Question about Cars & Trucks

Open Question

I need step by step on how to remove fuel cap for fuel on my crown victoria?

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

reisdos
  • 1297 Answers

SOURCE: fuse diagram for 2000 crown victoria

there are 5+ pages of fuses what specifically do you need


Posted on Jul 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you depressurize the CFI on 85 Crown Victoria LTD?


1. Start engine
2. allow to idle
3. remove fuel pump fuse while engine running
4. with fuse still removed restart 1-3 more times to clear any fuel from system.
System D/P'd.

May 06, 2014 | 1989 Ford Crown Victoria

1 Answer

Does a 1996 crown victoria have a fuel pump reset switch?....and if it does where is it located??


To answer your question about the fuel pump switch...yes. The location of the fuel pump cut off switch is typically located in the upper left corner of the trunk. You may need to pull the carpet down a bit to access it. If it is not in the upper left corner, then it is probably on the right. Usually, the switch is located on the side of vehicle where the fuel filler cap is. Once you locate the switch, press down on the button...you should either feel or hear a "click".

Nov 06, 2010 | 1996 Ford Crown Victoria

1 Answer

Replace 2004 Crown Victoria headlight


From the engine compartment, unlock the 3 tabs that are over the headlight housing area. Remove the cover and unscrew the plastic ring that has the wires protruding from it. Carefully pulls the light fixture out of the housing. Pull the 2 L-shaped tabs up and remove the lens section. Reverse the steps to re-install the headlight. If replacing the full turn signal housing, unscrew 2 screws from each light , disconnect bulb wiring and remove. Replace accordingly.

Jul 23, 2010 | 2003 Ford Crown Victoria

1 Answer

My 1985 crown victoria has been sitting for 10 years and I need to get bad gas out of the tank


BEST TO USE A HAND SIPHON TO REMOVE GAS FROM FUEL TANK REMOVE FUEL TANK..THEN CAREFULLY WASH OUT SEDIMENT IN THE BOTTOM OF FUEL TANK.

Jun 22, 2010 | 1985 Ford Crown Victoria

1 Answer

How to remove a fuel pump from a 99 crown victoria


first things first! disconnect battery! lift rear of car ! use jack stands ! just behind the rear AKA AXL DISCONNECT FUEL LINE WITH FOR TOOL ! HAMMER AND SCREW DRIVER look at the ring that holds the sender in to the tank! it only comes off one way! becareful ! fuel will pour out! once u have the sender out replace pump and reverse steps! if this helped please leave feed back!

Apr 16, 2010 | 1999 Ford Crown Victoria

1 Answer

How to change a fuel pump on 1998 ford crown


you have to remove the fuel tank- it is located inside the tank

Feb 16, 2010 | 1998 Ford Crown Victoria

1 Answer

I have a fuel system failue on a 2001 ford crown


I'm assuming you already checked for fuel pressure. If not this is your first step.

You need to find out if you have power at the fuel pump. If not you may of popped a fuse or relay . Then you need to find out if you have a ground when the key is cycled on. If you dont you may have a open wire to the computer or a bad computer. Most likely your problem is a bad fuel pump but its just a guess.

Sep 20, 2009 | 2001 Ford Crown Victoria

1 Answer

Engine does not start immediately when cranking


The problem could be many things. Is the engine light on? Check for proper fuel pressure. Remove one spark plug and inspect. Your vehicle may just need a simple tune up. Spark plugs,distributor cap and rotor,fuel filter.

Jul 26, 2009 | 1991 Ford LTD Crown Victoria

1 Answer

94 CROWN VICTORIA FUEL PUMP


Yes you can replace it. It is in the fuel tank. You will need to drain the tank and remove it to gain access to the fuel pump. A floor jack will help when lowering the fuel tank. If you fo to a dealer to do this you will be looking probably around $700.00 to replace the pump.

Feb 17, 2009 | 1994 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...