Question about 2006 Nissan 1400 Bakkie

Open Question

Nissan 1400 steering rack diagram ?

How das it work ?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

localwonder
  • 6784 Answers

SOURCE: rack and pinion steering

No. they are fairly similar in design...

Posted on Aug 27, 2009

  • 299 Answers

SOURCE: Where can I find a steering rack for a 1988 Nissan

You should be able to find those parts at the local auto parts store such as autozone or rs strauss. If you can't find the parts there go to your dealers parts department.

Posted on Oct 27, 2009

  • 3600 Answers

SOURCE: 2005 Nissan 1400 Standard. The hooter buttons on

First locate the horn in the engine compartment should be between the front grill and radiator core support. Pull the horn off, it has one wire and one bolt holding it on. next clean the bolt area where it is bolted on with sand paper to get a good ground. Sand it on the bottom of the mounting bracket and on the area where the horn bolts on. next get a wire and hook to the positive side of the battery, touch the horn to the negative side so it has a ground then touch the horn wire connector with the wire connected to the positive side of the wire does the horn work? if so it was needing cleaning, if not you will need to replace the horn. There are two things that you can do before you replace it look for a single screw on the horn and back it out three or four turns the try it again before installing, if this makes it work better then you know the problem that the reeds are going out replace the horn for $15.00 at any auto parts store. Or buy a air horn for $20.00 bucks and replace it with that, it's louder and easy to install. Nissan has always had issues with the horn so your not alone on this issue. Also check to see if a wasp built a next inside the horn or a mud dauber may have built a nest in the horn, if there is obstruction in the throat of the horn clean it out and try it again. Of all Nissan's I have worked on I have found it necessary to replace the horn about 90% of the time.

Posted on Jan 05, 2010

  • 731 Answers

SOURCE: power steering wireing diagram for nissan nv200

Power Steering is a hydraulic system and does not have a wiring diagram

Posted on May 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Could I please have a diagram of rack and pinion power steering for a 1999 Nissan sentra.


go to AutoZone an check out the parts diagram there for almost any part

Jul 26, 2017 | Nissan Cars & Trucks

1 Answer

How to repair steering freeplay on nissan bakkie 2002 1400


Depends on where the free play is coming from. Put car front end up on stands and have helper wiggle the steering wheel while you look for where the free play is.

Feb 26, 2016 | Nissan Cars & Trucks

1 Answer

1400 nissan 1 toner


check idler arms and linkage

Mar 18, 2014 | 2007 Nissan 1400 Bakkie

1 Answer

1996 Nissan maxima steering gear


Yes, but it is usually cheaper and better to buy a remanufactured steering rack. Remember to get the car realigned after replacing the rack. Also top off the lost power steering fluid.

Jan 29, 2014 | Nissan Maxima Cars & Trucks

1 Answer

Nissan ga13 carburetor diagram


hi i need a ga13 nissan sunny model b13 carpretor kit diagram how and ga13 manual timing,engine,distridutor (manual)and rack power steering manual and staring switch

Jun 16, 2013 | Cars & Trucks

1 Answer

I have a 2002 Nissan Altima 3.5, the steering has become harder to turn in the last few months. The fluid level is good, is my power steering pump gone? Or could it be steering rack? Is it easy to check if...


you may need the lower steering shaft. pretty common issue with those. they are starting to pop up more and more now that those cars are getting older (2002 - 2006) models. there is a u-jiont built into the lower steering shaft. those get tight and cause hard steering. have it checked. its the piece that connects to the steering rack and the upper steering column.

Apr 09, 2011 | Nissan Altima Cars & Trucks

1 Answer

Rack and pinion steering


No. they are fairly similar in design...

Aug 27, 2009 | Nissan Xterra Cars & Trucks

1 Answer

Power steering


Sounds like a bad steering rack & pinion assembly... is it only bad in one direction or both...?
If both then it's the rack assembly... Hope this helps...;-)

Apr 13, 2009 | 2005 Nissan Altima

1 Answer

99 Maxima Power steering sticking


I am a Nissan ceritifed Scope Technician with over 10 years experience in a Nissan dealership.

To me, it sounds like your problem is "morning sickness". The problem is there only after the vehicle sits for a period of a few hours (overnight) and then is gone once the vehicle warms up some.

What happens with "morning sickness" is this: there are nylon rings in the pinion section of the steering rack and pinion. Over time, these nylon rings wear grooves into the aluminum housing in which they reside. When the steering rack and pinion is cold, the pressurized power steering fluid can move past these rings causing difficulty in steering or an unsmooth steering condition. Once the fluid warms up some, the nylon rings expand and seal the gap and fluid can't get past anymore and it stays where it's supposed to be, leading to the normal steering you experience the rest of the day.

The only repair for this condition is to replace the power steering rack and pinion. A used one can be a gamble as this could reoccur in a short time. A brand new one is overly expensive. That leaves a good quality aftermarked remanufactured rack and pinion as your best option. And be sure to have the vehicle aligned when that work is completed.

Hope this helps!!!

Nov 02, 2008 | 1999 Nissan Maxima

Not finding what you are looking for?
2006 Nissan 1400 Bakkie Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...