Question about 2005 Pontiac G6
How to replace rear coil springs on a g6
You will to support the rear lower control arm, remove the through bolt to the spindle, and the bolt at the rear cradle for the control arm, then lower the arm and the spring should come out.
Posted on Jun 06, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Here are the radio wire colors of the whole system, please rate this solution.
2007 Pontiac G6 Car Radio Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Red/White
Car Radio Accessory Switched 12v+ Wire: The radio harness does not provide a switched power source. Run a wire to the fusebox for switched power or use the brown wire (+) at the ignition wire harness.
Car Radio Ground Wire: Black/White
Car Radio Illumination Wire: Pink
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue
Posted on Jan 06, 2009
comes out of bottom. You need to remove the bottom cover. Then there is two radiator support brackets that need to be removed. Don't forget to remove the AC condenser bolts then lower it on down. Probably gonna take u a few hours to replace.
Posted on Apr 15, 2009
Remove the brake caliper
Remove the disc, (rotor)
Remove the 34mm nut on the axel shaft
Remove the three (3) bolts from the back side
You will need a wheel puller (three jaw will work well)
Place the puller over the hub and tighten, this will push the shaft out of the hub. Now you have to pull the hub assy. out of the mounting bracket. I found hitting each side,of the hub with a lead hammer to work well. Don't forget to disconnect the ABS senser on the back side of the hub assy.
Do not over tighten the 34mm axel nut when you install the new assy. If you use an impact whrench on it you will damage the bearing.
Posted on May 03, 2009
its probally a haligen bulb needs replaced from the inside under the hood that twists in the back of the light just half a turn the unplug old and put in new
Posted on May 31, 2009
some G6 do not have power streeing pumps
they have ELECTRIC POWER STEERING
all depends on the engine
2.2 4cylinder have electric
3.5V6 can have one or the other
if you have a V6 then you will see the power steering cap through the engine cover on the right side if it has hydralic power steering
Posted on Dec 24, 2009
Tips for a great answer:
Sep 22, 2015 | 2001 Pontiac Montana
Aug 04, 2014 | 2005 Pontiac G6
Jul 18, 2014 | 2006 Pontiac G6
May 07, 2014 | 1999 Mercury Mountaineer
Jul 24, 2012 | 2005 Pontiac G6
Oct 29, 2010 | 2005 Pontiac G6
Jul 03, 2010 | 2005 Pontiac G6
Jan 22, 2009 | 2005 Pontiac G6
229 people viewed this question
Usually answered in minutes!