Question about Toyota Land Cruiser

1 Answer

If my water pump fails on my land cruiser petrol 4.7L V8, can the cooling fluid get into the engine?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 29 Answers

No. The purpose of your water pump is to push the fluid into the engine. If it doesn't work, your engine will NOT be cooled with cooling fluid.

Posted on May 07, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 316 Answers

SOURCE: Overheating engine

Check your oil dipstick for coolant, or a mucky substance. Your symptoms sound like a blown head gasket.

Posted on Jun 22, 2009

  • 132 Answers

SOURCE: quantity of engine oil used in 1 HD engine toyota land cruiser

if you have just bought the car change the oil and the filters asap on the grounds that the oil and filters may have not been changed for quite a while also change air and fuel filters also and grease any steering and tail shaft joints check brake fluid and water levels also and for any leaks around brakes gearbox and differential then every 5000km change oil and every 10000 change filters and spark plugs start with 4liters of oil let settle check level and keep topping up until close to full mark fill oil slightly under than over too much oil will build up pressure and burst oil seals in motor the more expensive the oil the better the quality its a bit like scotch whiskey best of luck glenn.......

Posted on Nov 12, 2008

bigg t
  • 640 Answers

SOURCE: 1997 Toyota Land Cruiser rain water leak

check the sunroof drains,they may be clogged they are located on the right and left front of the sunroof.

Posted on Jun 07, 2008

  • 58 Answers

SOURCE: ford fiesta,1996,petrol,fails to start.

either your fuel pump relay or the safety shut off switch

Posted on Jul 05, 2009

  • 1 Answer

SOURCE: Toyota Land Cruiser fuel tank warning light on

Hi There. Have the exact same problem on my 95mod petrol with the sub fuel tank not emptying. think it may be the relay but cant find it. The earlier models have the relay in the rear wheel well, but ours are set up differently. had the whole car to pieces but still cant find it. Was wondering if you had any luck with yours and could enlighten me. Thanks kim_mck53@hotmail.com

Posted on Jan 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

VSC light flashing on land cruiser 200 series


have you had the OBD codes read ? if not could well be code(s) P0440 P0441 P0442 P0443 P0446 and a few others ,these refer to the Evaperation control system , one easy thing to try is make sure the gas tank cap is securely tightened turning so a couple of clicks are heard , this may cure the light coming on if not will need the codes reading and further investigation keep me updated if you wish

May 19, 2014 | 2007 Toyota Land Cruiser

1 Answer

HARD PEDAL WHEN BREAKING


vacume pump on alternator failed or pipe loose to brake servo cylinder,check where you top up brake fluid big round cylinder with plastic pipe to it, pull pipe out and start engine and see if its sucking if not check pipes to pump! either bad connection on pipe or pump failed

1_26_2013_4_53_52_am.jpg

Jan 13, 2013 | 1994 Toyota Land Cruiser

1 Answer

How to replace a radiator on a1994 toyota land cruiser


dak408_129.gif

  1. Disconnect battery ground cable.
  2. Drain engine coolant.
  3. Remove battery and tray,
  4. Remove radiator grille
  5. Disconnect No. 3 water bypass hose.
  6. Disconnect radiator inlet hose.
  7. Disconnect coolant reservoir hose.
  8. Loosen water pump pulley mounting bolts.
  9. Loosen lock, pivot and adjusting bolts of alternator and remove drive belts.
  10. Disconnect oil cooler hose from clamp on fan shroud, then remove shroud.
  11. Remove water pump pulley mounting nuts.
  12. Remove fan with fluid coupling, water pump pulley and fan shroud.
  13. Disconnect transmission oil cooler hoses.
  14. Disconnect radiator outlet hose.
  15. Remove radiator brackets, then the radiator.
  16. Reverse procedure to install.

Dec 11, 2010 | 1994 Toyota Land Cruiser

1 Answer

Where is the oil filter located on a V8 petrol toyota landcruiser?


2007 Landcruiser 200 Petrol V8 How do you remove the engine oil filter and where is the sump drain?

Dec 14, 2009 | 2003 Toyota Land Cruiser

1 Answer

Just replaced head gasket heads not warped still overheats replaced radiator,clutch fan,water pump thermostate and still the same does the system need to be bleed 4 air and do i need a name brand...


Some answers:

Any brand stat will do the job as long as it is listed for that car and is suitable for the climate you mostly drive in. (The auto store will sort that)

Yes, air in the system will cause issues still so bleeding is a must. Most garages use a simple technique of undo filler cap, get engine slightly warm, rev engine at 3000rpm while someone *with protective gloves* gentley squeezes hoses to get the air bubbles to come up to the header tank and out into the atmosphere.

Some questions:

Is this the 200TDi, 2.5 Petrol / 3.9 V8 petrol (I assume V8 as you say heads?

Is the heater in the car blowing hot air?

Have you felt the hoses *with engine warm* and top, bottom of radiator for cool spots? (This proves air is in the system)

Cheers

Lloyd

Dec 05, 2009 | 1998 Land Rover Discovery

1 Answer

Where is the fuel filter located in my land rover discovery?


On the diesel engine TD5 it is mounted in the engine compartment, you cannot miss it.
On the petrol engine V8 it is mounted on the fuel pump inside the fuel tank,
Hope this helps

Feb 01, 2009 | 2004 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...