Question about 2006 Ford Expedition

1 Answer

2006 expedition vacuum - 2006 Ford Expedition

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

What are you asking I have a 2006 as well

Posted on Jul 27, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is vacuum canister located on a 2000 ford expedition suv


For exact location and diagram of vacuum canister on ford expedition,click the link below and view its diagram:----
Vacuum canister 2000 ford expedition

http://technoanswers.blogspot.com/2012/11/vacuum-canister-2000-ford-expedition.html

----------

These will help.

Thanks.

Nov 30, 2012 | Cars & Trucks

1 Answer

P0171, p0300, p0302


Which engine does your Expedition have? The P0171 could be a PCV system issue, possibly an EGR issue, intake manifold gasket issue, etc. The P0300 could be a vacuum leak such as those mentioned above as well, but the P0302 and P0171 would probably point more to Bank 1. Based on these three diagnostic codes it does seem likely that one issue will probably fix all three diagnostic codes. I think you're correct in looking for vacuum leaks, but depending on the engine in your Expedition, intake manifold gaskets and the EGR system are a couple of candidates that you maybe haven't considered yet.

-Rod

May 01, 2017 | 2006 Ford Expedition Limited

1 Answer

Diconected vacuum hose for a 2006 ford expedition


Look under the hood there is a vacuum line routing guide.

Oct 08, 2012 | Ford E-Series Cars & Trucks

1 Answer

Where is the fuel pump relay for the 2006 ford expedition


Have a 2006 expedition that died. Towed it back home and found that the #12 fuse was blown. Replaced the fuse and it started back up. After it started I gave it some gas and it died. It will not start again. I checked the fuse and it is not blown now. Any ideas????

Sep 11, 2010 | 2006 Ford Expedition

1 Answer

When I slow down and my engine will vibrate.


Rough Idle usually indicates a vacuum leak. You may have to feel along the lines that are routed in the back. My expedition has a small line that is routed from the PCV valve to the back of the intake where it goes from a small hard vacuum in to a reducer connection. This connection crumbled. The vacuum lines deteriorate over time. Some may not look bad, however they are like a sponge. sucking air the entire length.
I use a propane torch (not lit). Turn on the valve and trace the vacuum circuit. If you have a leak, the engine will rev up slightly when the torch passes the leak.

Aug 26, 2010 | 2006 Ford Expedition

1 Answer

I HAVE A 97 FORD EXPEDITION THAT STUCK IN 4 WHEEL DRIVE


Possible solution..Expedition uses a vacuum solenoid on the firewall that controls vacuum to the 4-wheel drive actuator. Vacuum "unlocks" the 4-wheel drive, so you may have a leak in the line to the actuator so the 4-wheel drive is always on. Seems backwards, I know.

Dec 07, 2009 | 1997 Ford Expedition

1 Answer

I have a 2006 Ford Expedition. The Air


you have a vacuum loss to the ac control head, the motors that divert air are vacuum operated, if you loose vacuum the system goes to defrost for safety reasons, the vacuum comes from the engine, then goes o a plastic vacuum tank under the hook start there, it is a 3/16 id hose.

Aug 14, 2009 | Ford Expedition Cars & Trucks

2 Answers

2006 Expedition Limited, misses while driving.


I have a 2006 expedition with 136,000 miles and have had the transmission checked and replaced the coil wires but it still misses at 40-50 MPH and at 70 mph does the same sound. If you accelerate and back off the go again it sounds like the transmission is clunking but the transmission guy said it wasn't the transmission. HELP!!!

Jun 29, 2009 | 2006 Ford Expedition

Not finding what you are looking for?
2006 Ford Expedition Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...