Question about 1999 Ford Expedition

3 Answers

Instructions on how to install window regulator on 99 Expedition

Is there a diagram or instructionsome where online I can get that shows me how to install the window regulator on my 99 Expedition. I don't have a service manual.

Posted by on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 76,164 Answers

Answer
Here is the procedure, the "dimples" are on the metal surface of the inside of the door. With the waterscreen off you can locate the motor to help you tell where the dimples are. Drill holes then use a socket to remove window motor bolts.

Front Door Window Regulator Motor
Removal and Installation

Raise the front door window glass to the full up position.
Remove the front door trim panel.
Remove the door speaker.
Position the watershield aside.
CAUTION: Make sure the electrical connector is positioned aside before drilling.

To access the power window motor bolts, use a 19 mm (3/4-in) hole saw with a 8 mm (1/4-in) pilot to drill three holes at the existing drill dimples on the door.

Disconnect the front door window regulator electrical connector.

Remove the bolts and the front door window regulator motor.

To install, reverse the removal procedure.
Cycle the window glass to make sure the gears engage

Posted on Jun 22, 2009

×

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 41 Answers

Don't forget to silicone the brackets, so the window stays in the new brackets.
Hunnybunny

Posted on Feb 06, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 520 Answers

You can go to www.alldata.com and subscribe to there site. Its very affordable and offers good info. Only problem i've seen so far is the site is a bit troublesome to navigate. Hope this helps. Good luck.

Posted on Jun 22, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace power window in driver door of 2001 chevy blazer?


are you replacing the power window regulator ?follow this u-tube link for excellent step by step instructions , if not the regulator let me know and i'll see if i can help further
How To Install Replace Power Window Regulator Chevy S10 Blazer GMC S15...

Sep 19, 2014 | 2001 Chevrolet Blazer

Tip

How To Install Replace Rear Power Window Regulator 1999-05 VW Volkswagen Jetta


1A Auto shows you how to repair, install, fix, change or replace a slow, stuck, cracked or damaged window regulator. This video is applicable to the 99, 00, 01, 02, 03, 04, 05, Volkswagen Jetta.

1999 Volkswagen Jetta Window Regulator

on Jun 26, 2014 | Volkswagen Jetta Cars & Trucks

1 Answer

I need a diagram on a skoda1.9 octavia 2003 car on how to fix the eletric window winder regulator wires


library has chilton and mitchell books------or go to magicmechanic online and send him the problem

Jul 27, 2012 | Cars & Trucks

1 Answer

How to install window regulators for 2001 Land Rover Discovery Series II


There are none

Any diagram would be in a factory
shop manual & not tell you what to do

Jun 17, 2012 | 2001 Land Rover Discovery Series II

1 Answer

Window cable broke so window does not go up and down


The window regulator cable on a Ford Expedition is part of the regulator assembly and is not serviceable separately. Therefore, if your Expedition's window regulator cable incurs damage, you'll need to replace the entire regulator. The cable moves the regulator up or down in response to the window motor. If the cable malfunctions, you won't have command of your Expedition's power window until you replace the regulator. If you have basic auto-repair skills and an hour of free time, you can replace your Expedition's window regulator. Pry the window switch bezel out of the Expedition's door panel using your trim tool. Disconnect the switch from the door harness by hand and set the switch/bezel assembly aside.

  • 2 Remove the hex head screws from the door panel using the Phillips screwdriver. Depending on the year of your Expedition, you may need to remove a trim cover from behind the inner door handle with the trim tool to expose that screw.
  • 3 Lift the door panel up and off the door by hand. If your Expedition has a courtesy light in the lower-trailing edge of the panel, disconnect that light from the door wiring harness before moving the panel away from the door.
  • 4 Push the Expedition's window to the top of the window frame by hand. Tape the glass to the top of the door with packing tape to prevent it from dropping back down.
  • 5 Remove the window regulator mounting bolts with the socket set. Unbolt the regulator from the window glass with the socket set. Pull the old regulator out of the Expedition's door by hand.
  • 6 Set the new window regulator into the Expedition's door by hand. Bolt it in place with the socket set.
  • 7 Reinstall the Expedition's door panel in reverse of how you removed it.
  • Oct 17, 2011 | 1997 Dodge Caravan

    2 Answers

    Power window will not roll up on 2004 expedition


    window has become loose from regulator and jammed or regulator has failed or switch has failed. if you hear the lift motor spinning when you hit the switch you can rule out the switch. if the window simply fell down and won't come up i would think it is disconnected from the regulator. if the window was going up and down problematically for a few days prior to failing i would suspect the regulator. you can buy a regulator new on ebay and have a glass shop install it much more cheaply than a dealer.

    Sep 18, 2010 | 2004 Ford Expedition

    1 Answer

    Diagram on how to take off left door panel on 1998 ford expedition


    REMOVAL AND INSTALLATION Trim Panel —Front Door, Expedition Removal
    1. NOTE: Release the top portion first.
      Remove the sail panel.
    cff7e48.gif
    1. Remove the window regulator switch plate (14524). 3745193.gif

    1. Disconnect the electrical connectors.
    d860af8.gif
    1. Remove the upper door trim panel screw. 4b4377b.gif

    1. Remove the door trim panel screw at the window regulator switch plate opening. 149d0a6.gif
    1. Remove the door trim panel screw in the courtesy lamp housing.
      1. Remove the courtesy lamp lens.
      1. Remove the screw. 8fe707b.gif

    1. Remove the inside door handle trim cover. 52f3d0f.gif
    1. Remove the inside door handle.
      • Remove the bolt. abe462f.gif
    1. swj~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: To avoid damage to the front door trim panel, do not pull directly outward.
      Lift upward and then outward to remove the front door trim panel (23943). d6459fb.gif
    1. Remove the courtesy lamp and socket. dfb380f.gif
    1. Disconnect the power mirror electrical connector.
    Installation
    1. Connect the power mirror electrical connector.
    1. Install the courtesy lamp and socket.
    1. Install the front door trim panel.
    1. Install the inside door handle.
      • Install the bolt.
    1. Install the inside door handle trim cover.
    1. Install the door trim panel screw in the courtesy lamp housing.
      1. Install the screw.
      1. Install the courtesy lamp lens.
    1. Install the door trim panel screw at the window regulator switch plate opening.
    1. Install the upper door trim panel screw.
    1. Connect the electrical connectors.
    1. NOTE: If a new trim panel is required: Some new trim panels have a cut out opening for the window switchplate that is larger than that on the original trim panel. When installing a new trim panel, install the window switchplate in the following sequence to make sure that the switchplate is secured fully into the door trim panel.
      Install the window regulator switchplate.
      • Insert the rear switchplate clip into the trim panel opening.
      • Install the forward and side clips into the trim panel opening.
    1. NOTE: Install the lower portion first.
      Install the sail panel.

    Mar 14, 2010 | 1998 Ford Expedition

    1 Answer

    Electronic window mechanism froze up and disconnected inside the panel...motor works fine. How do I remove the panel and find a diagram to repair the mechanism?


    Your repair manual for the vehicle should have a breakdown on how to remove/install the window regulator and motor.This is a comon problem on vehicles with electric windows.

    Mar 03, 2009 | 2000 Ford Expedition

    1 Answer

    Removing door panel and repairing regulator on 98 ford expedition


    the panel is held on with plastic fasteners, just pop all them off by putting a screw driver between the pannel and the door and pop em, these plastic fasteners break real easy so i would go buy a few replacements before you get ready to re-install

    Oct 19, 2008 | 1998 Ford Expedition

    Not finding what you are looking for?
    1999 Ford Expedition Logo

    1,325 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    76132 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    fordexpert

    Level 3 Expert

    5520 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...