to a shop where they will make an exact copy for you. If it's broken take all pieces.

May 08, 2014 | 2000 Chevrolet Monte Carlo

1 Answer

Bleed rear brakes on a 1979 monte carlo


It should be the same as any other car, you find the bolt on the brake pad or drum that connects the line to the system (it will look like a nipple) then loosen it,. This is a lot easier if you have another person. You have the second person push down on the brake peddle three quick times and then slowly push it in until brake fluid squirts out from the bolt. Then tighten the bolt back up and repeat for all brakes. Note: you may need to put in more brake fluid when your done and the process may need to be repeated it all the air doesn't come out of the lines.

Dec 04, 2013 | Chevrolet Cars & Trucks

1 Answer

2000 Monte Carlo Right rear strut needs to be replaced. Do both rear struts need replacing.Is it DIY or garage job? Cost? Thanks


you tube clips can help you replace rear struts.i would replace both struts same time and call auto parts for struts prices.

Sep 23, 2013 | 2000 Chevrolet Monte Carlo

1 Answer

I am looking to find the steel front brake lines for a 1999 monte carlo



  • If you have any comments then you can feel free to leave them here.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Aug 17, 2011 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Front sway bar on a 2000 monte carlo


Be very carefull because there are lines and wires that can be broken if the engine is lowered too far. Disconect the battery. Set the parking brake and chock the rear tire.
Put the car on jack stands and take off one of the tires. Put the jack under the rear of the engine cradle. You have to loosen the steering column set screw at the steering rack and loosen the two front bolts that hold the engine cradle to the chassis. Take the two rear cradle bolts almost all the way off and lower the cradle until you can wiggle the sway bar out. The steering will disconnect.
Reverse the procedure to put everything back where it belongs. The steering shaft is a "D" shape so it only goes on the rack one way. Tighten the set screw and torque the engine cradle to the required specification. 133 ft. lb.
IMPORTANT -- Take the car to an alignment shop and have at least the front aligned. The front suspension is attached to the cradle and can be moved out of alignment.
Complete instructions are found in Haynes Manual p/n 24048, chapter 10.

Nov 06, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

200 monte carlo problem


your emergency breck swtich which control with hand breck is faulty, Ist check it. if its ok, than check wire of swtich is short with body, it is midle of both front seats

Sep 21, 2009 | 2000 Chevrolet Monte Carlo

2 Answers

1998 Chevrolet Monte Carlo brake lights do not


check blubs if the center light works should be working side brake lights

Sep 07, 2009 | 1998 Chevrolet Monte Carlo

1 Answer

2000 monte carlo / noise from rear wheels


That's what it sounds like to me also. I would put the rear up on jack stands and spin the wheels to male shure wich side it is. Don't forget to block the front wheels for safety as you will not be able to set your e- brake for this test.

Aug 27, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

I have a bad ground wire somwhere on my 2000 monte carlo ss, where are the ground wires located?


G100
Battery cable, negative cable, RH side of engine compartment to the RH frame rail
G101
Left side of the radiator support
G111
Top right of the engine, below the ignition control module
G113
Lower LF of the engine, on the automatic transaxle stud, near the starter
G151
On the left frame rail, forward of the left front strut tower
G171
On the left frame rail, right of the left front strut tower, rear of G151
G201
Behind the I/P, on the LH side of the brake pedal bracket
G202
Behind the I/P, in the center
G203
Behind the I/P in the RH side of the brake pedal bracket
G301
At the base of the LH B-pillar
G302
At the base of the RH B-pillar
G309
On the RH side B-pillar

Aug 11, 2009 | 2000 Chevrolet Monte Carlo

Not finding what you are looking for?
2000 Chevrolet Monte Carlo Logo

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...