Question about 2005 Chrysler Pacifica

Open Question

On the rear seat cable is loose or broke seat won't let down 2006 chrylser pacifica

Why won't my rear seat let down the lach is not catching it is either broke or loose.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 299 Answers

SOURCE: wereis the refill port for the ac for 134a freon

Follow large ac line.

Posted on Jun 18, 2009

97F350diesel
  • 1326 Answers

SOURCE: Chrysler Pacifica ABS on

Not long at all, there located in each wheel. Worst case is about an hour per sensor...

Posted on Nov 05, 2009

  • 1 Answer

SOURCE: rear seat wont fold down in pacifica 06

third brake light wont work it connected to a circuit board?

Posted on Nov 12, 2009

chargerhp
  • 813 Answers

SOURCE: Need diagram to change oil for a 2005 Chrylser

Drive car on ramps or 2 2x12s reach behind oil pan remove bolt drain hot oil from car that has just been driven.into pan. When oil is just dripping very slow say 15 min replace plug. Now just behind front bumper next to engine is an oil filter remove it with an oil filter wrench. Make sure the gasket came off with the filter or just reach up with a clean rag and wipe the housing it will fall off if you touch it. Put oil on gasket of new filter and screw it on when the gasket touches the housing go 3/4 s of a turn more. Put in about 5-1/2 to6 quarts of 10w 30 oil. Start engine for a min ck for leaks shut off and ck dip stick and make sure it reads full after sitting 5 min or so to let oil dip down into pan

Posted on Feb 25, 2010

  • 5252 Answers

SOURCE: 2006 pacifica stalled out while driving. Now it won't even try to start. Check engine light came on.

A good read. That car is only 6 years old... I would say bye bye to Chrysler forever.

Posted on Jun 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove back seat from 2006 Pontiac g6


You must first remove the seat bottom, usually you will have a latch in the floor that the bottom edge of the seat frame catches into. You will need to push the leading edge of the seat down and towards the rear of the car. Once you get the bottom out you will be able to remove the back, it is usually bolted to the seatbelt anchors at the base and pushes straight up off of some catches in the back.

Jun 12, 2015 | 2006 Pontiac G6

1 Answer

Why dont my power seats and heated seats work in a 2006 pacifica


Check the heater fuse, if the fuse is ok then the element need to be replaced

Sep 21, 2014 | 2006 Chrysler Pacifica Touring

1 Answer

Rear seat on my Note won't fold down. When I pull the handle up nothing happens. Any ideas?


Are we talking about Nissan Notes here? I have the same problem with my 2006 Note where the larger of the 2 split seats in the rear won't fold down. It doesn't have any side latches or boot straps and yanking it hard doesn't work either. I can't see any options other than complete removal of the whole rear seat assemby.

Aug 25, 2012 | Nissan Note Cars & Trucks

2 Answers

2000 VW Beetle drivers side seat adjusment cable broken?


Under the seat there is a spring that conects the 'handle'to the Latch, tha tholds the seat in place....you will have to look under the seat to see if the spring is broke

Nov 07, 2011 | Cars & Trucks

1 Answer

How do you let the back seat down


The third row seats have pull tabs inset into the top of the seat backs. The pull tabs are connected to wires that when pulled will release the catch that holds the seat in place.
The middle seats have the typical lever that on the outside bottom of the seat that you would use to adjust a seat manually in many cars.

Mar 08, 2011 | 2006 Chrysler Pacifica

1 Answer

Rear seat wont fold down in pacifica 06


third brake light wont work it connected to a circuit board?

Nov 12, 2009 | 2005 Chrysler Pacifica

2 Answers

Hi my double seat on my hyundai santa fe won't go down


there might be an interior panel not clipped in all the way at some spot, gently beat on the bottom edge and top edges of all the trim surrounding the mounting brackets, also the catch might not have been placed correctly during assembly. No idea why but I had 2 hyundai's and a Kia Magentis/optima (suprisingly nice for a kia...) with loose body trim or a trunk catch not quite right (yay seeing one side of the hood lift and shake when you're cruising the roads). Just take a good luck at what you can s3ee, gently tap on the plastic trim edges, and maybe see the dealer about reinstalling the catch (usually free)

Aug 20, 2009 | 2006 Hyundai Santa Fe

3 Answers

Diagram of the engine?


if you follow the hose from your air filter to where it meets the engine you will see your throttle cable also connected to this piece on the intake that is your throttle body.

May 22, 2009 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...