Question about 1994 Mitsubishi Expo

Open Question

Where is the Mitsubishi1992 expo ac low preasure valve located?

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of ac low preasure switch, 2005 chev van express 3500

If you get a can of r134 with the end it should only fit the correct line to add freon.

Jun 07, 2017 | AC Cars & Trucks

1 Answer

My 07 ford e250 4.6 ac system my low side at idle 75 n my high side is 150 wats going on

It depends what temperature is outside and whats been done to ac syst! Preasures should be if 134a low at 32psi to 45 and hi side from 175 to 250psi the hotter weather higher preasures the colder the lower preasures! if around 70 deg out low side 32 n hi 174psi ! you may have a expansion valve clogged or orifice tube clogged! Get more inf 1_3_2014_2_37_21_pm.jpg

Sep 07, 2013 | Cars & Trucks

1 Answer

Ac clutch and pump shutting off and on

If the pressure shot up you were connected to the wrong port. The low side should not go over 70 or 80 psi with a single can.
Could be a relay, a low pressure switch, or the ac clutch on the compressor. And it could be low on freon.

Jul 12, 2012 | 2005 Dodge Neon

1 Answer

Where is low preasure valve for air conditioner

Low pressure service port is located on the Accumulator ( Silver Cylinder ) where the low side A/C line domes from the compressor. Location is on the passenger side fender by your evaporator housing and blower motor housing.
Thank you for using fixya and don't over charge your system.

Jun 03, 2010 | 1998 GMC Sierra

1 Answer

Locate low side valve for adding freon

the low preasure valve is located on the line coming off the ac compressor, if you look down from the front at the compressor and follow the top line out about 4 inches you will see it, good luck.

May 14, 2010 | 1997 Buick Skylark

1 Answer

What hose do i connect the 134 refrigrant to recharge the ac on a 2002 Montero Sport

you connect to the low preasure side, the connections are two diffrent sizes, the hose to recharge only fits the correct low preasure valve, it wont fit the wrong valve, hope this helps.

Apr 01, 2010 | 2002 Mitsubishi Montero Sport

1 Answer

Where is the thermal valve for the ac located on

Not shure what you mean by"thermal valve" There is a low preasure switch on the accumulator(big tank) that turns the ac clutch on and off,and shuts system down when to low on freon. there is also a high preasure switch that shuts down the system on the compresor.The only other "valve" would be the orifice tube or somtimes refered to as an expansion valve- this would be in the high preasure line, and can be found by looking for a spot in the line that has dimples. If this is the part you are trying to replace, you really need to take to a shop, as the freon must be recovered by law,and can be dangerous to handle if you don't know what you are doing.

Aug 27, 2009 | 1994 Ford Thunderbird

1 Answer

AC Compressor Cuts Out

Do you have gages you can hook up?check preasure when A/C clutch is on preasure low should be about 30 and high should be about 180,if high side is higher you got a blockage some where usealy they will plug at the recever dryer or the expansion valve

Jul 28, 2009 | Ford Ranger Cars & Trucks

1 Answer

Ac compressor not working try it irectly to battery and its fine. but when i put it back together its not working

Find ac preasure switch and install jumper,if compressor comes on it will be either low on refrigerant or faulty preasure switch.

Jun 17, 2009 | 1995 Pontiac Sunfire

Not finding what you are looking for?
1994 Mitsubishi Expo Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides