Question about Nissan Primera
When pulling up at traffic lights, engine stops, but restarts straight away on key
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
i recently experienced the same issue. it can be your tensioner pulley or your water pump see the belts are connected to the pulleys and sometimes get worn out and need to be replaced. especially on a older car see a mecanic
Posted on Jan 31, 2009
A reason for hard shifting could be a problem with many things with various degrees of seriousness. It could be your ATF( automatic transmission fluid) is low or broken down and old. This would cause the hardness and the reason for stop and go traffic effecting it. Another possibility is your transmission is just shot, and the timing gears inside are worn and not properly shifting at the correct RPM causing a **** during shifting.
Some possibilties, not all!
Posted on Mar 27, 2009
SOURCE: The engine shut down while on stop and go traffic. Tried to restart but the throttle was weak and shut down again. After shutting everything down for 5 minutes, restarted the engine. The throttle w
If the car is having trouble maintaining idle (the tach dips and car dies) the common causes are the idle control valve and camshaft position sensors. The cam sensors failing will be indicated by a check engine light.
The ICV can removed and cleaned with good results (I think there is a write up on bimmerfest) or purchased new for about $100.
While you are in there check the intake boot that is Y shaped for cracks, it's prone to fail and will mess up your idle too.
read up on the major forums and you'll get more info
Posted on May 18, 2009
How does it idle when you first start or idle when hot.
On the top of the air intake tube there is a small screw which should when screwed in speed up the idle and if it dosent work or it idles fine when cold or warm at idle then its your GEARs are binding up and there's not to much you can do about that ........sorry
Posted on Oct 16, 2009
SOURCE: engine dies in stop and
1999 300M 150,000 Miles
Car dies when coming off acceleration or at idle in traffic or at a stop. I can watch the Tach go to 0 RPM, some times it will restart immediately other times it is hard to start, so far I have always been able to re-start it and Drive on. Does anybody have verified fix for this issue, I have seen posts saying can and crank sensor, throttle body, EGR, and many more ideas... Do not really want to just start replacing parts with the hope that I eventually get a fix. Help...
Posted on Oct 14, 2010
Tips for a great answer:
Dec 27, 2017 | Nissan Cars & Trucks
Mar 08, 2013 | Nissan Cars & Trucks
Sep 08, 2012 | 1999 Nissan Pathfinder
Aug 21, 2017 | 2005 Ford Escape
Jan 27, 2011 | 2002 Jeep Liberty
Feb 05, 2010 | 2005 Nissan Maxima
May 10, 2009 | 2001 BMW 325
Jul 25, 2008 | Chrysler Concorde Cars & Trucks
27 people viewed this question
Usually answered in minutes!