Need torque specs for connecting rods sebring

SOURCE: main and rod bearing torque specs

do you have a Haynes Manual or Chilton? if not check your local library, they may have one, the specs are in there

SOURCE: need the crankshaft main bearing torque specs and

Hello tlittle3: My name is Roger and I will help you.See the attached image. Be sure to follow steps as it is very inportant. You will notice that you need to index some of the bolts. That is merely turning the bolt a specified degree. The crankshaft tie bolts are the bolts that are in the side of the block. install horizontal. Shold you need further help please just ask. Please rate the answer you received. Thank You for using Fix Ya. Roger

Testimonial: "thanks that what i needed"

SOURCE: torque specs for cylinder head on a 200 ford focus

1. CAUTION: Always install new cylinder head bolts. NOTE: Lubricate the cylinder head bolts with Super Premium 5W 30 SAE X0-5W 30-QSP or equivalent meeting Ford specification WSS-M2C153-G prior to installation. Install the cylinder head assembly and tighten the cylinder head bolts in the following sequence.

1. Tighten all bolts in a single sequence to 50 Nm
2. Back the bolts off 1/2 turn.
3. Tighten the bolts in sequence shown to 50 Nm .
4. Rotate all the bolts in a single sequence an additional 180 degrees in two steps of 90 degrees each.

SOURCE: i need torque specs for a 2004 dodge cummins 24

http://www.dieseltruckresource.com/dev/index.php

I suggest this website for your dodge truck needs.

ZJ Limited

• 17989 Answers
• Posted on Oct 11, 2010

SOURCE: need the torque specs for

Fig. Intake manifold bolt torque sequence 2.7L engine

Upper intake manifold with a new gasket on the lower intake manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm)

Hope helps (remember to rate this answer). Good job.