Question about 2008 Toyota Highlander

Open Question

Change o2 sensor vsc engine light still on how do I get the light to go out

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 26 Answers

SOURCE: 2001 Sienna VSC/Trac/Engine Light

Toyota Specific Trouble Codes
P1135 Air/Fuel Sensor Heater Circuit Response. (Bank 1 Sensor 1)
If you have changed the proper sensor then you may need to have the cam shaft looked at.

Posted on Dec 16, 2008

Ad
Murphybanton
  • 2004 Answers

SOURCE: vsc vsc off check engine

Disconnect your battery for 10 minutes after which you connect it back the lights should go off. Don't report to toyota. Nigerian style!

Rate this............

Posted on Mar 21, 2009

  • 1861 Answers

SOURCE: 2004 Sequoia. VSC TRAC, TRAC OFF, and Check

It is not hard to change the sensor, it just screws into a threaded hole. The light will not go out immeditaly, after the sensor is replaced. It needs to go thru a drive cycle. Your best bet is to replace the sensor and get the code cleard by whoever scanned it for the 0031 code.

Posted on Jul 23, 2009

  • 21 Answers

SOURCE: 2004 Toyota 4Runner, Regarding The VSC TRAC and VSC OFF lights

Check your switches for the VSC, some get bumped on (due to their location) and some get stuck in the "on"position.

Posted on Aug 04, 2009

countrybo331
  • 79 Answers

SOURCE: engine light stays on after changing 02 sensor on

did u change the right o2 sensor there is 2 sensors on bank1 and 2 on bank2.....upstream and down stream.....i had the same prob i changed the o2 senser to the other side to check and make sure it was the o2 senser....it took 4 o2 sensors before i got 1 that finally worked nd yes i was buying them brand new.....so change sides with it nd see if the code changes sides....and did u reset it with the code machine when u put the new 1 in?

Posted on Mar 28, 2010

Testimonial: "i wont no if this is a successful answer until i can reset the code thank you"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Troubleshooting codes p0300, p0301, p0302, p0303,p0305. VSC light, VSC off light, check engine light and engine shaking.


you have multiple cylinder missfire 1,2,3,5 check your spark plugs, plug wires and coils could even be a o2 sensor

Dec 06, 2012 | 2000 Lexus Gs 300

1 Answer

2003 Lexus GS300 P0031 code


Yes the O2 sensor preheater problem will turn on the VSC light, see the complaint often, why? don't know
.P0031 TOYOTA - Oxygen Sensor Heater Control Circuit Low Bank 1 Sensor 1
In most cases the O2 being replaced cures the code but here is the full story.
Possible causes- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)

Jun 16, 2012 | 2003 Lexus Gs 300

1 Answer

Hello, VSC, Trac OFF and Check Engine lights turn on when i was driving. Whats means ? In Autozone said me that problem is with the catalyst system. Thanks for your advise.


when ever the check engine light is turned on for any reason the vsc and trac light also comes on to let you know they are not working, whenever the engine light is on the other systems can not operate if the engine is not working correctly, so its programed to shut down the trac and vsc when the engine light is on. the catalyst system means the catalic converter is no longer cleaning the exhasut to specs, this is caused by a weak bad converter or bad o2 sensors giving false readings you will need to have the sensors checked to see if they are the problem or the converter is the problem good luck.

Jan 23, 2011 | Toyota Sienna Cars & Trucks

2 Answers

The VSC and Check engine light turn on for lexus 1999 the cood is p0500


Toyotas and Lexus cars have some unique feaures. If your fuel cap is loose or the O2 sensors on the exhaust are faulty this results in an emission problem and the engine computer unit (ECU) engages the check engine light and disables the VSC (the VSC light comes on to warn you that it has been disabled). However you have p0500 code which says the car has no speed sensor signal. The seed sensor is located on the side of the final drive from the transmission and its job is to measure the speed of rotation of the output shaft. The ECU will compare the signals from this shaft along with the speed sensors in the wheel hubs. If there is a difference between these signals the VSC is engaged to apply braking effort to which ever wheel is slipping (running faster) than the other or that the transmission speed sensor would warrant.
So you either have an emission fault has fed back to the VSC and speed sensor missing (p0500) condition, or you have a faulty sped sensor which has tripped the VSC light and in turn the CEL.
Check your fuel filler cap is on tight, turn radio off and disconnect the negative lead to the battery for 5 minutes (this should clear the ECU memory of the code error). If p0500 error and CEL and VSC lights come back on then check the electrical connection to the speed sensor. Ensure it is clean and making a good contact, check the wiring for continuity. If everything else looks good consider changing the speed sensor.

Sep 14, 2010 | 1999 Lexus ES 300

1 Answer

Vsc & check engine light on. Code reads cylinder 2 misfire I have changed the plugs swaped coil with another cylinder swaped vsv's swaped injector plugs with another cylinder always shows misfire #2...


You may need to look at your exhaust system. If you have a leak, your O2 sensors will send the wrong reading to your engine which will in turn tell your engine to fire differently. Your code will come up reading as a misfired bank. See if you have an exhaust leak first, then see about changing out the O2 sensors behind the leak.

Jun 21, 2010 | Cars & Trucks

3 Answers

The check engine light, VSC light and Trac control


2000 toyota highlander just had oil changed and VSC lightis on.
what to do

Mar 24, 2010 | 2001 Toyota Highlander

1 Answer

2004 lexus rx330 what does vsc light indicate


VSC is Vehicle Stability Control. This is and electronic sensing which monitors and combines performance of braking, wheel slippage and handling, ect.
If this light comes on along with check engine light, it can be caused by a loose gas cap or faulty o2 sensor.

Nov 23, 2009 | 2004 Lexus RX 330

1 Answer

2004 Sequoia. VSC TRAC, TRAC OFF, and Check


It is not hard to change the sensor, it just screws into a threaded hole. The light will not go out immeditaly, after the sensor is replaced. It needs to go thru a drive cycle. Your best bet is to replace the sensor and get the code cleard by whoever scanned it for the 0031 code.

Jul 23, 2009 | 2004 Toyota Sequoia

1 Answer

VSC light and Check Engine Light On at same time 2003 RX300


need to take to a toyota or lexus dealer to find out what the code really is. the vsc light comes on every time the check engine light comes on. aftermarket scantools sometime will not give the proper description of the code that is present.vsc light is a vehicle skid control light. and do u mean o2 sensor.

May 26, 2009 | 2003 Lexus RX 300

1 Answer

Vsc vsc off check engine light on 2000 toyota avalon I have the same problem on my 2006 Avalon Limited. Error code indentifies the O2 Sensor located on Bank 1 Sensor 1 as defective.


Disconnect your battery for 10 minutes after which you connect it back the lights should go off. Don't report to toyota. Nigerian style!

Rate this............

Mar 21, 2009 | 2007 Toyota Avalon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...