Question about 2001 Dodge Ram 2500 Truck

Open Question

Not getting power from truck battery

Where is the 12vlt power pickup connection located for the feed to the trlr. battery ??

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can i find the main fuse on 1996 nissan pickup?


Most main fuses are located close to the positive battery cable and in some cases attached directly to the positive cable located in a plastic box with a cover. There may also be a fusable link used for a main fuse which will connect to the starter

Jan 29, 2016 | 1996 Nissan Pickup

1 Answer

No power from alternator to battery


Is the battery ignition light coming on when you turn the key on. Wiring for an alternator is quite simple, the 60amp cable (thick wire) is a direct feed to the battery. The thin wire (normally blue) connected to the 'ing' terminal gets a live feed via the battery ignition light. if the bulb has blown or this wire is not connected, the alternator will not charge. If you can, use a 12v 5watt test light connected to the battery, start the engine and touch the 'ing' terminal. this should prove and energies the alternator to start charging.

Jan 21, 2014 | 1985 BMW 3 Series

1 Answer

Wont shut off by the key just changed the motor and had to unhooked battery to shut it down and all dash lights are staying on for a 95 chev pickup truck with a 4.3 motor


you have cross connected a battery feed with an ignition feed. Go back and check to ensure that all the engine harness connectors and any other connections made to the engine are correct.
If you have to, disconnect each connector in turn until you find one that shuts everything down, then recheck the wiring codes etc to enure you have plugged it into the correct connector. It is very easy to reconnect a harness connector into the wrong place so check wiring colour codes etc.

Mar 08, 2011 | 1986 Chevrolet Chevy

1 Answer

Where is the starter on a 1996 chev s- pickup


The starter motor is located on the passenger's side of the engine and access to the mounting bolts is from under the truck.For easily locating the starter.Just follow the positive terminal of your car battery.That connects to the car starter. -------------- thanks.Helpmech.


Jan 14, 2011 | 1996 Chevrolet S-10 Pickup

1 Answer

Vw passat 2004, 1.8T, Radio has no power, I have checked the fuse per the fuse box diagram (20 amp) seems to be ok, but have changed with a new 20 amp fuse, still no power. Is there a secondary fuse in...


first check the aux fuse, then check to see if the clock comes on the radio, if it don't check the radio it should have fuses, check them. check the connector to the radio for power, with the key in the off position you should have 1 12vlt power with the key on you should have 2 12vlt power... if the fuses are good on the radio and you don't have any power to the connector, it could be a relay or ignition switch

Dec 26, 2010 | 2003 Volkswagen Passat

1 Answer

Fuel filter replacement


S10 Pickup, Sonoma 2000-2004 Fuel Filter - Removal & Installation
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:
    Negative battery cable Fuel filler cap Quick connect fittings from the filter Filter feed nut and the clamp bolt Filter and the clamp from the vehicle

    c361288.jpg
    Fig. Fuel filter location along frame rail-2.2L engine


    ad98b7d.jpg
    Fig. Fuel filter location along frame rail-4.3L engine
To install:
  1. Install or connect the following:
    NOTE The filter has an arrow (fuel flow direction) on the side of the case, be sure to install it correctly in the system, the with arrow facing away from the fuel tank.
    Filter and clamp with the directional arrow facing away from the fuel tank, toward the throttle body
    Fuel feed nut Filter clamp assembly bolt Fuel quick disconnect fittings to the filter Fuel filler cap Negative battery cable
  2. Check for fuel leaks as follows:
    1. Turn the ignition ON for 2 seconds.
    2. Turn the ignition OFF for 10 seconds.
    3. Turn the ignition ON .
    4. Check for leaks.

Hope this help.

Apr 09, 2010 | 2002 Chevrolet S-10

1 Answer

93 VOLVO -850 NO SPARK AT COIL I HAVE POWER ON BOTH SIDES OF COIL NO SPARK AT SPARK PLUG WIRES CHANGED CAM SENSOR AND CRANK SENSOR DIDNT HELP


the coil may be faulty check for continiuity from secondary circuit (high volyage or spark end) and the primary circuit 12vlt.sideif you get a reading ,the coil is no good

Oct 03, 2009 | 1993 Volvo 850

1 Answer

Voltage regulator location


NOT sure of what back feed you are talking about. But for reference the voltage regulator is BUILT IN the alternator.

Jan 08, 2009 | 1995 Eagle Summit

3 Answers

2006 GMC Sierra 2500HD 4WD trailer light connection fuse blown?


It is in the fuse box under the hood on the drivers side

Jun 27, 2008 | 2006 GMC Sierra 2500HD 2WD

Not finding what you are looking for?
Cars & Trucks Logo

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...