Question about Cars & Trucks

1 Answer

I have a 1991 isuzu mu the electric tailgate button doesn't work and the hand break light stopped working is there a fuse or relay

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Habit-Forming:

    Visited the website for 3 consecutive days.

  • Expert
  • 98 Answers

Yes the fuse box is located under the steering wheel to the right check that out first. then if that is the case replace and it blows again you will have to check why it is blowing the fuse it is indicating a further problem ahead

Posted on Jun 18, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 28 Answers

SOURCE: I can't find the heater fan relay on my 1991 Honda Accord EX 4 dt

you mean the cooling fan? for the rad the relay is under the hood by the battery in the fuse and relay box

Posted on Feb 19, 2009

  • 18 Answers

SOURCE: 1991 toy 4runner, tailgate window wont go up/down

sorry to tell you but the rubber4 in the tail gate motor gear always packs it in the covers need to be removede and motor replaced ,actually if i remember correctly i think the left rear window motor will fitt straight in

Posted on May 17, 2009

  • 580 Answers

SOURCE: No power to electric windows and interior courtesy lights

This is a common problem, but I've never seen a window regulator go bad in a Mercedes, the problem is probably the switch, you can check his by removing both working and nonworking window switches from the console, and plug in the other side or rear to roll the windows up/down,you will need to disassemble the switch that does not work and clean it well then, it will work again I've done it to my Mercedes

Posted on Jul 15, 2009

Testimonial: "Helps a bit, will be checking switch out, Thanks"

  • 133 Answers

SOURCE: 1991 honda accord dash board lights not working.

CHECK THE FUES BOX UNDER THE DASH BOARD ON THE DRIVERS SIDE.
THOSE LIGHTS ARE COMMONLY ON THE SAME FUSE

Posted on Nov 25, 2009

pugwash814
  • 377 Answers

SOURCE: Jaguar xJ6 X300 The electric seat has stopped

the motors stick ( freeze ) i have heard that disconect the battery for an hour helps with this,and you may need to reprogram everything after..

Open the boot lid and drivers door, and switch on the ignition. Rock the valet switch, in the centre console, 5 times. The system will chirp to indicate it has entered learning mode.

On models with seat/mirror/steering wheel memory functions, the first remote will be linked to memory 1, second to memory 2 etc.

Press the larger, lock, button of the remote. The system will chirp to confirm it has got the signal. If it doesn't receive any signals for 15 seconds, it will chirp twice and exit learn mode.

To programme further remotes, rock the valet switch once. The system will chirp twice for remote number two, three times for number three etc, then press the lock button of the remote as above.

When finish, wait 15 seconds for the system to time out and chirp twice, turn off the ignition, close the doors and boot lid and the job is done!

Posted on Mar 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ac fuse on a 1987 isuzu trooper2


this should be similar to the isuzu mu/big horn 2.8l diesel?
in which case it's in the fuse box (along with other fuses) in the engine bay on the left hand side from the drivers seat.

Aug 02, 2016 | Isuzu Cars & Trucks

1 Answer

All lights working except parking lights, all fuses and relays are good help


I would check , clean & tighten all the grounds you can find first, a bad ground can cause all kinds of wierd electrical issues.

Dec 20, 2012 | 1991 Isuzu Pickup

1 Answer

The ac on my Isuzu box truck doesn't work it blows


where is the low side fitting on a 2005 isuzu box truck i need to charge ac

May 12, 2012 | 2007 Isuzu MU-7

1 Answer

Hi there, i have a 1991 Izuzu mu, 2.8 turbo. Everytime i turn the key on the glowlight or glowplug fuse keeps blowing. Its on the inside of the car not the bigger one under the bonnet?


There will be a relay that switches the power to the glowplugs on and off, probably mounted in the fuse/relay box near the big fuse under the bonnet. Check this relay and associated wiring for a short circuit to ground

Feb 28, 2011 | Isuzu MU-7 Cars & Trucks

2 Answers

1993 rodeo not running no power to fuel pump


if there is no power to the fuel pump check relays and fuses....UNDERHOOD FUSE & RELAY PANEL IDENTIFICATION Fig. 2: Underhood Fuse & Relay Panel Identification Courtesy of ISUZU MOTOR CO. Fusible Link Identification ? A - 80 Amp (1991-92 3.1L) ? A - 60 Amp Main-1 ? B - 30 Amp Main-2 ? C - 30 Amp (1993-94) ECM (3.2L) ? D - 30 Amp Condenser Fan (A/T Models) Relay Identification ? 1 - Headlight Relay ? 2 - A/C - Heater Relay ? 3 - Starter Relay ? 4 - A/C Compressor Relay ? 5 - Charge Relay ? 6 - Fuel Pump Relay ? 7 - ECM Relay ? 8 - Wiper Relay Fuse & Circuit Breaker Identification ? 1 - 15 Amp (1991) ECM, Fuel Injection System ? 1 - 15 Amp (1992-94 2.6L) ECM, Fuel Injection System ? 1 - 10 Amp (1992-94 3.1 & 3.2L) Heated Oxygen Sensor, Fuel Injection System ? 2 - 20 Amp (1991-92) Fuel Pump ? 2 - 20 Amp (1993-94 2.6L) Fuel Pump ? 2 - 15 Amp (1993-94 3.2L) Fuel Pump ? 3 - 10 Amp (1991) ? 3 - 15 Amp (1992-94) Turn Signal Lights, Hazard Warning Flasher Lights ? 4 - 10 Amp Horn, Door Locks ? 5 - Not Used (1991 3.1L) ? 5 - 10 Amp Charging System, Charge Warning Light WARNING: Always disconnect battery ground cable before servicing "high- current fuses. It is recommended that "high-current" fuses be replaced by a qualified technician. Page 1 of 2 FUSES & CIRCUIT BREAKERS -1994 Isuzu Rodeo LS? 6 - Not Used (1991) (1992-93 2.6L) ? 6 - 10 Amp (1992-94 3.1L & 3.2L) A/T Interlock System ? 6 - 10 Amp (1994 2.6L) Heated Oxygen Sensor, Fuel Injection System ? 7 - 20 Amp Heater/Air Conditioning Blower Controls ? 8 - 10 Amp Air Conditioner Compressor Controls ? 9 - 10 Amp Right Headlight ? 10 - 10 Amp Left Headlight © 2008 Mitchell Repair Information Co., LLC.
62217_isuzfuse_1.jpg
Underhood fuse block swap out relay #7 thats the ECM relay.
Ground Circuits Using a DVOM, touch negative voltmeter lead to a good ground. Touch positive voltmeter lead to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If reading is greater than one volt, check for open, corrosion and loose connection on ground lead. See ECM GROUND LOCATION table for ECM ground location.
Page 1 of 1 SYSTEM/COMPONENT TESTS - 2.6L EFI -1994 Isuzu Rodeo

Mar 28, 2010 | 1993 Isuzu Rodeo

2 Answers

My 1995 isuzu trooper sunroof and interior light, clock stopped working.i have checked the fuses and they are all good. any help or guidance would be appreciated


Check under your hood for a second fuse box.This box should contain fuses and relays.Some times the box lid will tell you whats what ie.horn relay,fuel pump relay,ect.Look to see for a relay for your sunroof.Your sun roof takes a lot of power to run and should be on a relay.Your light and clock be on the same relay.Good luck.

Mar 09, 2010 | 1995 Isuzu Trooper

1 Answer

Headlights don't work after new battery put in


it could have been that you blew the fuse for the low beam headlights ...just check the fuse box under the hood

Jan 30, 2010 | 1991 Dodge Dakota

2 Answers

Hi, i have a 206HDI 51 plate and for some reason my brake lights (O/S N/S and tailgate)have stopped working. i've changed fuses but still no joy, bulbs also seem to be ok. All the other light are working...


Check the brake switch, located on the break pedal. Connect the 2 wires together and if the break lights work, a new switch is required.(if only 1 wire connect to frame/chassis)

Jul 26, 2009 | 1991 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...