Question about 2002 Chrysler Sebring

Open Question

2001 sebring timing belt oil light - 2002 Chrysler Sebring

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Audioaholic
  • 376 Answers

SOURCE: 2004 sebring 143k miles stalls

well if the belt was installed one tooth off, that will surely make this problem relavent, have a mechanic scan the computer and check to see if the sensor values are within range, it might have a few bad sensors for the induction (air / fuel). also try cleaning out the throtlebody, and IAC
(Idle Air Control) sensor and port. but this problem could be anything from ignition to induction, and/ or the timming /Belt.

Posted on Jan 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When should I change my timing chain or belt on a 1997 sebring xji


change timing chain when noisy and belt around 100.000klm. To do a proper job consider changing cam and crank oil seals. hydraulic belt tensioner and all idler pulleys as oil is the biggest killer of timing belts and idlers work just as hard as the belt

Jan 26, 2013 | 1997 Chrysler Sebring

1 Answer

I have a 2004 Chrysler Sebring, the timing belt broke, had it replaced, when i got the car back th oil light was on and would go off for a few seconds then come back on, and now it stays on all the time....


Sounds like bad oil pressure switch. Is the engine making any loud noise(s)? I'd replace oil pressure switch and/or check connection at oil pressure switch.

Apr 21, 2011 | 2004 Chrysler Sebring

1 Answer

I have a 2005 chrysler sebring and the oil light started blinkiing and it felt like the car would cut off, then it started sputtring along each time i press the gas. I put three quarts of oil in it and the...


I don't think it's an oil related problem. Anytime car wants to stall dash lights (oil light etc,) will come on. Similar to when first starting. I would look into fuel filter and ignition issues as your source of problem. When was last "healthy" Tune up? (spark plug replacement,filters,hoses, belts) I'd give a healthy service and use that as a "ground zero" starting point.

Jan 05, 2011 | 2001 Chrysler Sebring

2 Answers

I have changed the timing belt on my 2002 Chrysler Sebring LXI coupe and the car runs great when it stays running. When I shut the car off and start it back up it just starts and dies but if i unhook the...


Check the throttle plates and idle speed control motor make sure there both clean.

Also check manifold vacuum at idle the best you can hold an idle. I have run into timing belt being one tooth off and engine still ran fine. But the vacuum was low that's how I could tell the belt was a tooth off.

Oct 27, 2010 | 2001 Chrysler Sebring

1 Answer

Replace water pump on 2001 chrysler sebring


if you have the 2.4 engine, the water pump is external and driven by the timing belt.you need a water pump - timing belt component kit. the 2.7 has a internal water pump driven by the timing chain. here again you should install a water pump- timing kit. 2.7 is more complex and expensive to change

Oct 07, 2010 | 2001 Chrysler Sebring

2 Answers

Oil preasure light comes on


Your oil sensor may be faulty, or your may have a leak since you said the fluid level is okay.

Sep 23, 2009 | 2001 Chrysler Sebring

1 Answer

2001 Chrysler Sebring- difficulty steering,


the belt will be on the front pulley on the power steering pump

Apr 22, 2009 | 2001 Chrysler Sebring

1 Answer

Oil presure light comes on after diving for a while, at stop sign


without confirming oil pressure,(not level)are within normal specs,I would replace the oil pressure switch,If you need the location let me know. DB

Feb 01, 2009 | 2001 Chrysler Sebring

1 Answer

Oil light keeps coming on


normally when you have this problem it is the oil sending unit is sticking and it is normally located near the oil filter

Jan 22, 2009 | 2001 Chrysler Sebring

Not finding what you are looking for?
2002 Chrysler Sebring Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...