Question about 2004 Mitsubishi Endeavor

1 Answer

Where is the ETACS on 2004 Mitsubishi endev - 2004 Mitsubishi Endeavor

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 121 Answers

Posted on May 07, 2014

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 691 Answers

SOURCE: plugged ac evaporator drain hose

I take it that condensate from the evaporator is leaking inside on the floor. Could be the drain tube is partially clogged. It is usually located on the fire-wall or down towards the floor pan under the car. It is usually close to where the A/C lines go thru the fire-wall. About 1/2 inch diameter sticking straight out but may have a 90 degree elbow pointing down.
Also, it's been extra hot and humid all over and moisture could be freezing inside the unit when on MAX A/C, then suddenly melting when switched to normal. This opens the outside air door and allows warm/hot air into the unit instead of recirculating the cold air inside the car. The drain may not be able to handle a large, sudden quantity of water.
Perform a "driveway" test. Open the hood, start engine and run the A/C on normal with the windows or doors open. Locate the drain tube by looking for water dripping. Once located twist 2 or 3 pipe cleaners together and verify the tube is clean. Then close the doors/windows and switch to MAX A/C. Check for water dripping. If it stops dripping, water is freezing inside and now you know why!

Posted on Aug 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 mitsubishi montero door chime not working


a HOnda Mitsubishi? huh?
MITSU: sport or non sport?
for some its a blessing, vast posts world wide to on how to kill em.
but is:
first in all electric fails check all dash and engine bay fuses.
ETACS ECU , is the controller, on this car.
Electric Time & Alarm Control System
1: does the chim work on all other chime active errors? , like the KEY reminder feature? if that works , id bet the ETACS is ok.

2: the door switch bad (drivers?) the door switch is like #1 fail on all cars. they get dirty , fail to close, (rust) and bingo bad switch.
the way to diagnose it it is to use the FSM book.
the door switch ground the Door ajar pin in ETACS,
so if the voltage on the wire is not at 0v door closed, the switch is
bad, or the ground wire to it is rusted and bad.

the operators guide is free, get it, and read it, and see all things
that make the chime sound. can be many things. ETACS has a large number of inputs..

Nov 18, 2013 | 2002 Honda Civic

1 Answer

Fuses for power locks,power mirrors,blower fan where are they located


Door Locks: 20A fuse 6, 7.5A fuse 8, and 7.5A fuse 12 in the ETACS-ECU

Mirrors: 10A fuse 16 in the ETACS-ECU

Blower: 30A fuse 1 (blower relay) and 7.5A fuse 8 (goes to A/C-ECU) in the ETACS-ECU

Ileave it to you to figure out what ETACS means

Sep 24, 2012 | 2008 Mitsubishi Lancer

1 Answer

Compre una Santafe 2004, usada. No tenia el ETACS. No funciona la velocidad intermitente del limpiavidrios. Compre el ETACS, fue instalado pero al parecer incorrectamente porque no funciona la velocidad...


I have the same problem few days ago and found my solution on Fixya Expert Sources website. Here you will get all the top sources of your problem. All the sources of this site provided by top Fixya Gurus. Have a good look at the sources of the page. Go through the sources to find your solution. Hope it will help.


View Count:1

Aug 12, 2011 | 2004 Hyundai Santa Fe

1 Answer

How do I wire a remote door lock to my 1995 mitsubishi eclipse , what are the wire colors for the power door locks?


Hope this helps. It's for a 2004 eclipse remote start.

12volts white/red (40A) + ignition harness
Starter black/red + ignition harness
Second Starter N/A
Ignition green + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory blue/red + ignition harness
Second Accessory blue/black + ignition harness
Keysense blue/red ignition harness
Notes: This wire rests at ground, and goes to an open circuit when the key is inserted into the ignition cylinder.
Power Lock purple - pin 33 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Unlock lt. green/red - pin 34 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Lock Motor lt. green 5wi pin 19, 28 pin plug below fuses
Unlock Motor green/red 5wi pin 22 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Parking Lights+ green/white + pin 2, 15 pin plug above fuses
Parking Lights- N/A
Hazards green - pin 55 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Turn Signal(L) green/blue + pin 8, 15 pin plug above fuses
Turn Signal(R) green/yellow + pin 13, 15 pin plug above fuses
Reverse Light red/blue + pin 9, 43 pin plug in driver kick
Door Trigger see notes - see notes
Notes: The driver door trigger is lt. green, pin 6, in a 15 pin plug above the fuses. The passenger door is lt. green/black in pin 65 at the ETACS ECU. Use both wires and diode isolate each.

The ETACS ECU is attached to the back of the fuse box.
Dome Supervision green/orange - pin 1, 3 pin plug above fuses
Trunk/Hatch Pin red - pin 62 or 37 at ETACS ECU
Notes: It is in pin 62 on the coupes, and in pin 37 on the convertible spyders.

The ETACS ECU is attached to the back of the fuse box.
Hood Pin green/red - pin 24 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Trunk/Hatch Release green/white 5wi pin 32 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Sliding Door N/A
Factory Alarm Arm lt. green/black - pin 42 at ETACS ECU
Notes: Meter this wire while turning the key in the driver door key cylinder.

The ETACS ECU is attached to the back of the fuse box.
Factory Alarm Disarm orange - pin 25 at ETACS ECU
Notes: Meter this wire while turning the key in the driver door key cylinder.

The ETACS ECU is attached to the back of the fuse box.
Disarm No Unlock blue/red - pin 27 at ETACS ECU
Notes: Meter this wire while turning the key in the hatch/trunk key cylinder.

The ETACS ECU is attached to the back of the fuse box.
Tachometer white or black/white ac engine speed detection connector
Notes: The engine speed detection connector is a single pin connector in the fuse/relay box under the hood.

Can also go to one of the ignition coils or the distributor assembly and use the black/blue or white/green wire.
Wait to start N/A
Brake Wire green/orange + brake pedal switch
Parking Brake yellow/green - parking brake switch
Horn Trigger lt. green/black - pin 44 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Standard on all models.

Good luck.

Mar 02, 2010 | 1995 Mitsubishi Eclipse

1 Answer

Where is the ETACS unit on my 2007 Santa Fe?


Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Sep 28, 2009 | 2004 Hyundai Santa Fe

1 Answer

Need to replace the ETACS unit


ETACS
(Electronic Time and Alarm Control System)

as far as the rear defroster, it may be the switch, relay, or fuse.

i have all of the service info on mediafire.com , just click this LINK and download whatever you need. i would suggest these 2 sections for fixing your problem:
97-99Electrical.pdf
2gTech_Info_Man.pdf

Dec 21, 2008 | 1997 Mitsubishi Eclipse

1 Answer

Unable to start car, keyless remote won't work anymore either


sounds like the battery to me. if not it would be the ETACS.

yep i just checked and there is a TSB out on it.

SC-04-002 JUN 04

Oct 12, 2008 | 2004 Mitsubishi Galant

Not finding what you are looking for?
2004 Mitsubishi Endeavor Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...