Question about 2001 Chevrolet Venture
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
there could be several reasons for this type of problem. the engine is controled through main computer(ECM) and the sensors assocciated with it. most often times a hesitation is commonly a idle issue and that would be monitored by the TPS ( throttle position sensor) if this is beginning to fail it sends faulty reradings to the computer and the computer tries to compensate and sometimes either leans or richens the fuel air mixture cause and effect is a engine stall or a hesitation. another factor is your (O2) sensors these monitor your exaust and tell the ECM to adjust accordingly the fuel mixture also. a sure fire way to tell if one ore more sensors are faulty is to either have your check engine light come on or if there is a rough start. if the check engine light isn't on then i would think there is a timing issue involved and a tune up is in order. the tune up is simple by just changing plugs and wires, however the timing is computer controled and can only be adjusted by a certified tech with the proper equipment. try and change the plugs and wires first this is the least expensive way to solve your problem. if the problem persists then take it to a shop and have a tech hook up diagnostic tools to check the ecm for fault codes to narrow down whatsensors if any are faulty.
Posted on Apr 17, 2009
SOURCE: engine sputtering
Firstly, never run or drive a vehicle when the engine light is FLASHING. Very bad things may happen.
Are there any other symptoms? Does it do it al the time? Have you checked with your dealer?
Posted on Nov 18, 2008
under the intake plenum, which will have to be removed before you can access the thermostat.
I suggest having it done by a garage mechanic.
Posted on May 23, 2009
most any sensor going bad can cause the check engine light to come on,try disconnecting the posative battery cable for 15 seconds ,then put it back on,will reset the codes, or take it to auto zone,they will test your computer for codes at no charge to you.i had a venture van my was ox. sensor. thanks robert b.
Posted on Jun 17, 2009
Reset the ECU / PCM for Check Engine light removing the neg battery cable for 5 minutes to reset the codes. If the warnin glight come on again, I suggest scanning you vehicle for details, one fault is in there.
Good luck (remember rated this help).
Posted on Oct 30, 2009
Tips for a great answer:
Aug 11, 2014 | 2001 Chevrolet Silverado 2500HD
Jan 31, 2012 | Cars & Trucks
Apr 07, 2010 | 2001 Chevrolet Express
Mar 28, 2010 | 2001 Ford Windstar
Oct 26, 2009 | 2000 Chevrolet 3500
Aug 13, 2009 | 2001 Dodge Grand Caravan
Jun 16, 2009 | 1998 Chevrolet Venture Cargo
277 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: