Question about 2007 Volkswagen Transporter 1.9

Open Question

Bleeding fuel system on vw lt 35 ? - 2007 Volkswagen Transporter 1.9

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: Engine torque settings VW lt 35 1993 2.4 turbo diesel. Code ACL

bob go to collsionrepairadvice.com and I will send the download to you its a big file

Posted on Mar 13, 2009

  • 1 Answer

SOURCE: vw lt 35 manual

how to get glow plugs out
from a lt35

Posted on Dec 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

VW GOLF 02 V5, the car drove fine until I turned the engine off for 10 mins and tried to re- start it. It fired up and then conked out, on opening the bonnet the panels were extremely hot.


This problem is usually caused by a intake Vacuum leak ,Check the hard tube coming out of the brake booster for cracks. MAFs are known to fail on them.

Sep 29, 2016 | 2002 Volkswagen Golf

1 Answer

I need the map of the fuses on a VW LT35 van 2003 plate


it should be listed in the manuel and inside the lid to the fuse box

Oct 31, 2014 | Cars & Trucks

1 Answer

Preheat light flashes


You sure had a misfire and the error light lightup, next time you take it to service ask them to clean the error

Oct 14, 2013 | Volkswagen Cars & Trucks

1 Answer

How do you bleed the fuel lines on 2000 vw jetta vr6


The system is self bleeding, just hold the gas pedal to the floor and crank it over for 5 seconds at a time until it starts. Make sure you have at least 3 gallons in the tank to properly prime the fuel pump.

Jul 16, 2012 | Cars & Trucks

1 Answer

Rear brake line was removed and now i need to bleed the system 1997 chevy blazer any special tools needed ?


you need a 1/4 or 5/16" wrench and procedure requires bleeding all corners staring with furthest away from master cylinder working your way closer (Rt Rr, Lt Rr, Rt Frt, Lt Frt)

Mar 02, 2011 | 1997 Chevrolet Blazer

1 Answer

How many psi is the in the fuel line of a 1996 jetta 1.9L turbo diesel


fuel system of different brand are slightly and has fuel pressure specification and requirements unique to the system. vw jetta '96 has 35 to 40 psi running. if has to much pressure,check the regulator. and if has low or not enough pressure,change fuel filter before going after the fuel pump.

Jan 05, 2011 | 1996 Volkswagen Jetta

1 Answer

What special tools do I need to remove the fuel tank from my 04 F250 for cleaning ?


Anyone special tool, just check this procedure to Removal & Installation
CAUTION Fuel injection systems remain under pressure, even after the engine has been turned OFF. The fuel system pressure must be relieved before disconnecting any fuel lines. Failure to do so may result in fire and/or personal injury.
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:
    Negative battery cable Fuel pressure Fuel tank skid plate bolts and lower the skid plate. Fuel Fuel tank filler pipe hose from the tank Fuel tank filler pipe vent hose from the tank Fuel lines from the fuel pump Front fuel tank connections Rear Evaporative Emissions (EVAP) hose clamp and the hose Electrical connector from the fuel pump

  3. Support the fuel tank with a jack.
    Fuel tank support strap bolts and the fuel tank straps Fuel tank
To install:
  1. Installation is the reverse of removal. Note the following torques:
    1. Tighten the fuel tank strap bolts to:
      F-150: 35 ft. lbs. (47 Nm) F-250 and F-350 mid-ships tank: 30 ft. lbs. (40 Nm) F-250 and F-350 aft-of-axle tank: 66 ft. lbs. (90 Nm) Mark LT: 35 ft. lbs. (47 Nm)
  2. Tighten the skid plate bolts to:
    F-150: 15 ft. lbs. (20 Nm) F-250 and F-350 mid-ships tank shield: 15 ft. lbs. (20 Nm) F-250 and F-350 aft-of-axle tank cover: 66 ft. lbs. (90 Nm) Mark LT: 15 ft. lbs. (20 Nm)
  3. Connect the negative battery cable.

Hope helps.

Dec 24, 2010 | 2004 Ford F250

1 Answer

Vw lt 35 manual


how to get glow plugs out
from a lt35

Jul 03, 2009 | Volkswagen Eurovan Cars & Trucks

1 Answer

91 vw jetta diesel ran out of fuel


At the rear of the injection pump there are four lines, each goes to an injector. loosen the flare nut at just one injector. crank the engine over until you see fuel spitting out. Close the fuel line,vehicle should be running. If not then its something else check the fuel filter, fuel shut-off, and check for any fuel leaks.

Apr 26, 2009 | 1991 Volkswagen Jetta

1 Answer

Engine torque settings VW lt 35 1993 2.4 turbo diesel. Code ACL


bob go to collsionrepairadvice.com and I will send the download to you its a big file

Mar 13, 2009 | 2000 Volkswagen Jetta TDI

Not finding what you are looking for?
2007 Volkswagen Transporter 1.9 Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...